2019 Jeep Cherokee

I own a 2019 Jeep Cherokee. While driving approximately 50-60 MPH, the steering wheel was pulling to the right and the left. The movement occurs often while driving over 50 mph requiring tight control of steering wheel. Vehicle evaluated by mechanic and unable to reproduce the movement and no recalls on this at this time, looks to be a common issue with this vehicle. No warning light illuminated, mileage at time of initial problem was 36,000.

This is a known issue with Jeep. But they refuse to repair it at no cost. My emergency brake has become corroded due to water leaking into the module and from time to time the emergency brakes will get stuck to the point my car will not move. This recently happened last night when my vehicle was parked in the garage. I had recently been driving through a major rain storm. And upon trying to use my vehicle the next day... The emergency brakes would not release. My mechanic brought his computer over and verified the check engine light was related to the emergency brakes not releasing. This is a definite safety hazard! I have also noticed that certain safety features are being disabled due to the emergency brake not working properly. For example if I leave my Jeep in drive and open the door the emergency brakes should automatically engage disabling roll away. This feature no longer works. Another future, if my driver seat seat belt was not buckled my emergency brake would engage. This is no longer working. I am very concerned about this. There are countless other reports of emergency brake errors. Please issue a recall!

The contact owns a 2019 Jeep Cherokee. The contact stated that while making left and right turns, the battery warning light illuminated, and the vehicle stalled. The vehicle was able to be restarted. The vehicle was taken to an independent mechanic but was not diagnosed or repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 33,000.

On the date of 4/1/ 20 24 While driving the vehicle in normal conditions it lost power and the steering would not work correctly making a loud noise coming from the front end in addition to that an indicator light came on the dash SVC 4WD. I pulled to the side of the road and shut off the engine To look under the Vehicle I did not see any damage I got back in the vehicle and started it and drove fine for a few more Miles The same indicator light SVC4 wheel drive kept coming On and off So I pulled in to the nearest Auto-repair garage they could not look at it that day they said they would check it first and then in the morning. 8 AM the next morning on 4/2/2024 they put it up on the left and diagnosed That the PTU had failed I needed to be replaced This is the code number he gave me for the fault....1.C14A7-97:97PTU MOTOR COMPONENT OR SYSTEM OPERATION OBSTRUCTED OR BLOCKED

Was involved in a t-boned accident where the front end of my jeep stuck a vehicle in the side. The collision sensor did not activate nor did the air bags deploy. The other vehicle involved had airbags that deployed. The jeep is at my residence for inspection. With airbags not performing properly (faulty) this did not keep the upper body from jilting forward which causes head and shoulder issues. Insurance has not investigated neither did police. There was no warning lights or messages indicating that there was a problem prior to the accident.

I took my vehicle to a local dealership to have the "auto stop start" system checked. I had a dashboard warning light indicating the system was not working correctly. No other warnings signals were displayed. The dealership performed a diagnostic check but found no problems with the "auto start stop system". The day after I picked up my car, I drove for ten miles and the car overheated. I contacted the dealership and was told to check radiator fluid and drive the car back if possible. I found no radiator fluid in the car. My car required a full engine replacement and several subsequent repairs to exhaust system and driveshaft. An engine can overheat and seize which can cause drivers to lose control and crash. Please note: The original engine was part of recall for oil consumption. Prior to the recall update, I experienced stalling in traffic without warning due to the engine recall.

The contact owns a 2019 Jeep Cherokee. The contact stated that while driving at an undisclosed speed, the “Service 4WD” warning light illuminated. The contact stated that the accelerator pedal was depressed; however, the vehicle failed to respond as intended. In addition, the fuel economy mileage decreased. The vehicle was taken to the dealer where it was diagnosed with a failed power train unit. The contact was informed that the power train unit needed to be replaced. The vehicle was not diagnosed or repaired by an independent mechanic or dealer. The manufacturer was made aware of the failure. The failure mileage was approximately 68,790.

Incident date/time: [XXX] MDT*Year, make, model: 2019 Jeep Cherokee Latitude Upland 4X4 3.2L V6 F/I Gas 4D SUV*Odometer when incident occurred: 80,358*Injuries: No*Failed or malfunctioned component or system: Engine*Warning lamps, messages or other symptoms of the problem prior to incident: No*Recent maintenance history, date and location: Routine maintenance, inspections, oil, lube*Last oil change, location and mileage: DEC 2023, Hot Springs, SD, odometer 78,653*To and from travel details: Traveling home to Hot Springs, SD from Henderson, NV after grandmother passing*Incident location: [XXX] Wamsutter, WY*Incident details, include velocity, vehicle load/trailering/towing, road conditions:*[XXX], fair weather, snow, plows in service that day on interstate, velocity 70MPH, left lane behind tractor trailer passing a slower tractor trailer in the right lane when incident occurred, observed and heard roadway obstruction/debris struck one mile prior to failure, unknown obstruction/debris type, no malfunction indicator lights, no information on dash heads-up display, no indication of an issue present or imminent; normal load, not pulling/trailering, slight (<1% grade) incline, road straight; Jeep performing normally prior to incident; without warning, a "pop" was heard in the cabin, smoke billowed from under the hood and rear of vehicle and immediate powertrain failure; malfunction indicator light indicates engine issue, heads-up display flashes performance, oil pressure, stability and traction control failure warnings, engine power ceased, operator safely maneuvers from left lane to shoulder; visual inspection reveals engine oil loss, engine block rod part observable at the bottom of engine compartment; incident documented, photographed, reported to insurance and warranty*Problem confirmed by dealer shop, inspected by insurance and warranty companies - blown motor, undetermined*Past PCV issues possible cause. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

While driving along, my jeep will suddenly lose all power, making it necessary to stop, place it in park, press my foot on the brake and re-start. There is absolutely no warning, no chugging or hesitation, it just dies. This is random and has occurred 4 times now. There has not seemed to be a pattern. The first time, I left my dooryard and within a couple hundred feet, it happend. The second time, I had been driving about a mile and it happened, the third time I had driven about 3 miles and it happend and this last time (this morning)my vehicle had been running idle for about 15 min, I drove about 5 miles and it just suddenly died. All of these events occurred without any kind of warning.