2024 Jeep Wrangler

My 2024 Jeep Wrangler 4xe has been subject to four safety recalls in the ten months I have owned it, three involving vehicle fire risk: 56C/25V-527 (TPMS, completed), 68C/25V-741 (high-voltage battery cell separator damage/fire risk, completed), 78C/25V-766 (casting sand contamination of the engine), and 21D/26V-363 (electric hydraulic power steering pump overheating/fire risk). Recall 78C was announced November 6, 2025, warning that my engine may be contaminated with casting sand and may suffer catastrophic engine failure, a vehicle fire, or an unexpected and unrecoverable loss of propulsion. More than eight months later, no remedy has been performed on my vehicle and the recall remains open. Recall 21D is also open, with FCA instructing me to park outside and away from structures because the vehicle may catch fire even while parked with the ignition off. Under recall 68C I was previously instructed not to charge the vehicle.

What component or system failed or malfunctioned, and is it available for inspection upon request?Multiple components across four separate manufacturer safety recalls: (1) the high-voltage battery (Recall 68C), currently being replaced by the dealer; (2) the Hybrid Control Processor / drive system (Recall A7C); (3) the electric hydraulic power steering pump (Recall 21D); and (4) the 2.0L engine (Recall 78C, status disputed — see below). The vehicle is currently at the authorized dealer and is available for inspection there. How was your safety or the safety of others put at risk?Recalls 68C and 21D are both manufacturer-designated fire risks; 21D specifically carries an "URGENT: FIRE RISK WHEN PARKED" designation in NHTSA's own database. Recall A7C describes a loss of drive power without warning while driving, which the manufacturer states may cause a vehicle crash. I experienced a stalling event with the drive indicator blinking on 10/17/2025 (10,553 miles); UNKNOWN whether this was directly caused by the A7C defect, but the symptoms match the recall's description.Has the problem been reproduced or confirmed by a dealer or independent service center?The 68C battery failure has been confirmed by the dealer, who is currently performing a full battery replacement. UNKNOWN whether the 10/17/2025 stalling event was ever formally diagnosed as connected to Recall A7C; the dealer's repair order for that visit does not reference A7C or a root cause. UNKNOWN whether Recall 78C's applicability to my vehicle has been confirmed or denied by the dealer — see discrepancy described below.Has the vehicle or component been inspected by the manufacturer, police, insurance representatives or others?The vehicle has been inspected and serviced multiple times by the manufacturer's authorized dealer. UNKNOWN whether any FCA/Stellantis field engineer or investigator has separately inspected it. No police involvement; no c

My 2024 Wrangler 4xe has 27,000 miles on it. On Friday, 7/10/2026 around 7:00 in the morning the check engine light came on. I immediately called the dealer to set up an appointment and they could not get me in until 7/15/2026. At about 9:30am that day when I was pulling a small trailer the battery light also came as I was driving on the interstate. As soon as I exited and slowed down, the car lost all power. It would not start or move. I was stranded on the exit ramp in the turn lane, with a trailer, unable to get to the shoulder. There was quite a bit of traffic around me. I was able to have it towed to the dealer. I had to safely get out of the vehicle and direct traffic around the vehicle. Today, 7/15/2026, the dealer ran the diagnostics and determined that the hybrid battery has failed and needs to be replaced. The car currently has 27,000 miles on it and this is now the second hybrid battery replacement and the third time the Jeep has stranded me and has required a tow to the dealer. It is unreliable and unsafe as it becomes immobile and loses power on the roadway.

Vehicle: 2024 Jeep Wrangler 4xe (VIN: [XXX]) Complaint Description: My vehicle is currently under active NHTSA Recalls 25V-766 and 26V-363. Following the 25V-766 software flash designed to detect internal engine bearing failure, the vehicle has experienced a sudden, unrecoverable loss of propulsion (Limp Mode) on the highway at 60 mph on three to four separate occasions. This has nearly resulted in high-speed rear-end collisions, making the vehicle incredibly dangerous for my family. The vehicle is currently grounded at Criswell Jeep in Maryland. Despite the vehicle experiencing the exact catastrophic failure outlined in 25V-766, Stellantis corporate and the local dealership are refusing to authorize the mandated engine block replacement. The dealership claims their local technicians cannot physically replicate the failure and do not know how to extract the historical freeze-frame data from the vehicle's computer. Instead of dispatching a Stellantis Field Technical Specialist to pull the internal Uconnect logs—which Jeep Cares corporate admitted on a recorded line is the required next step if the local tech cannot duplicate the issue—the dealership has put over 150+ unnecessary test-drive miles on the vehicle and consumed half a tank of gas trying to blindly trigger the failure. Conducting 150 miles of highway test driving on a vehicle with a documented history of suddenly losing propulsion while it simultaneously has an active, unpatched fire risk (26V-363 "Park Outside" advisory) is a severe safety liability. Furthermore, Jeep Cares explicitly refused to reimburse me for the gas and mileage, stating this excessive driving is just part of their diagnosis and quality control. The manufacturer is negligently failing to execute a federal safety recall by refusing to utilize proper engineering diagnostic tools, leaving INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

