2013 Hyundai Veloster

On going issue since 2016 with the failure of the rubber coupling in the motor driven power steering (MDPS) assembly. Loose steering, knocking noise, worsening overtime. Known issue with the Hyundai Elantra and recall issued for the same part and issue on the Elantra. But not for the Veloster, service department acknowledged identical part usage in Veloster and MDPS assembly is failing in the Veloster with same safety issues. But since no recall have been issued full cost of replacement passed to consumer. $5 dollar rubber coupler, +$500 labor.

One night I was driving on the highway and my check engine light came on. At first I thought it was weird because I had just gotten the car from a dealership three weeks prior. I pulled into a gas station and checked my oil which was low so I added some oil that I had bought. As I was driving home the car suddenly developed a tick and started to lose power. The turbo stopped working. I was pretty concerned about this so the next morning I decided to top off the oil and I decided to take the car into a shop. The first shop heard the engine knock and told me that my crankshaft might be going bad but I wanted a second opinion so I took it to a trusted shop who heard the engine knock and told me the engine would need to be replaced. I called the warranty company and they inspected it at the shop and said the engine would need to be torn down for diagnosis. I had to agree to pay for the shop to tear down the engine if it would not be covered. The shop found metal shavings in the oil pan. Once the engine was apart, they said that the rod bearing was bad. The car and engine are available for inspection.

The contact owns a 2013 Hyundai Veloster. The contact received notification of NHTSA Campaign Number: 23V651000 (Service Brakes, Hydraulic) however, the part to do the recall repair was not yet available. The contact then received a second recall notice that stated that parts for the recall repair were available. The local dealer was contacted about the recall and an appointment was scheduled. The vehicle was taken to the dealer for an oil change and the recall repair; however, the contact was later informed that the dealer was out parts for the recall repair and was not able to service the recall. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.

The contact owns a 2013 Hyundai Veloster. The contact received notification of NHTSA Campaign Number: 23V651000 (Service Brakes, Hydraulic) however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact scheduled and confirmed an appointment and upon arriving, was informed that the parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.

The HVAC control knob overheated and burned out in my car. It scorched/charred and melted the plastic switch it was plugged into in the dash. It caused a strong burnt plastic, Smokey smell inside the car while I was driving. I thought the car was on fire at first. Thank goodness it wasn’t but it really could have started a fire in the dash of the car under the right conditions. I’ve read numerous accounts online of this same exact issue on this year/model, but no action has been taken by Hyundai to rectify this dangerous design flaw. I’ve also read that it can and usually happens again to the replacement control knob and plug. It’s absolute insanity to replace it with the exact same part knowing full well that it’s most likely going to do the same exact thing again. What if it does cause a fire in the dash the next time while I’m driving? It could possibly severely injure or kill me and any passenger in the car in addition to putting other drivers at risk from a mobile flaming inferno.

Vehicle is burning through oil without having oil light engaged. Vehicle is going through two quart + of oil every 3 weeks. Just added 2 quarts of oil 3 weeks ago when the car would not accelerate past 5mph and rough idled (this turned out to be caused by a different issue still being diagnosed), I added the oil as dip stick showed no oil on the stick. Light did not come on. Took to independent mechanic this week who stated I had no oil in the vehicle. Can not go 3 month/3000 miles for an oil change or the engine would be damaged. Have taken the vehicle several times to Valvoline who indicate no oil with no oil pressure light on, each time. This has been constant for 2 years. Each mechanic shop states the GDI engines are burning through oil. No oil leaks have been detected. This issue could result in serious engine damage.

First the turbo stopped working n smoking. Took it to the dealer n they had it for a month.. Get it back one day later had to have it towed . Vehicle was there for another 2 weeks got it back and it started to smoke. I pressed on the gas pedal n the car wouldn’t move! The first time the turbo was supposed to be replaced I believe ever since it was sent there to be replaced it was never the same. I still have the car and it will not start. The turbo n engine are filled with oils .

The Plug that connects to the AC control Unit is burned and damaged. In fact, When I replaced it its smells like smoke. It is the third time since 2018 that I changed the unit. I decided to officially make a complaint because I saw that this vehicles and exact models from 2014-2016 where included but My year not ( 2013). I called the Hyundai and they told me that I needed to buy the unit and go fix it in a dealer. I found it unfair because is a defect of the car not something People can make to the car. The campaing nunber is: 16-01-070 from december 2016 ( and my car where not included) The problem is not the unit is the plug that cames from the car that connects to the unit that melts and gets burned.( but the unit is damaged due to this)