2019 Toyota Highlander

Originally, 2019 Toyota Highlander lost engine power, steering, and braking on U.S. Route 30, a very busy highway. Managed to pull off side of road AND WAITED. AFTER A FEW MOMENTS CAR STARTED AND RAN AS EXPECTED.Took to local dealer who had the car for several days, but couldn't identify the problem. This instance was 2020/2021. Fast forward to this past September 26th. Pulling out of a private parking lot the car stalled exactly as it had previously.This complete failure of engine is going to get me killed. Further I now notice my dash lights are dimming for no reason then coming back to bright. Now I read where other Highlander are doing the exact thing. I have a car, I'm afraid to drive.

Experience "dead zones" in accelerator pedal movement. Experience "no acceleration" with first 1-2 inches of travel from idle position. This is constant and does not vary noticibly with speed. I was driving in an suburban shopping area in York PA with three lanes of travel in each direction. I intended to move from the laft hand lane to the center lane. I indicated my intentions and waited for an opening. I was travelling about 35-40mph. When an opening came along, I steered into the indended lane, but depressing the accelerator to increase my speed, no acceleration occurred. I then panicked and depressed the pedal quicker, and the ensuing acceleration nearly catapaulted me into the semi truck in the center lane ahead of me. I missed the truck by inches. I have had this issue evaluated at Bennett Toyota in Lebanon PA, and the Lancaster Toyota, the dealer who sold me the vehicle in May of 2023, is aware of the issue. Bennett Toyota service department tried to fix the issue by replacing the brake switch. That did not alleviate the problem. I have had several other instances when pulling into traffic when the delayed acceleration caused me issues but no accidents. I believe this issue is related to the selectable "snow" driving function. I think the system is somehow stuck in the "snow" mode at all times. I may have substantiated this today when I experimented with the "snow" function while driving at about 45 mph. When I select the "snow" mode while driving, the accelerator "dead zone" actually gets worse. Bennett Toyota Service response is "it drives like any other Highlander". If that is so - this is truly a huge issue with "drive by wire" tachnology...!!! As a note, at Bennett Toyota I did drive a 2019 Highlander privately owned by the service manager and it did indeed have the dead zone in the acelerator - a fact that the service manager admitted to me verbally. I have read many instances of this issue in chats online.

While I am driving my Toyota Highlander XLE 2019 in a parking lot to park my car, I stopped to yield to people crossing and I slowed down and applied brake , but my car stopped and unable to restart as car display showing an error - Braking Power Low I unable to star the car and ended up towing to Toyota Dealer ship in Plano,TX I am still waiting for Dealer to check on and advise on the issue I feel this is huge safety issue as car can stop in middle of traffic or on busy highway with out any warning and can cause a serious accident I am really pissed off at Toyota quality

This is a 2019 hybrid Highlander and the vehicle continually stalls or won’t start and we get a warning message that the hybrid system has stopped working and to put car in Park and restart. While this is happening regularly during startup, fortunately this has only happened once with the vehicle in Drive but represents a serious safety concern for us! We were being assigned to Germany and reported the issue to our local Toyota dealer who couldn’t duplicate the problem and said that the Toyota engineers said it couldn’t happen. Since arriving in Germany, the problem during startup has occurred on almost a daily basis. Last occurrence was this evening, 12 Dec 22.

The contact owns a 2019 Toyota Highlander. The contact stated while his wife was driving in a parking lot at approximately 2 MPH, the vehicle suddenly accelerated without the contact's wife having depressed the accelerator pedal. The vehicle crashed into a railing in the garage. The contact stated his wife had not noticed any warning lights. The vehicle had minor damage to the front grill and bumper there were scrapes and dents on the driver's side front fender and also to the passenger side front fender. The vehicle was drivable. The contact drove the vehicle to a local dealer, the vehicle had not been diagnosed. The vehicle had not been repaired. The manufacturer had been informed of the failure. The failure mileage was approximately 40,000.

When running, after stopping at a stop sign, the car hesitates to go, kind of sputters. When turning the car on, the lights on the dash flicker and now the car won’t start. On days prior, you would turn the car key, but the car wouldn’t start on the first time. It sounded like it wouldn’t turn all the way on, like the battery died. I didn’t leave the radio on or anything that would warrant that.My safety was put at risk because I work in healthcare and get off work at midnight so if I broke down or stalled in traffic, this could cause an accident.

I was driving and stopped at a red light on 4 lane intersection (very busy). I went to press on the gas and my car would not move. I put it in park and and then back in drive. It still did not move. It "died". I looked at the dash and it said "electrical system - move over to a safe place". My car would not start - I could not move it. I was stuck in the middle of the street -scared out of my mind. I had to call 911 and they told me someone already called for me and the police were on their way. When the police came he told me to stay in my car and he would stay behind me. There were no warning lights or anything to let me know that this was going to happen. If there was, I would not be in the middle of a 4 lane road. Toyota states it is the start-stop battery system. This is completely unsafe.

Since having recall work done my vehicles computer system has not been functioning the same. My vehicle has been stalling out and saying braking power low,stop in a safe place, charging system malfunction. I’ve reached out to Haley Toyota 8301 Midlothian Turnpike, Richmond, VA 23235 where the diagnostic was done and let them know of the error code I was given ( P0335) Crankshaft Position Sensor “A” Circuit. I took it in for diagnostic there and they told me they couldn’t find any issues with my vehicle , ( picked up Oct.3, 2021). It’s Oct.4 , 2021 and here I am at Sams Club trying to leave but my vehicle will not start. I contacted Toyota again and let them know of the same issue and they said to once again bring it in for diagnosing. I asked the gentleman on the phone if they had previously had it for a week and didn’t seem to find any issues with it after doing diagnostic then what were they planning on doing differently. My vehicle is under warranty and I’m trying to figure out who and where I can take it to to get some answers.