2013 Hyundai Veloster

The contact owns a 2013 Hyundai Veloster. The contact stated that after starting the vehicle, the braking system malfunctioned, and the brake pedal extended to the floorboard while being depressed. The contact stated that upon inspection, it was discovered that brake fluid was leaking from the vehicle. The vehicle was taken to the local dealer who informed the contact that the VIN was included in NHTSA Campaign Number: 23V651000 (SERVICE BRAKES, HYDRAULIC); which was linked to the failure. The vehicle was not yet repaired. The manufacturer was not yet contacted. The failure mileage was 73,000.

I was driving my vehicle and it began severely misfiring and stalled on me. I took it to the dealer and found there was damage to cylinder number 2 engine balance. After research I found there are many claims and complaints due to this type of issue. The likely cause is preignition caused by what Hyundai calls bad software. I recently purchase the vehicle and they say it was updated in July of 2024 and will not repair my vehicle as they say because of its age and mileage. That being said I’m at 120k mileage and work in the auto industry…. They is nothing that could cause valve burn outside of the known ignition issue with these cars. I have no problem paying for repairs due to my cause issues or normal wear and tear but a melted valve is caused by the know issues on these cars. I am looking for help working with Hyundai to get this issue fixed.

Car started smoking on cabin while driving. Risk of hazard dueto bad A/C control switch. Wiring harness and plug melted too. Several Hyundai Veloster are suffering same issue. Started to think blower wiring is to small for load too. Pleaae see attached pictures. Time and miles provided is an approximate. Do not remember when exactly happened but was reported previously. In the pictures you are going to be able to see the faulty part P/N for your review.

The contact owns a 2013 Hyundai Veloster. The contact stated while driving 45 MPH, the vehicle lost motive power and the check engine warning light illuminated. The contact depressed the brake pedal and the vehicle started to shake. The contact stated that after shifting into gear the vehicle became difficult to drive. The vehicle was taken to an independent mechanic, where the vehicle was diagnosed with a passenger’s air bag fault. The dealer was made aware of the failure. The manufacturer was made aware of the failure and a case was opened. The failure mileage was approximately 172,000.

On October 17, 2024, owner was leaving Denver, CO on the highway and had to stop for traffic and vehicle wouldn't move. Was in drive but vehicle would not drive and pulled to side of road. Had insurance tow to nearest Hyundai dealership. Check engine light was on and dealership checked vehicle and needed to have the crankshaft position sensor replaced. Fixed the problem thank God and I was on my road shortly there after. My Veloster is 2013 with 47,000 miles at time of incident.

The contact owns a 2013 Hyundai Veloster. The contact stated that while his wife was driving at an undisclosed speed, she heard an abnormal clicking sound emanating from the front of the vehicle, after which she became aware that there was excessive left and right play in the steering wheel. No warning lights were illuminated. The vehicle was not taken to the dealer or an independent mechanic. The vehicle was not repaired. The manufacturer was notified of the failure but did not assist. The failure mileage was 67,000.

The contact's god-daughter owns a 2013 Hyundai Veloster. The contact stated that the ABS warning light and other unknown warning lights were illuminated. The vehicle was taken to the dealer, where the recall repair of NHTSA Campaign Number: 23V651000(Service Brakes, Hydraulic) was performed; however, the failure persisted. The contact stated that while inspecting the vehicle at the residence, the contact noticed that the ABS fuse was blown. The contact replaced the ABS fuse; however, the ABS motor made an abnormal whining and humming sound. The ABS motor then blew up and caught on fire. The contact stated that he was able to extinguish the 12 inch high flames with a bottle of water. The vehicle was towed to the dealer, where it was determined that the ABS unit and the wiring harness needed to be replaced. The vehicle was not repaired. The contact stated that the recall remedy failed to fix the failure. The manufacturer was notified of the failure and a case was opened; however, the manufacturer later sent a letter to the contact advising that the claim was denied. The failure mileage was approximately 87,700.

A connecting rod bearing failed in the engine leading to catastrophic engine failure with the connecting rod breaking through the wall of the engine block causing a hole and undriveable vehicle. According to my research, this issue has been recalled in adjacent model years (2015-2016) but not in my model year (2013) that has the same engine. This issue has already been confirmed in these engines, but Hyundai states my car is not included in the recall. This was a safety risk because the engine failure breached the engine wall which could have ignited engine oil and caused a fire. The engine may have also failed at a critical driving moment when acceleration was needed and stranded the car in an unsafe position. Yes, the problem was reproduced at the dealer's service center because the failure occurred while they were test driving my vehicle. Since the service center tech was the one driving the car when the incident occured, I do not know if there was a fire or not and the speed they were traveling, etc. The vehicle has been inspected by the dealer service center and confirmed that this is the issue that caused the problem. The dealer even suspected this was going to happen as they had foreknowledge of the issue occurring on other vehicles that had already been recalled for this issue. The only prior warning of this issue is that I had some misfires on the engine a few days before which is what prompted me to bring it in for service. The misfires temporarily illuminated the "check engine" light but then the light went back out again. I had no idea this minor issue would result in such a severe, catastrophic failure.