2025 Jeep Wrangler

The contact called for an acquaintance who owned a 2025 Jeep Wrangler. The contact stated that while the vehicle was parked in the driveway, a neighbor saw black smoke coming from the vehicle. The neighbor called the authorities first and then called the contact, who was not at the residence during the failure. The vehicle caught on fire, and the neighbor alerted the occupants inside the residence about the fire. The Fire Department arrived on the scene and extinguished the fire. The fire burned several trees in the yard and damaged the concrete in the driveway. A fire report was filed. The remnant of the vehicle was towed to a salvage yard and deemed a total loss.

My Jeep is in limp mode and won’t go further than a mile before the power steering shuts down and the vehicle won’t move. I bought the vehicle used in March 2026 and took it to a local dealership to have the blind spot monitor system looked at and I was never made aware of any recalls. & now I will probably have to tow my vehicle out of pocket to the dealership to have it fixed.

Purchased vehicle in question on 9/11/25 as a lease through the local Jeep dealership near my residence. Sometime around 4/26 to 5/26 my vehicle started to display odd operational patterns which were brought to my local dealerships attention. The first event where I was able to record any type of documentation was around 5/25/26. While driving, the vehicle would suddenly go into "limp mode" and rapidly decrease speed. Several check engine lights would appear to include: Service Electronic Throttle Control, Service Electronic Stability Control, Traction Control and the standard CEL. When this does happen, the vehicle will decrease speed suddenly without warning and becomes difficult to operate until it is pulled over and parked. Vehicle has been to my local dealership several times (4) and out of service for over 70 days with the latest stay 30+ days. According to documentation from the dealership, the listed error/issue has been recreated on their end at least one time but no data was captured with that fail. My local Jeep dealership Service Manager (CF) replied to an email of mine (7/16/26 at 1703) with the following statement: Verified customer concern of check engine light on connect to wytec and found p2173 stored in powertrain control module. Also found c121c stored in ABS module. Believe ABS code is related to PCM code, cleared codes test drove multiple times. Finally able to get customer concern to duplicate but no data was captured on this failure. We are continuing to drive the vehicle while monitoring data to catch freeze frame data while concern occurs but have not been able to do so far at this time. The condition, when it occurs presents a serious safety concern for the driver and other drivers as it will cause a sever throttle limitation and can cause the vehicle to slow down rapidly. As of 8/9/26, no fix confirmed for my vehicle and the dealership and manufacture are pushing to return my vehicle with confirmed fix. Jeep case number 97378351

As I was driving a service electronic stability control came up on my dash and I lost control of the vehicle. The brakes did not work and it was hard to steer. I almost hit a vehicle and the Jeep kept rolling until it stopped. Then I received an alert that the brakes did system, anti lock brake system, and Electronic Stability System failure. This is very scary my vehicle is a lease and they say they are fixing it but I’m very scared I will lose control of my Jeep while I’m driving.

The 12-volt auxiliary battery and related electrical system in my 2025 Jeep Wrangler 4XE plug-in hybrid (leased new 8/25/2025) repeatedly fail. The battery completely discharges after the vehicle sits plugged into a standard home charger, undisturbed, for several consecutive days, leaving the vehicle completely inoperable. The vehicle is available for inspection upon request and is currently at a dealership. Failures to date (5): 11/05/2025: found dead after charging; required jump start. No warning lamps or messages precede the discharge events; the vehicle is simply dead when approached. 01/26/2026: dead after charging; would not jump start; towed. Dealer replaced the 12V battery and performed recall 68C software. 04/27/2026: check engine light illuminated while driving and the vehicle became stuck in electric mode; it would not switch to hybrid, gas, or E-save despite attempts, and a restart did not resolve it; towed. Dealer could not reproduce the fault. 05/17/2026: dead after charging; towed. 12V battery replaced a second time (same part number) and media hub replaced; vehicle was dead again at dealer pickup. 06/13/2026: dead after charging (plugged in undisturbed 6/9 to 6/13); towed. Tow operator noted the rear tires dragged during loading. Dealer/manufacturer confirmation: dealers have observed and documented the dead-battery condition multiple times, including a vehicle dead at pickup, but no dealer has reproduced the underlying failure or confirmed a root cause across five repair visits and approximately 56 cumulative days out of service as of 7/6/2026. The manufacturer's customer care team is engaged; it suspects a parasitic electrical draw, and the dealer is awaiting specialized test equipment. No police or insurance inspection. Safety risk: inability to leave electric mode while driving with the check engine light active; repeated complete electrical failures stranding occupants; an undiagnosed electrical draw in a plug-in hybrid that charges overnigh

While driving my 2025 Jeep Wrangler 4xe in normal conditions, the vehicle unexpectedly loses electric drive power. Power is reduced in stages — to approximately 50%, then 25% — then electric mode is disabled and the dash displays "Electric Mode Temporarily Unavailable," after which the vehicle forces into hybrid operation after a delay. During the delay, the vehicle does not deliver the power requested by the accelerator. This has occurred at 41%, 73%, and 81% battery state of charge during normal driving, with no wide-open-throttle demand — conditions under which the manufacturer's specification states electric power should continue. This is a loss of drive power. The manufacturer's own recall A7C (NHTSA campaign 25V710000) identifies a software error that may result in loss of drive power in these vehicles, and states that a loss of drive power increases the risk of a crash. My vehicle exhibits this condition but is not included in that recall population, which raises a question of whether the recall scope covers all affected vehicles. Safety risk: unexpected loss of drive power during normal driving — including when merging, crossing intersections, or pulling into traffic — creates a delay in which the vehicle does not respond to the accelerator as expected. Reproduced by the dealer: dealership service personnel personally experienced the loss of electric propulsion during a test drive, and the condition was also reproduced on a second 4xe vehicle at the dealership. In all cases, no diagnostic trouble codes were present, no repair was performed, and the vehicle was returned as "operating as designed." A neutral arbitrator in the manufacturer's warranty arbitration found that a nonconformity exists with a propulsion issue on the vehicle. The condition has not been properly diagnosed because I am unable to obtain the diagnostic measurement I have requested. The manufacturer's case manager has stated that warranty coverage for diagnostic testing cannot be confirmed