Counts are not failure probabilities and are not adjusted for sales, age, mileage exposure or reporting. One report may name several categories. Comparison method and limitations.
I HAVE HAD SEVERAL PROBLEMS WITH THIS CAR...THIS BEING THE LATEST. SINCE BUYING THIS VEHICLE BRAND NEW I HAVE HAD TO HAVE THE ENTIRE DASHBOARD REPLACED BECAUSE IT WARPED, THE RADIO REPLACED, THE CHROME RAILS ON TOP OF THE CAR REPLACED AND NOW I TOOK MY VEHICLE IN FOR SERVICE BECAUSE I WAS HEARING A "CHIRPING" NOISE. I THEN GO…
Read full complaint
I HAVE HAD SEVERAL PROBLEMS WITH THIS CAR...THIS BEING THE LATEST. SINCE BUYING THIS VEHICLE BRAND NEW I HAVE HAD TO HAVE THE ENTIRE DASHBOARD REPLACED BECAUSE IT WARPED, THE RADIO REPLACED, THE CHROME RAILS ON TOP OF THE CAR REPLACED AND NOW I TOOK MY VEHICLE IN FOR SERVICE BECAUSE I WAS HEARING A "CHIRPING" NOISE. I THEN GOT A CALL BACK AND WAS TOLD THAT THE COMPRESSOR HAD GONE BAD. BUT IT GETS BETTER AS RIGHT AFTER THAT I WAS TOLD THAT NISSAN GOT A BAD BATCH OF COMPRESSORS AND THEY CAN'T GET A NEW ONE FOR ME. BUT IT STILL GETS BETTER...I WAS THEN TOLD THAT IF I DON'T REPLACE THE COMPRESSOR (AT A COST OF OVER 1K) THEN IT WILL FAIL AND DAMAGE THE BELTS, WHICH WILL CAUSE THE POWER STEERING TO FAIL AS WELL AS DAMAGING THE CONDENSER. SO I NEED A PART THAT NISSAN SAYS IS DEFECTIVE SO THEY DON'T HAVE ANYMORE OF THEM AND ARE WAITING ON A NEW SUPPLIER, BUT IN ADDITION TO THAT IF I DON'T GET THIS PART IT WILL CAUSE ADDITIONAL DAMAGE TO THE CAR. *TR
CERTAIN PASSENGER VEHICLES EQUIPPED WITH AN 'INTELLIGENT KEY' FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 114, "THEFT PROTECTION." DURING AN INSPECTION OF SOME VEHICLES AT THE ASSEMBLY PLANT, IT WAS FOUND THAT THE STEERING WHEEL WAS LOCKED WITH THE IGNITION KNOB IN THE "OFF" POSITION BUT THE VEHICLE TRANSMISSION NOT BEING IN THE "PARK" POSITION.
Consequence & remedy
Consequence: IF THE KEY IS TURNED TO THE "OFF" POSITION WITHOUT THE TRANSMISSION BEING IN THE "PARK" POSITION, IT IS POSSIBLE THAT THE STEERING WHEEL CAN LOCK WHEN TURNED TO THE RIGHT.
Remedy: DEALERS WILL INSPECT AND REPLACE THE STEERING WHEEL LOCK ASSEMBLY FREE OF CHARGE. THE RECALL BEGAN ON DECEMBER 18, 2006. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
Defect investigations
1
PE08045 · Transmission Hose Leak
Opened Jul 23, 2008 · Closed Oct 24, 2008
Status: closed (inferred from source dates) · Power Train:automatic Transmission; Power Train:automatic Transmission:cooling Unit And Lines
THIS PE WAS OPENED FOR MODEL YEAR (MY) 2008 NISSAN MAXIMA VEHICLES BASED ON EARLY WARNING DATA THAT THE AUTOMATIC TRANSMISSION COOLER HOSE MAY HAVE PINHOLES AND/OR CRACKS RESULTING IN A TRANSMISSION FLUID LEAK.THE LEAKED FLUID CAN CONTACT THE EXHAUST SYSTEM AND IGNITE.NISSAN HAS SHOWN THAT THE ROOT CAUSE OF THE PINHOLES AND/OR CRACKS IN THE HOSE IS EXCESSIVE STRESS DURING THE MANUFACTURE FORMING PROCESS RESULTING IN HOSE DEFORMATION AT LOADING ONTO A MANDREL, OR DAMAGE DURING UN-LOADING.REGARDING LOADING STRESS, NISSAN STATES, WHEN EXCESSIVE STRESS IS APPLIED WHILE LOADING THE HOSE ONTO THE MANDREL, HOSE DEFORMATION (WHICH LOOKS LIKE A BULGE) CAN OCCUR AROUND THE BENDING AREA.A CRACK WILL START TO FORM ON THE INSIDE OF THE HOSE AT THE AREA OF DEFORMATION.REGARDING UNLOADING STRESS, NISSAN STATES, AFTER THE CURING PROCESS, IN SOME INSTANCES THE HOSE STUCK TO THE MANDREL TIGHTLY AND THE OPERATOR HAD TO APPLY A SIGNIFICANT AMOUNT OF FORCE TO PULL THE HOSE FROM THE