After performing the 68c recall vehicle no longer drives the way it was designed. When in hybrid mode pushing the accelerator to the floor results in a 2-6 second delay waiting for the gas motor to kick in and then it slams the power into the car. This car is extremely unsafe and impossible to merge into the highway correctly now. Car does not show any warnings and dealer claims this is normal operation.

Was traveling approximately 55 MPH down the highway for 15 min in electric mode. Moved to the shoulder and stopped quickly using regenerative braking for an oncoming emergency vehicle. I got back on the highway and I suddenly lost almost all pedal response and it would not accelerate. I kept pushing the accelerator pedal harder and harder. That's when the ICE kicked on and there was a sudden violent lurch forward and the engine was screaming at over 5000 RPM. There were cars approaching behind me and they had to suddenly stop and they honked horns and avoid hitting me. This sudden throttling of the battery/electric and very erratic switch over to ICE is dangerous.

I have a 2024 Jeep Wrangler 4xe plug in hybrid. When I first got the vehicle I could drive in the electric mode without kicking over to the gasoline mode. The manufacturer issued a recall for the battery due to fire danger. I had an update 68c performed by the dealer to address the recall issue. Upon getting my Jeep back I can no longer drive in the electric mode without the Jeep surging into and out of the gas mode. This happens at different times, slow speeds or fast speeds. The jeep does hesitate or bogs down prior to engaging the gas mode. After takinThe 68C recall was issued because the high-voltage battery cells have a defect (separator damage) that causes them to short-circuit and catch fire. To avoid replacing hundreds of thousands of expensive batteries all at once, Stellantis implemented a "fix" via a software flash. Here is exactly what that software is doing to your driving experience: Aggressive Battery Throttling: The new software heavily restricts how much power can be drawn from the high-voltage battery to keep it from getting warm. If you push the pedal enough to draw more than roughly 40–50% power—or if the battery temperature hits a strictly lowered threshold—the software abruptly chokes the electric motor. The "Bogging" Sensation: When the software chokes the battery, the vehicle experiences a sudden drop in power. This is the hesitation or "bogging down" you feel. The Violent Engine Surge: Because the electric motor just lost its punch, the computer frantically fires up the gasoline engine to make up the difference. Because there is an inherent delay while the gas engine starts up and matches the transmission speed, it engages with a sudden, frustrating lurch or surge. Because this clunky, unrefined behavior was intentionally coded into the 68C update by corporate engineers to limit fire risks, your local dealer's computer diagnostics read "No Errors Found" and "Operating as Designed."

This is apparently an ongoing problem with all Jeep 4xe's that have passed the 68c recall. The vehicle will no longer operate in "Electric" mode in normal driving conditions, this is our second Wrangler 4xe and we have a total in excess of 50k miles of typical driving in "Electric" mode. The vehicle will no longer function safely in "Electric" mode as it did prior to the recall, it now fails to accelerate for minor hills and slows down to the point of causing following vehicles to come dangerously close to the rear of the vehicle. After a long delay with the pedal now to the floor and the vehicle slowing further as it's trying to go up an incline the ICE (gas engine) violently starts and lurches forward in an unnatural manner. The response by Stellantis is that this is "Normal" operation of the vehicle. I can 100% tell you this is not normal as neither of our 4xe's operated in this manner prior to the recall. I can only imagine what would happen if we attempted to merge into traffic or try to cross an intersection and this "Normal" operation happened.

Since having the battery recall done in January, my Jeep is a completely different car. In electric mode, it can no longer go up hills without losing significant power to the point where it slows down a lot. I have to manually change it to hybrid mode so that I don't get rear ended. It will no longer quickly and effectively change by itself like it did before the software update. It has also been having issues with power when going around turns or accelerating from a stopped position. In order to go more than 20-25 mph, I have to floor the pedal after completing the turn. This creates a problem when trying to merge into traffic and/or turning into the far lane and crossing traffic to do so. This puts myself and others in danger when trying to merge/cross. I have taken it back to the dealer twice now for power issues and this past time (June 2026), even though the techs could tell there was an issue, Jeep is saying that it's "normal" functioning after the recall update. There is no specific date for this incident, as it happens everytime I drive it. I can no longer trust this car to keep me safe in normal driving conditions.