2022 Ford Escape Hybrid

"While driving my 2022 Ford Escape Hybrid, the vehicle suffered an abrupt powertrain failure. A wrench icon and check engine light illuminated on the dashboard, and the vehicle immediately dropped into a low-speed mode that severely limited my throttle control on the road. I was unable to drive home and had to leave the vehicle on the road until I could get a tow. The vehicle is currently grounded and unsafe to operate at a Ford dealership lot. Ford customer service is actively refusing to authorize alternative transportation or honor the extended coverage parameters outlined in Customer Satisfaction Program 23N06, which covers this exact engine defect."

The contact owns a 2022 Ford Escape. The contact stated that upon starting the vehicle, the check engine warning light illuminated and remained illuminated. The vehicle was taken to a local dealer where it was diagnosed, and a code for ABS Internal Module Failure was displayed. The contact was informed that further diagnostic tests were needed to determine the cause of the failure. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 55,000.

On 20 July 2026, my 2022 Ford Escape HEV caught fire in the engine compartment while parked. The vehicle is likely a total loss (insurance pending). On-site emergency personnel responded within minutes of the fire and the local fire department was on scene within 5 minutes of the 911 call. They cleared the incident (and d/c the 12V) within 32 minutes of arrival. Detroit Fire Department Incident: 202620101471. This vehicle was subject to Ford Safety Recall 23S27 and Customer Satisfaction Program 23N06, which address a manufacturing defect in the 2.5L HEV/PHEV engine. Under that recall, connecting rod bearing journals were not properly finished, causing premature bearing and engine failure that can release engine oil and fuel vapor into the under-hood area resulting in a fire. The recall remedy was completed on my vehicle, as were all customer satisfaction program campaigns. The dealer performed the PCM software update, which is intended to detect early signs of bearing failure through diagnostic trouble codes (P1061 and P032F) so the failure can be caught before an engine breach occurs. The engine long block was NOT replaced. Under Ford's own criteria, long block replacement was only authorized if the vehicle exhibited loud metal-to-metal clanking noises, a loss of torque, or the associated diagnostic codes. Dealership personnel assured me an engine light would illuminate and I would have time to safely move the vehicle to the side of the road. My vehicle did not have any warnings: no clanking, loss of torque, or leaks-no diagnostic warnings of any kind before the fire. The recall remedy did not prevent the exact failure it was designed to prevent--Ford's response was inadequate to protect owners. My NHTSA VIN lookup shows no open recalls. I completed every recall and CSP Ford issued. I have complete dealer service records for this vehicle, photos of the damage, hi-res surveillance video is saved at work, as well. The vehicle is intact and has not been salvaged.

The contact owns a 2022 Ford F-150. The contact received notification of NHTSA Campaign Number: 26V104000 (Electrical System, Exterior Lighting); however, the part to do the recall repair was not yet available. The contact stated upon starting the vehicle, the message " Trailer Brake Module Failure" was displayed. The vehicle was taken to the dealer, where it was diagnosed and determined that the integrated trailer module (ITRM) had failed and needed to be replaced. The dealer informed the contact that the manufacturer had failed to make the part available for the repair. The vehicle was not repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The failure mileage was approximately 72,000.

The contact owned 2022 Ford Escape. The contact stated that while her husband was driving 65 MPH uphill, another vehicle attempting to make a left turn in front of the vehicle crashed into the vehicle. The contact stated that several air bags deployed inside the vehicle; however, the steering wheel and the front passenger’s side air bags failed to deploy. The contact stated that the Forward Collision Avoidance feature failed to operate during the failure. The contact sustained injuries to the head, left hand, and the back. Medical attention was sought. The contact stated that a Police report was not filed. The manufacturer was not notified of the failure. The approximate failure mileage was 180,000.

The cloth that covers the sun roof sags into the car. One side of mine still holds the cloth mostly into place, but if that side breaks, the cloth will drop into the car which will make it impossible to see anything behind me. After receiving an estimate for repair, I was told by the repair tech that this was a common problem with these sun shade assemblies.

The contact owns a 2022 Ford Escape. The contact stated that while driving at various speeds, the instrument panel intermittently displayed a blank screen. The vehicle was taken to the dealer and test driven, and the failure was duplicated. The vehicle was diagnosed with a defective instrument cluster, and the contact was provided an estimate for the repair. The manufacturer was notified of the failure and agreed to cover a partial amount of the cost of repair. The vehicle was not repaired. The failure mileage was approximately 38,000.

The contact owns a 2022 Ford Escape. The contact stated that upon visual inspection, there was excessive corrosion on the driver's side door panel. The vehicle was taken to the dealer, who determined that there was water entering through the front body hinge pillar and down to the rocker panel. The contact was informed that the water should drain out, but instead was causing the excessive corrosion to all four doors. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was 21,000.

The Panoramic Sunroof Drip Molding will not stay attached. When it falls, it can rip the sunshade causing it to hang down from the roof and block the drivers rear vision. The glue pads that are provided with the molding does not last long and it causes the molding to rattle with every bump as it starts failing. THE RIPPED SUNSCREEN HAS NOT HAPPENED TO MY CAR, BUT THE MOLDING PIECE DOES KEEP FALLING OFF...NO MATTER WHAT TYPE OF ADHESIVE I USE!