While driving my 2026 Toyota RAV4 Hybrid (VIN [XXX], approximately 354 miles on the odometer), I was involved in a frontal collision. Event Data Recorder (EDR) data retrieved from the vehicle's Airbag Control Module via Bosch CDR tool confirms the following: The Pre-Collision System (PCS) On/Off switch was ON and the system repo…
Read full complaint
While driving my 2026 Toyota RAV4 Hybrid (VIN [XXX], approximately 354 miles on the odometer), I was involved in a frontal collision. Event Data Recorder (EDR) data retrieved from the vehicle's Airbag Control Module via Bosch CDR tool confirms the following: The Pre-Collision System (PCS) On/Off switch was ON and the system reported "Enable" status (no fault/DTC) throughout the 5-second pre-crash window. The Automatic Emergency Braking (AEB) system status was recorded as "On, Non-Engaged" for the entire pre-crash window. The PCS-PBA Request Flag (which would indicate the system requested automatic brake assist) remained OFF for the entire pre-crash window — the system never requested autonomous braking. The PCS-ALM Request Flag (forward collision alert/warning) also remained OFF for the entire pre-crash window — no forward collision warning was issued to the driver at any point. No Diagnostic Trouble Codes (DTCs) were present at the time of the event. All braking that occurred was driver-initiated: the EDR shows Service Brake changing from Off to On only 0.27 seconds before impact, with brake pedal position reaching 100% by the time of impact. The primary point of impact was recorded as Front (12 o'clock position), a squarely centered frontal impact — the type of scenario Toyota's own marketing materials describe the Pre-Collision System as designed to detect and respond to. The vehicle's Pre-Collision System and Automatic Emergency Braking — both active, switched on, and reporting no internal fault — did not provide any forward collision warning and did not request automatic braking at any point before this frontal impact occurred. This is the first-model-year rollout of Toyota Safety Sense 4.0 on the redesigned 2026 RAV4. I am filing this report to document this incident for NHTSA's records and to flag a potential pattern concern for this new-generation safety system. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2024 Toyota Tacoma Hybrid, 2025 Tundra Hybrid, Tundra, 2026 RAV4 Hybrid, 4Runner i-Force Max Hybrid, and 4Runner vehicles. The load carrying capacity modification label may display inaccurate added weight values. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 110, "Tire Selection and Rims."
Consequence & remedy
Consequence: A vehicle with an incorrect maximum capacity weight value may be overloaded, increasing the risk of a crash.
Remedy: Dealers will replace the load carrying capacity modification label, free of charge. Owner notification letters are expected to be mailed October 18, 2026. Owners may contact Toyota's customer service at 1-800-331-4331. Toyota's number for this recall is 26TA18.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0
No exact-year investigations in this snapshot.
2026 Toyota RAV4 Hybrid Problems, Complaints & Recalls | Skip That Year