2014 Ford Edge

2014 ford edge backorder prevention, identical to the recall for 2021 & 2022 edge recall for distorted or camera not available NHTSA Campaign Number: 22V151000. This recall should be expanded to include other years including 2014 edge as these vehicles are having the same issue. This happens every day and as soon as you put the vehicle into reverse.

This is a known issue with Ford models. The door sensor does not work correctly when the doors are closed. The sensor alerts that a door is still open, and will keep the dome light on and will not allow the doors to lock. This is a huge issue with not being able to see at night with the light on, and doors not locking with children in the back seat. There is also another sensor that does not sense when the vehicle is in park. Then again you are not able to lock the doors of the vehicle.

The contact owns a 2014 Ford Edge. The contact stated that while driving at various speeds, the brake pedal was either stiff or soft upon depression. The contact also stated that the check engine warning light had illuminated the instrument panel. The contact had initially taken the vehicle to an independent mechanic who informed him that there was a service bulletin on the vehicle; the mechanic referred him to a dealer. Upon taking the vehicle to a dealer, he was informed that his vehicle was not covered under the service bulletin. The manufacturer had yet to be notified of the failure. The dealer repaired the vehicle. The failure mileage was 80,000.

When the vehicle reaches up to 80,000 miles or so, you may hear a clicking or clunking in the rear when turning or ascending. Nowhere listed in the driver's manual is a power transfer unit mentioned. Obviously, the fluid in this part has to be changed every 30,000 miles. Resulting in a very expensive repair if not done so. I am being quoted 2500.00 for the part and installation by a ford dealer. The power transfer unit blew up, has black oil and metal fragments in it.

The contact owns a 2014 Ford Edge. The contact stated that while driving at an undisclosed speed, the powertrain malfunction warning light was illuminated, then the vehicle stalled. The vehicle was taken to the dealer and diagnosed with throttle body failure. The dealer replaced the throttle body. The manufacturer was made aware of the failure but informed the contact that the VIN was included in any recalls and referred the contact to file a complaint with NHTSA. The failure mileage was 58,338.

The contact owns a 2014 Ford Edge. The contact stated while driving 40 MPH and approaching a stop sign, she had to depress the brake pedal to the floor to stop the vehicle. The contact also stated she heard an abnormal noise. The contact stated no warning light was illuminated. The contact took the vehicle to the local dealer, where it was diagnosed with needing the brake booster to be replaced. The vehicle was repaired but on 11/8/2021, she began to experience the failure again. The contact took the vehicle back to local dealer, where it was diagnosed with needing the brake master cylinder to be replaced. The master cylinder was replaced 11/22/2021 but failed to fix the failure. The dealer informed the contact that the hydraulic control unit needed to be replaced. The vehicle was not repaired but was pending the repair. The manufacturer had been informed of the failure. The failure mileage was 64,800 as of 2/14/2022. The contact stated that the hydraulic control unit was not replaced and the vehicle was taken to another mechanic. The right rear caliper piston was repaired. The failure has not reoccurred.

Brake pedal became very hard to press down, severely limiting the ability to stop the vehicle. The brake booster is available for inspection. It appears that there was a recall for 2009-2013 models but not for the 2014. My car was built and assembled in December of 2013 at the same plant installed the defective boosters. There were no warning lights or indication of a problem. The brake booster has been replaced by a reputable shop.