MANDREL.IF THIS OPERATION WAS PERFORMED ROUGHLY, THE INTERIOR OF THE HOSE COULD BE DAMAGED BY THE MANDREL EDGE. NISSAN ALSO STATES, BECAUSE OF THE WAY THE HOSES RECEIVED INTERNAL DAMAGE, A DAMAGED HOSE WAS PRODUCED AS A RARE, RANDOM EVENT RATHER THAN SYSTEMATICALLY.THE TRANSMISSION HOSE SUPPLIER, COOPER STANDARD AUTOMOTIVE, IMPLEMENTED PROCESS IMPROVEMENTS THAT LIMIT EXCESSIVE STRESS ON THE HOSE DURING MANUFACTURE. NISSAN HAS SHOWN THAT THIS TRANSMISSION COOLER HOSE WAS ASSEMBLED ON MY 2007 AND MY 2008 MAXIMA VEHICLES.NISSAN REDESIGNED THE TRANSMISSION COOLER HOSE ON MY 2009 MAXIMA, AND THE HOSE IS MANUFACTURED BY A NEW SUPPLIER.NISSAN HAS ALSO SHOWN THAT THE LEAKS MOSTLY OCCUR WITHIN THE FIRST 2000 MILES OF SERVICE WITH A SEVERE DROP IN INCIDENTS BEYOND 2000 MILES OF SERVICE.MOST LEAKS HAVE ALREADY OCCURRED, AND THE ONE FIRE WAS MINOR. A SAFETY-RELATED DEFECT HAS NOT BEEN IDENTIFIED AT THIS TIME AND FURTHER USE OF AGENCY RESOURCES DOES NOT APPEAR TO BE WARRANTED.ACCORDINGLY THIS INVESTIGATION IS CLOSED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT NO SAFETY-RELATED DEFECT EXISTS.THE AGENCY RESERVES THE RIGHT TO TAKE FURTHER ACTION IF WARRANTED BY THE CIRCUMSTANCES.
Additional source detail variants (2)
Power Train:automatic Transmission:cooling Unit And Lines
THIS PE WAS OPENED FOR MODEL YEAR (MY) 2008 NISSAN MAXIMA VEHICLES BASED ON EARLY WARNING DATA THAT THE AUTOMATIC TRANSMISSION COOLER HOSE MAY HAVE PINHOLES AND/OR CRACKS RESULTING IN A TRANSMISSION FLUID LEAK.THE LEAKED FLUID CAN CONTACT THE EXHAUST SYSTEM AND IGNITE.NISSAN HAS SHOWN THAT THE ROOT CAUSE OF THE PINHOLES AND/OR CRACKS IN THE HOSE IS EXCESSIVE STRESS DURING THE MANUFACTURE FORMING PROCESS RESULTING IN HOSE DEFORMATION AT LOADING ONTO A MANDREL, OR DAMAGE DURING UN-LOADING.REGARDING LOADING STRESS, NISSAN STATES, WHEN EXCESSIVE STRESS IS APPLIED WHILE LOADING THE HOSE ONTO THE MANDREL, HOSE DEFORMATION (WHICH LOOKS LIKE A BULGE) CAN OCCUR AROUND THE BENDING AREA.A CRACK WILL START TO FORM ON THE INSIDE OF THE HOSE AT THE AREA OF DEFORMATION.REGARDING UNLOADING STRESS, NISSAN STATES, AFTER THE CURING PROCESS, IN SOME INSTANCES THE HOSE STUCK TO THE MANDREL TIGHTLY AND THE OPERATOR HAD TO APPLY A SIGNIFICANT AMOUNT OF FORCE TO PULL THE HOSE FROM THE MANDREL.IF THIS OPERATION WAS PERFORMED ROUGHLY, THE INTERIOR OF THE HOSE COULD BE DAMAGED BY THE MANDREL EDGE. NISSAN ALSO STATES, BECAUSE OF THE WAY THE HOSES RECEIVED INTERNAL DAMAGE, A DAMAGED HOSE WAS PRODUCED AS A RARE, RANDOM EVENT RATHER THAN SYSTEMATICALLY.THE TRANSMISSION HOSE SUPPLIER, COOPER STANDARD AUTOMOTIVE, IMPLEMENTED PROCESS IMPROVEMENTS THAT LIMIT EXCESSIVE STRESS ON THE HOSE DURING MANUFACTURE. NISSAN HAS SHOWN THAT THIS TRANSMISSION COOLER HOSE WAS ASSEMBLED ON MY 2007 AND MY 2008 MAXIMA VEHICLES.NISSAN REDESIGNED THE TRANSMISSION COOLER HOSE ON MY 2009 MAXIMA, AND THE HOSE IS MANUFACTURED BY A NEW SUPPLIER.NISSAN HAS ALSO SHOWN THAT THE LEAKS MOSTLY OCCUR WITHIN THE FIRST 2000 MILES OF SERVICE WITH A SEVERE DROP IN INCIDENTS BEYOND 2000 MILES OF SERVICE.MOST LEAKS HAVE ALREADY OCCURRED, AND THE ONE FIRE WAS MINOR. A SAFETY-RELATED DEFECT HAS NOT BEEN IDENTIFIED AT THIS TIME AND FURTHER USE OF AGENCY RESOURCES DOES NOT APPEAR TO BE WARRANTED.ACCORDINGLY THIS INVESTIGATION IS CLOSED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT NO SAFETY-RELATED DEFECT EXISTS.THE AGENCY RESERVES THE RIGHT TO TAKE FURTHER ACTION IF WARRANTED BY THE CIRCUMSTANCES.
