Counts are not failure probabilities and are not adjusted for sales, age, mileage exposure or reporting. One report may name several categories. Comparison method and limitations.
I OWN A 2007 NISSAN MAXIMA. COMING HOME FROM A TRIP THAT LASTED APPROXIMATELY 60 MILES, I TURNED ONTO MY STREET AFTER ABOUT ANOTHER MILE I WENT OVER A BUMP, AND IT SOUNDED LIKE I HAD SCRAPPED THE BOTTOM OF THE VEHICLE. I CONTINUED ON. WITHIN THE NEXT 500 FEET OR SO THE CAR BEGAN TO PULL EXTREMELY HARD TO THE RIGHT. KNOWING WHAT …
Read full complaint
I OWN A 2007 NISSAN MAXIMA. COMING HOME FROM A TRIP THAT LASTED APPROXIMATELY 60 MILES, I TURNED ONTO MY STREET AFTER ABOUT ANOTHER MILE I WENT OVER A BUMP, AND IT SOUNDED LIKE I HAD SCRAPPED THE BOTTOM OF THE VEHICLE. I CONTINUED ON. WITHIN THE NEXT 500 FEET OR SO THE CAR BEGAN TO PULL EXTREMELY HARD TO THE RIGHT. KNOWING WHAT A TIRE FAILURE FEELS LIKE, I IMMEDIATELY PULLED OVER AND GOT OUT. TO MY AMAZEMENT MY RIGHT REAR TIRE HAD LOST ALL AIR WITHIN SECONDS. IF I HAD BEEN TRAVELING ON THE HIGHWAY LIKE I PREVIOUSLY STATED I WOULD HAVE SPUN OUT. AFTER CHANGING THE TIRE I EXAMINED THE FLAT AND OBSERVED THAT THE TIRE HAD TWO PIECES OF TREAD "TORN" OUT OF THE TIRE IN TWO SEPARATE LOCATIONS. THE FIRST WOULD BE AT APPROXIMATELY 2 O'CLOCK AND THE SECOND AT 9 O'CLOCK. NOT DIRECTLY PARALLEL TO EACH OTHER. THE TIRE HAD NOT BEEN WORN ON THE INSIDE WHERE THE TREAD FAILED, SO I DEEMED IT NOT TO BE A CHASSIS PROBLEM WITH THE CAR. I HAVE PHOTOS OF THE TIRE AND STILL HAVE IT AT THIS MOMENT. *TR
NHTSA ODI #10512020
19,900 miles · Mar 5, 2009
Tires
TL*THE CONTACT OWNS A 2007 NISSAN MAXIMA. THE VEHICLE HAS CONTINENTAL CONTI PRO CONTACT TIRES, SIZE P215-60R16. WHILE DRIVING 35 MPH, THE VEHICLE BEGAN TO VIBRATE. THE CONTACT PULLED THE VEHICLE OVER AND NOTICED THAT THE REAR PASSENGER TIRE HAD COMPLETELY BLOWN OUT. THE TIRE APPEARED TO BE SHREDDED. THE VEHICLE WAS TOWED TO…
Read full complaint
TL*THE CONTACT OWNS A 2007 NISSAN MAXIMA. THE VEHICLE HAS CONTINENTAL CONTI PRO CONTACT TIRES, SIZE P215-60R16. WHILE DRIVING 35 MPH, THE VEHICLE BEGAN TO VIBRATE. THE CONTACT PULLED THE VEHICLE OVER AND NOTICED THAT THE REAR PASSENGER TIRE HAD COMPLETELY BLOWN OUT. THE TIRE APPEARED TO BE SHREDDED. THE VEHICLE WAS TOWED TO A REPAIR SHOP AND A NEW TIRE WAS INSTALLED. THE MANUFACTURER ADVISED HER TO SEND THEM THE FAULTY TIRE. THE CONTACT BELIEVES THAT THE TIRES SHOULD BE RECALLED. THE FAILURE MILEAGE WAS 19,900 AND CURRENT MILEAGE WAS 21,000.
