Seat Belts. Review the 33 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Structure. Review the 33 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Latches/locks/linkages. Review the 30 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

10 crash reports8 fire reports7 injury reports

Suspension complaints

4 reports

Clear category filter

Mileage unknown · Oct 6, 1999

Suspension

WHILE DRIVING AT ABOUT 40 MPH THERE'S A GRINDING NOISE. GRINDING NOISE GETS LOUDER THE FASTER VEHICLE GOES. *AK

NHTSA ODI #850080

Mileage unknown · May 28, 1997

Electrical SystemSuspension

STARTER FAILED.

NHTSA ODI #517462

Mileage unknown · Apr 11, 1995

Suspension

LEFT COIL SPRING ON FRONT SUSPENSION BROKE. TT

NHTSA ODI #963550

Mileage unknown · Jan 26, 1995

Suspension

FORWARD REAR BEAM BOLTS HAVE BACKED OUT AND STRIPPED CAUSING STEERING TO GO OUT. TT

NHTSA ODI #959168

Official recalls

95V103001 · Seat Belts:front:buckle Assembly

May 24, 1995

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Consequence & remedy

Consequence: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.

Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES. CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. CHECK THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUG ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, THEN PRESS THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS ANY SIGN OF BREAKAGE OR CRACKING, OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, PROMPTLY CONTACT YOUR AUTHORIZED HONDA/ACURA DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT THE FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.

93V056000 · Seat Belts:front:anchorage

Apr 22, 1993

THE REAR OUTSIDE SEATING POSITION SAFETY BELTS MAY LOCK UP AT ANGLES OTHER THAN THOSE REQUIRED BY FMVSS 209, "SEAT BELT ASSEMBLIES". THIS DOES NOT CONFORM TO THE MOTOR VEHICLE SAFETY STANDARD.

Consequence & remedy

Consequence: NON-CONFORMING SAFETY BELTS CAUSE AN INCREASED RISK OF INJURY IN THE EVENT OF A SUDDEN STOP OR ACCIDENT.

Remedy: REPLACE THE SENSOR IN THE REAR SEAT BELT RETRACTOR.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