Power Train:automatic Transmission
THIS PE WAS OPENED FOR MODEL YEAR (MY) 2008 NISSAN MAXIMA VEHICLES BASED ON EARLY WARNING DATA THAT THE AUTOMATIC TRANSMISSION COOLER HOSE MAY HAVE PINHOLES AND/OR CRACKS RESULTING IN A TRANSMISSION FLUID LEAK.THE LEAKED FLUID CAN CONTACT THE EXHAUST SYSTEM AND IGNITE.NISSAN HAS SHOWN THAT THE ROOT CAUSE OF THE PINHOLES AND/OR CRACKS IN THE HOSE IS EXCESSIVE STRESS DURING THE MANUFACTURE FORMING PROCESS RESULTING IN HOSE DEFORMATION AT LOADING ONTO A MANDREL, OR DAMAGE DURING UN-LOADING.REGARDING LOADING STRESS, NISSAN STATES, WHEN EXCESSIVE STRESS IS APPLIED WHILE LOADING THE HOSE ONTO THE MANDREL, HOSE DEFORMATION (WHICH LOOKS LIKE A BULGE) CAN OCCUR AROUND THE BENDING AREA.A CRACK WILL START TO FORM ON THE INSIDE OF THE HOSE AT THE AREA OF DEFORMATION.REGARDING UNLOADING STRESS, NISSAN STATES, AFTER THE CURING PROCESS, IN SOME INSTANCES THE HOSE STUCK TO THE MANDREL TIGHTLY AND THE OPERATOR HAD TO APPLY A SIGNIFICANT AMOUNT OF FORCE TO PULL THE HOSE FROM THE MANDREL.IF THIS OPERATION WAS PERFORMED ROUGHLY, THE INTERIOR OF THE HOSE COULD BE DAMAGED BY THE MANDREL EDGE. NISSAN ALSO STATES, BECAUSE OF THE WAY THE HOSES RECEIVED INTERNAL DAMAGE, A DAMAGED HOSE WAS PRODUCED AS A RARE, RANDOM EVENT RATHER THAN SYSTEMATICALLY.THE TRANSMISSION HOSE SUPPLIER, COOPER STANDARD AUTOMOTIVE, IMPLEMENTED PROCESS IMPROVEMENTS THAT LIMIT EXCESSIVE STRESS ON THE HOSE DURING MANUFACTURE. NISSAN HAS SHOWN THAT THIS TRANSMISSION COOLER HOSE WAS ASSEMBLED ON MY 2007 AND MY 2008 MAXIMA VEHICLES.NISSAN REDESIGNED THE TRANSMISSION COOLER HOSE ON MY 2009 MAXIMA, AND THE HOSE IS MANUFACTURED BY A NEW SUPPLIER.NISSAN HAS ALSO SHOWN THAT THE LEAKS MOSTLY OCCUR WITHIN THE FIRST 2000 MILES OF SERVICE WITH A SEVERE DROP IN INCIDENTS BEYOND 2000 MILES OF SERVICE.MOST LEAKS HAVE ALREADY OCCURRED, AND THE ONE FIRE WAS MINOR. A SAFETY-RELATED DEFECT HAS NOT BEEN IDENTIFIED AT THIS TIME AND FURTHER USE OF AGENCY RESOURCES DOES NOT APPEAR TO BE WARRANTED.ACCORDINGLY THIS INVESTIGATION IS CLOSED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT NO SAFETY-RELATED DEFECT EXISTS.THE AGENCY RESERVES THE RIGHT TO TAKE FURTHER ACTION IF WARRANTED BY THE CIRCUMSTANCES.
An investigation is not a finding of a defect, and closure does not prove a vehicle is problem-free.
Illustration