NHTSA ODI #10260788
18,000 miles · Aug 12, 2008
Tires
TL*THE CONTACT OWNS A 2007 NISSAN MAXIMA. THE VEHICLE HAS GOODYEAR EAGLE RS-A TIRES, SIZE P245/45R18. WHILE DRIVING AT ANY SPEED, THE STEERING AND THE VEHICLE SHOOK UNCONTROLLABLY. THE DEALER BALANCED THE TIRES, BUT THE PROBLEM PERSISTED. GOODYEAR STATED THAT THE TIRES WERE CONSIDERED A RIDE DISTURBANCE. SHE WOULD HAVE TO P…
Read full complaint
TL*THE CONTACT OWNS A 2007 NISSAN MAXIMA. THE VEHICLE HAS GOODYEAR EAGLE RS-A TIRES, SIZE P245/45R18. WHILE DRIVING AT ANY SPEED, THE STEERING AND THE VEHICLE SHOOK UNCONTROLLABLY. THE DEALER BALANCED THE TIRES, BUT THE PROBLEM PERSISTED. GOODYEAR STATED THAT THE TIRES WERE CONSIDERED A RIDE DISTURBANCE. SHE WOULD HAVE TO PAY $116 PER TIRE FOR FOUR $300 TIRES. THE CONTACT WAS ALSO INFORMED THAT THE TIRES WOULD BE REPLACED UP TO 25% TREAD WEAR; HOWEVER, THE TREAD WEAR IS CURRENTLY AT 30%. THE CONTACT BELIEVES THAT IN JUNE, WHEN THE FAILURE FIRST BEGAN, HER TIRES COULD HAVE BEEN AT 25% TREAD WEAR. THE FAILURE MILEAGE WAS 18,000. UPDATED 10/14/08 *BF THE CONSUMER STATED THE TIRES HAD BAD TRACTION AND WERE BALANCED 5 TIMES. UPDATED 10/16/08. *JB
NHTSA ODI #10237869
Mileage unknown · Aug 6, 2008
Service Brakes, ElectricSteeringTires
FRONT END JIGGLES OR SHAKES DURING DRIVING AND STOPPING . *TR
CERTAIN PASSENGER VEHICLES EQUIPPED WITH AN 'INTELLIGENT KEY' FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 114, "THEFT PROTECTION." DURING AN INSPECTION OF SOME VEHICLES AT THE ASSEMBLY PLANT, IT WAS FOUND THAT THE STEERING WHEEL WAS LOCKED WITH THE IGNITION KNOB IN THE "OFF" POSITION BUT THE VEHICLE TRANSMISSION NOT BEING IN THE "PARK" POSITION.
Consequence & remedy
Consequence: IF THE KEY IS TURNED TO THE "OFF" POSITION WITHOUT THE TRANSMISSION BEING IN THE "PARK" POSITION, IT IS POSSIBLE THAT THE STEERING WHEEL CAN LOCK WHEN TURNED TO THE RIGHT.
Remedy: DEALERS WILL INSPECT AND REPLACE THE STEERING WHEEL LOCK ASSEMBLY FREE OF CHARGE. THE RECALL BEGAN ON DECEMBER 18, 2006. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
Defect investigations
1
PE08045 · Transmission Hose Leak
Opened Jul 23, 2008 · Closed Oct 24, 2008
Status: closed (inferred from source dates) · Power Train:automatic Transmission; Power Train:automatic Transmission:cooling Unit And Lines
THIS PE WAS OPENED FOR MODEL YEAR (MY) 2008 NISSAN MAXIMA VEHICLES BASED ON EARLY WARNING DATA THAT THE AUTOMATIC TRANSMISSION COOLER HOSE MAY HAVE PINHOLES AND/OR CRACKS RESULTING IN A TRANSMISSION FLUID LEAK.THE LEAKED FLUID CAN CONTACT THE EXHAUST SYSTEM AND IGNITE.NISSAN HAS SHOWN THAT THE ROOT CAUSE OF THE PINHOLES AND/OR CRACKS IN THE HOSE IS EXCESSIVE STRESS DURING THE MANUFACTURE FORMING PROCESS RESULTING IN HOSE DEFORMATION AT LOADING ONTO A MANDREL, OR DAMAGE DURING UN-LOADING.REGARDING LOADING STRESS, NISSAN STATES, WHEN EXCESSIVE STRESS IS APPLIED WHILE LOADING THE HOSE ONTO THE MANDREL, HOSE DEFORMATION (WHICH LOOKS LIKE A BULGE) CAN OCCUR AROUND THE BENDING AREA.A CRACK WILL START TO FORM ON THE INSIDE OF THE HOSE AT THE AREA OF DEFORMATION.REGARDING UNLOADING STRESS, NISSAN STATES, AFTER THE CURING PROCESS, IN SOME INSTANCES THE HOSE STUCK TO THE MANDREL TIGHTLY AND THE OPERATOR HAD TO APPLY A SIGNIFICANT AMOUNT OF FORCE TO PULL THE HOSE FROM THE MANDREL.IF THIS OPERATION WAS PERFORMED ROUGHLY, THE INTERIOR OF THE HOSE COULD BE DAMAGED BY THE