2022 Toyota Tacoma

Transmission pops out of 2nd gear everyday after setting on level ground. I have questioned Toyota about the fluid levels, which they say its a sealed unit and cant be checked. It takes about 20 feet before the transmission rengages. It only happens when the transmission temperature is cold, then does not happen again. This can leave me without any power. Toyota has checked the vehicle twice and cannot duplicate the issue. The issue started shortly after i bought the vehicle.

In March, 2022, we had ice that coated the car and the driveway of my residence that led to schools being closed. The next day conditions were better, and on my way home from work I noticed that the passenger side view mirror had developed a strange crack that at first made me think that a sticker had been placed on the mirror. When I examined it closer, I found it to be a crack in the mirror that I tend to think was the result of the icing from the previous day. My concern is that the crack will spread and make the mirror unusable. I discussed this with my service advisor at Wilde Toyota in Milwaukee on 4/11/22 and told him that I felt the crack was a manufacturers defect. The advisor told me that they would not cover the damage as a defect, but that he had taken photos and sent the information to Toyota for consideration. The paperwork provided to me did not confirm or state that anything had been sent to Toyota.

The contact owns a 2022 Toyota Tacoma. The contact stated that both the front driver's seat and front passenger’s seat were vibrating while depressing the brake pedal. The vehicle was taken to the dealer, where it was diagnosed that the rear brake drums were grooved. The dealer turned the rear brake drums; however, the failure persisted. Additionally, the contact stated while driving at various speeds, the Pre-Collision malfunction warning light was illuminated. The contact stated that the failure also occurred upon starting the vehicle. The dealer was notified of the failure and informed the contact that the failure was caused by rainy and snowy weather; however, the contact stated that the failure had been occurring in good weather conditions as well. The dealer informed the contact that they could not diagnose the vehicle unless the warning light was illuminated at the time the diagnostic tests were being performed. The contact stated that the warning light would turn off upon turning off and restarting the vehicle. The vehicle was not repaired. The manufacturer was notified of the failure, but no assistance was provided. The failure mileage was approximately 10.

(HSA/Auto Vehicle Hold) Upon backing out of a heated garage onto a flat, lightly snow-covered asphalt driveway, a light to medium brake apply to test out surface conditions was done, and little to no sliding was observed. Upon reaching a conclusion that it was likely safe to proceed, vehicle was shifted into reverse and upon nearing the crest of a 14% grade on a residential driveway (asphalt), brakes were lightly applied (similar pedal force to the "test"), then released once grade was almost crested. The vehicle had been shifted into neutral and clutch was released prior to applying the brakes. It seemed as if the brake pressure from the light apply was not released, and wheels remained locked causing loss of control. ABS did not activate, and steering input had little/no effect. Vehicle slid off of driving surface and struck a tree, causing damage to rear bumper, tailgate, and rear left quarter panel (no visible frame damage). Upon safely bringing the vehicle back onto the driveway surface (bottom of driveway, ~5-9% grade), a second test to see if brake pressure was trapped was performed. The vehicle was allowed to roll to ~3mph, same light pedal force as before was applied and the brake pedal was released (in neutral with clutch released). The vehicle skidded to a stop with no signs of ABS or stability control activation (no lamps, etc), and about 2s later, a clicking sound was heard from the engine bay and the vehicle began rolling freely again with foot still off the pedal. No warning lamps ever illuminated, nor were any messages or functional notifications. No throttle input was given after the vehicle was shifted out of reverse.

My 2022 Tacoma has 1200 miles on it. While turning a corner I slowed down to make the turn when I pushed on the pedal to speed back up there was no response from the engine. It was dark outside and my dash lit up like the key was turned off. I kind of panicked and began pumping the pedal thinking I was out of gas. The fuel gage showed 3/4 an after 3 or 4 seconds it started back up. A week or so before I was at a red light when it turned green I tried to accelerate, the engine hesitated again like it was out of gas. I pumped the pedal but no response. After a few seconds it took off like a jet across the intersection and my foot was barely touching the pedal. Also while driving around 40-50 mph it feels like a stick shift vehicle that needs to be down shifted in a lower gear as there is a chunging feel which I think the transmission can't decide what gear to use. At those speeds it goes away if I manually move the shifter out of D into 4 or 5. Then It runs smooth. I took it to a Toyota Dealer near my house on 1/3/2023 They said they could not duplicate the problem. I said it does not happen all the time. The tech said he reset my computer.

Tire size 265/65/R17 In 8000 miles on a 2022 Toyota Tacoma, purchased new in August 2022, I have had two Nitto Ridge Grappler sidewall failures. Each has happened at highway speeds (55-60 mph) with adequate pressure (35 PSI). No objects or road hazards were encountered. Each tire displayed significant sidewall damage resulting in rapid loss of pressure (blowout). The passenger side front and driver side rear have both experienced the failure. This is a safety concern as a rapid decrease in pressure creates unstable driving conditions. So far, I have received no response from Nitto or Toyota regarding the failures. Instead, I am now required to purchase two new tires. I am concerned the other two will eventually fail on the sidewalls as well.

I purchased my vehicle (Toyota Tacoma TRD PRO) on September 23, 2022 and identified issues with all of the exterior cameras immediately. I scheduled an appointment with Toyota to inspect the problem with blurry cameras on September 29, 2022, but they advised that all 2022 vehicles have similar blurriness issues. I also own a 2018 Toyota Highlander that has a much more crisp image, so I know Toyota has a problem with the cameras. Fast forward to approximately November 20, 2022 when my first problem occurred. I was backing into a parking space that had a shopping cart that was left on the sidewalk behind my parking space. Knowing that I was clear to park, I proceeded to back into the space, but as I started to back up, the already blurry camera flared up because of the direct sunlight and I could not observe anything. It so happens that the shopping cart started to roll towards my parking spot and hit the bumper of my truck, because of the high tailgate I was not able to observe this moving cart in my mirrors. Because of the flared and blurry camera image, I could not see the cart and the minor collision occurred. There was no damage to either my truck or the cart, but this could have been a child or animal and could have resulted injury or loss of life. As I have learned, this particular camera cannot be relied upon for the safe viewing behind the vehicle as it was intended. As my vehicle is equipped with multiple front, side, and rear cameras and they are all blurry, I would presume the problem lies somewhere with the computer or image controlling board that the cameras are attached to. This issue has not been inspected by the police or insurance company as no loss occurred and there were not faults indicated on the vehicle. Toyota did state that this was the normal operation for all 2022 vehicles and I presume this is a widespread issue what will inevitably have dire consequences down the road. Please evaluate and encourage Toyota to produce a fix.