Forward Collision AvoidanceFuel/propulsion SystemVehicle Speed Control
CRUISE CONTROL SURGES BEYOND NORMAL LIMITS, HAS TRIED TO TAKE CURVES ON EXITS SO FAST THE TIRES SLIDE AND I HAVE TO SLAM ON THE BRAKES. ALSO, WHEN PULLING OUT FROM BEHIND A CAR, THE CRUISE CONTROL KICKS IN TOO FAST AND IS FLYING TOWARD STOPPED CARS, AND I HAVE TO USE THE BRAKE TO STOP IT OR REAR-END THE CAR IN FRONT OF ME. ALS…
Read full complaint
CRUISE CONTROL SURGES BEYOND NORMAL LIMITS, HAS TRIED TO TAKE CURVES ON EXITS SO FAST THE TIRES SLIDE AND I HAVE TO SLAM ON THE BRAKES. ALSO, WHEN PULLING OUT FROM BEHIND A CAR, THE CRUISE CONTROL KICKS IN TOO FAST AND IS FLYING TOWARD STOPPED CARS, AND I HAVE TO USE THE BRAKE TO STOP IT OR REAR-END THE CAR IN FRONT OF ME. ALSO, THE FUEL SYSTEM WOULD NOT ALLOW ME TO FILL UP THE GAS TANK, AND I WAS STRANDED. COMPUTER WOULD NOT OPEN THE FUEL TANK FOR ME TO PUT FUEL INTO IT. HAS TO PRY THE ENTIRE ASSEMBLY OFF AND BREAK IT. THEN FUEL WOULD NOT GO INTO THE FUEL TANK, AIR PRESSURE KEPT TURNING OFF THE PUMP. AFTER THOSE INCIDENTS GOT THE CAR BACK FROM THE DEALER AND TWO DAYS LATER IT WAS COMPLETELY DEAD IN THE GARAGE, NOTHING WORKED, LOCKS, BACK LATCH, ETC. WHEN THEY RECARGED IT THERE WERE DOZENS OF CODES ON.
Mazda North American Operations is recalling certain 2025 CX-50 and CX-50 Hybrid vehicles. The front suspension fastener bolts may not be tightened properly, which can result in suspension component and/or wheel detachment.
Consequence & remedy
Consequence: Wheel or suspension component detachment can cause a loss of vehicle control and a loss of drive power, increasing the risk of a crash.
Remedy: Dealers will inspect the front suspension fastener bolts and, if necessary, replace and tighten them, free of charge. Owner notification letters were mailed December 10, 2025. Owners may contact Mazda customer service at 1-800-222-5500 Option 6. The manufacturer's number for this recall is 7925J. Vehicle Identification Numbers (VINs) involved in this recall became searchable on NHTSA.gov beginning November 3, 2025.
Mazda North American Operations (Mazda) is recalling certain CX-50 Hybrid and CX-50 vehicles. Incorrectly configured module software may cause the air bag to deploy improperly.
Consequence & remedy
Consequence: An air bag that deploys improperly increases the risk of injury during a crash.
Remedy: Dealers will update the module software, free of charge. Owner notifications will not be mailed due to all vehicles being under Mazda dealer control. Owners may contact Mazda customer service at 1-800-222-5500 Option 6. The manufacturer's number for this recall is 7625F.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0
No exact-year investigations in this snapshot.
2025 Mazda CX-50 Problems, Complaints & Recalls | Skip That Year