MANDREL EDGE. NISSAN ALSO STATES, BECAUSE OF THE WAY THE HOSES RECEIVED INTERNAL DAMAGE, A DAMAGED HOSE WAS PRODUCED AS A RARE, RANDOM EVENT RATHER THAN SYSTEMATICALLY.THE TRANSMISSION HOSE SUPPLIER, COOPER STANDARD AUTOMOTIVE, IMPLEMENTED PROCESS IMPROVEMENTS THAT LIMIT EXCESSIVE STRESS ON THE HOSE DURING MANUFACTURE. NISSAN HAS SHOWN THAT THIS TRANSMISSION COOLER HOSE WAS ASSEMBLED ON MY 2007 AND MY 2008 MAXIMA VEHICLES.NISSAN REDESIGNED THE TRANSMISSION COOLER HOSE ON MY 2009 MAXIMA, AND THE HOSE IS MANUFACTURED BY A NEW SUPPLIER.NISSAN HAS ALSO SHOWN THAT THE LEAKS MOSTLY OCCUR WITHIN THE FIRST 2000 MILES OF SERVICE WITH A SEVERE DROP IN INCIDENTS BEYOND 2000 MILES OF SERVICE.MOST LEAKS HAVE ALREADY OCCURRED, AND THE ONE FIRE WAS MINOR. A SAFETY-RELATED DEFECT HAS NOT BEEN IDENTIFIED AT THIS TIME AND FURTHER USE OF AGENCY RESOURCES DOES NOT APPEAR TO BE WARRANTED.ACCORDINGLY THIS INVESTIGATION IS CLOSED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT NO SAFETY-RELATED DEFECT EXISTS.THE AGENCY RESERVES THE RIGHT TO TAKE FURTHER ACTION IF WARRANTED BY THE CIRCUMSTANCES.
Additional source detail variants (2)
Power Train:automatic Transmission:cooling Unit And Lines
THIS PE WAS OPENED FOR MODEL YEAR (MY) 2008 NISSAN MAXIMA VEHICLES BASED ON EARLY WARNING DATA THAT THE AUTOMATIC TRANSMISSION COOLER HOSE MAY HAVE PINHOLES AND/OR CRACKS RESULTING IN A TRANSMISSION FLUID LEAK.THE LEAKED FLUID CAN CONTACT THE EXHAUST SYSTEM AND IGNITE.NISSAN HAS SHOWN THAT THE ROOT CAUSE OF THE PINHOLES AND/OR CRACKS IN THE HOSE IS EXCESSIVE STRESS DURING THE MANUFACTURE FORMING PROCESS RESULTING IN HOSE DEFORMATION AT LOADING ONTO A MANDREL, OR DAMAGE DURING UN-LOADING.REGARDING LOADING STRESS, NISSAN STATES, WHEN EXCESSIVE STRESS IS APPLIED WHILE LOADING THE HOSE ONTO THE MANDREL, HOSE DEFORMATION (WHICH LOOKS LIKE A BULGE) CAN OCCUR AROUND THE BENDING AREA.A CRACK WILL START TO FORM ON THE INSIDE OF THE HOSE AT THE AREA OF DEFORMATION.REGARDING UNLOADING STRESS, NISSAN STATES, AFTER THE CURING PROCESS, IN SOME INSTANCES THE HOSE STUCK TO THE MANDREL TIGHTLY AND THE OPERATOR HAD TO APPLY A SIGNIFICANT AMOUNT OF FORCE TO PULL THE HOSE FROM THE MANDREL.IF THIS OPERATION WAS PERFORMED ROUGHLY, THE INTERIOR OF THE HOSE COULD BE DAMAGED BY THE MANDREL EDGE. NISSAN ALSO STATES, BECAUSE OF THE WAY THE HOSES RECEIVED INTERNAL DAMAGE, A DAMAGED HOSE WAS PRODUCED AS A RARE, RANDOM EVENT RATHER THAN SYSTEMATICALLY.THE TRANSMISSION HOSE SUPPLIER, COOPER STANDARD AUTOMOTIVE, IMPLEMENTED PROCESS IMPROVEMENTS THAT LIMIT EXCESSIVE STRESS ON THE HOSE DURING MANUFACTURE. NISSAN HAS SHOWN THAT THIS TRANSMISSION COOLER HOSE WAS ASSEMBLED ON MY 2007 AND MY 2008 MAXIMA VEHICLES.NISSAN REDESIGNED THE TRANSMISSION COOLER HOSE ON MY 2009 MAXIMA, AND THE HOSE IS MANUFACTURED BY A NEW SUPPLIER.NISSAN HAS ALSO SHOWN THAT THE LEAKS MOSTLY OCCUR WITHIN THE FIRST 2000 MILES OF SERVICE WITH A SEVERE DROP IN INCIDENTS BEYOND 2000 MILES OF SERVICE.MOST LEAKS HAVE ALREADY OCCURRED, AND THE ONE FIRE WAS MINOR. A SAFETY-RELATED DEFECT HAS NOT BEEN IDENTIFIED AT THIS TIME AND FURTHER USE OF AGENCY RESOURCES DOES NOT APPEAR TO BE WARRANTED.ACCORDINGLY THIS INVESTIGATION IS CLOSED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT NO SAFETY-RELATED DEFECT EXISTS.THE AGENCY RESERVES THE RIGHT TO TAKE FURTHER ACTION IF WARRANTED BY THE CIRCUMSTANCES.
