2007 BMW 525I

The contact owns a 2007 BMW 535I. The contact stated that while operating the vehicle, the passenger’s side air bag warning light remain illuminated, indicating a possible failure to the air bag system. The cause of the failure was not yet determined. The local dealer was notified of the failure. The manufacturer was not yet notified. The failure mileage was 100,000.

The contact owns a 2007 BMW 525I. The contact received notification of NHTSA Campaign Number: 22V119000 (Engine and Engine Cooling). The vehicle was taken to the dealer for the recall repair however, upon retrieving the vehicle, the contact noticed that the vehicle was shaking while driving at various speeds. The contact stated that the failure had worsened while at a complete stop. Over time, the service engine warning light illuminated. The dealer was notified of the failure and the contact was placed on an indefinite hold until the call disconnected. The manufacturer was not notified of the failure. The vehicle was not repaired. The failure mileage was 284,191.

The contact owns a 2007 BMW 525i. The contact stated that while driving at approximately 75-85 MPH, she smelled smoke coming from the hood of the vehicle. The contact was unsure if any warning lights illuminated. The vehicle was taken to an independent mechanic where he referenced NHTSA Campaign Number: 22V119000 (Engine And Engine Cooling) , but the vehicle was not diagnosed for the failure. The dealer was not notified of the failure. The manufacturer was not notified of the failure. The approximate failure mileage was 189,000.

The contact owns a 2007 BMW 525i. The contact received notification of NHTSA Campaign Number: 22V119000 (Engine and Engine Cooling) however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2007 BMW 525i. The vehicle had previously been serviced by the dealer under an unknown NHTSA campaign; however, the failure recurred with a burning odor detected. Additionally, several unknown warning lights were illuminated. The contact then received notification of NHTSA Campaign Number: 22V119000 (Engine and Engine Cooling) however, the part to do the recall repair was not yet available. The dealer was made aware of the failure but confirmed that parts were not yet available. The manufacturer was made aware of the failure but confirmed that parts were not yet available. The vehicle was not repaired. The failure mileage was 34,406. VIN tool confirms parts not available.

I purchased said automobile from my neighbor for my son to drive. I figured it was a good car to buy because it was serviced by Hendrick BMW (Charlotte, NC) only and regularly. BMW's also have a reputation for being safe as well as reputable so this also weighed into my decision. Fast forward 18 months. The passenger rear brake bulb went out. We replaced the bulb, it worked for a short time, then went out. We replaced the bulb again. This time it didnt work. About a week later the front passenger side head light went out, then the other side. We took it to Hendrick BMW for repair. Hendrick has told us the car wiring basically needs to be replaced due to the protective coat wearing off and corroding the bare wire underneath. The headlights/ brake light will also need to be replaced due to the corrosion blowing out the bulb. For the front headlight the whole assembly needs to be replaced at a tremendous cost. I performed a google search on this and found many, many instances of the same issue. Ive seen many of these cars while casually driving around town. It would seem to be a MAJOR issue if an active drivers head and tail lights suddenly stopped working on a busy road. Also due to the cost most people probably wouldnt fix the issue on their own and drive the car anyway causing an ever bigger safety issue. I have never had this issue with any other vehicle brand ive owned. Ive looked into this issue with other brands and most tell me they use wiring which will not do this. I am not sure why BMW would not do the same. The car is also up for inspection. The car will not pass inspection unless I pony up over $6k ($2500 NADA value) to fix. My taxes are also due. In NC you cant pay the tax unless the car passes inspection. This is costing me daily penalties in addition to the major safety issue. I believe the NHTSA has a duty to look into this major manufacturing defect and have BMW provide remedy to those other unfortunate folks who are experiencing the same issue.

HEADLIGHT WIRING INSULATION ROT LEAD TO FAILED HIGH AND LOW BEAMS ON DRIVER SIDE AND INTERMITTENT FAILURES OF BOTH BEAMS ON PASSENGER SIDE. SEE PHOTO FOR EXAMPOLE OF DISINTEGRATED WIRING ON DRIVER HIGH BEAM WIRING HARNESS. ONLY KNOWN OPTION IS TO BUY A COMPLETE NEW HEADLIGHT ASSEMBLY ($1250+ PER SIDE) OR ATTEMPT DIY. THIS PROBLEM IS WELL-KNOWN AND HAS LONG BEEN REPORTED BY OTHER BMW E60 (5 SERIES 2004-2010) OWNERS AT BIMMERFEST.COM AND 5SRIEST.NET. SEE THESE URLS FOR MORE INFORMATION: HTTPS://WWW.BIMMERFEST.COM/FORUMS/SHOWTHREAD.PHP?T=798640 HTTPS://WWW.BIMMERFEST.COM/FORUMS/SHOWTHREAD.PHP?T=883000 HTTPS://5SERIES.NET/FORUMS/E60-E61-PARTS-ACCESSORIES-MODS-22/OPENING-UP-E60-HEADLIGHTS-138473/