Power Train:automatic Transmission
THIS PE WAS OPENED FOR MODEL YEAR (MY) 2008 NISSAN MAXIMA VEHICLES BASED ON EARLY WARNING DATA THAT THE AUTOMATIC TRANSMISSION COOLER HOSE MAY HAVE PINHOLES AND/OR CRACKS RESULTING IN A TRANSMISSION FLUID LEAK.THE LEAKED FLUID CAN CONTACT THE EXHAUST SYSTEM AND IGNITE.NISSAN HAS SHOWN THAT THE ROOT CAUSE OF THE PINHOLES AND/OR CRACKS IN THE HOSE IS EXCESSIVE STRESS DURING THE MANUFACTURE FORMING PROCESS RESULTING IN HOSE DEFORMATION AT LOADING ONTO A MANDREL, OR DAMAGE DURING UN-LOADING.REGARDING LOADING STRESS, NISSAN STATES, WHEN EXCESSIVE STRESS IS APPLIED WHILE LOADING THE HOSE ONTO THE MANDREL, HOSE DEFORMATION (WHICH LOOKS LIKE A BULGE) CAN OCCUR AROUND THE BENDING AREA.A CRACK WILL START TO FORM ON THE INSIDE OF THE HOSE AT THE AREA OF DEFORMATION.REGARDING UNLOADING STRESS, NISSAN STATES, AFTER THE CURING PROCESS, IN SOME INSTANCES THE HOSE STUCK TO THE MANDREL TIGHTLY AND THE OPERATOR HAD TO APPLY A SIGNIFICANT AMOUNT OF FORCE TO PULL THE HOSE FROM THE MANDREL.IF THIS OPERATION WAS PERFORMED ROUGHLY, THE INTERIOR OF THE HOSE COULD BE DAMAGED BY THE MANDREL EDGE. NISSAN ALSO STATES, BECAUSE OF THE WAY THE HOSES RECEIVED INTERNAL DAMAGE, A DAMAGED HOSE WAS PRODUCED AS A RARE, RANDOM EVENT RATHER THAN SYSTEMATICALLY.THE TRANSMISSION HOSE SUPPLIER, COOPER STANDARD AUTOMOTIVE, IMPLEMENTED PROCESS IMPROVEMENTS THAT LIMIT EXCESSIVE STRESS ON THE HOSE DURING MANUFACTURE. NISSAN HAS SHOWN THAT THIS TRANSMISSION COOLER HOSE WAS ASSEMBLED ON MY 2007 AND MY 2008 MAXIMA VEHICLES.NISSAN REDESIGNED THE TRANSMISSION COOLER HOSE ON MY 2009 MAXIMA, AND THE HOSE IS MANUFACTURED BY A NEW SUPPLIER.NISSAN HAS ALSO SHOWN THAT THE LEAKS MOSTLY OCCUR WITHIN THE FIRST 2000 MILES OF SERVICE WITH A SEVERE DROP IN INCIDENTS BEYOND 2000 MILES OF SERVICE.MOST LEAKS HAVE ALREADY OCCURRED, AND THE ONE FIRE WAS MINOR. A SAFETY-RELATED DEFECT HAS NOT BEEN IDENTIFIED AT THIS TIME AND FURTHER USE OF AGENCY RESOURCES DOES NOT APPEAR TO BE WARRANTED.ACCORDINGLY THIS INVESTIGATION IS CLOSED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT NO SAFETY-RELATED DEFECT EXISTS.THE AGENCY RESERVES THE RIGHT TO TAKE FURTHER ACTION IF WARRANTED BY THE CIRCUMSTANCES.
An investigation is not a finding of a defect, and closure does not prove a vehicle is problem-free.
Illustration