Severe structural corrosion was discovered on a low-mileage 2019 compact SUV affecting critical suspension components, including the front subframe, lower control arm mounting points, and structural attachment areas. The issue was identified during inspection at a dealership. The technician documented that suspension components…
Read full complaint
Severe structural corrosion was discovered on a low-mileage 2019 compact SUV affecting critical suspension components, including the front subframe, lower control arm mounting points, and structural attachment areas. The issue was identified during inspection at a dealership. The technician documented that suspension components were severely rusted, subframe bolts were rusted and cracking, and lower control arms were deteriorating due to corrosion. The technician advised that the vehicle should not be driven and recommended towing for further structural inspection. These components are part of the load-bearing suspension system and may pose a safety risk if failure occurs. This level of corrosion is unusual given the vehicle has approximately 27,000 miles and has been operated in a region without exposure to road salt or severe winter conditions. Independent mechanics who inspected the vehicle also expressed concern about the severity of the corrosion. The problem was confirmed by both a dealership and an independent repair facility. The vehicle was not inspected directly by the manufacturer. No warning lights or messages were present prior to discovery of the issue. Photographic evidence shows rust perforation, material loss, and metal delamination along structural seams, indicating corrosion progressing internally. This condition may compromise suspension mounting integrity and increase the risk of failure while driving. The affected components were repaired and are available for inspection upon reque
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2019-2020 C-HR and 2020 Corolla and Corolla Hybrid vehicles equipped with rear seat belt assemblies with a dual-mode locking mechanism. The seat belt webbing sensor locking mechanism may not lock as intended.
Consequence & remedy
Consequence: In the event of a crash involving multiple impacts, the seat belt may not properly restrain the occupant, increasing the risk of injury.
Remedy: Toyota will notify owners, and dealers will inspect the rear seat belt assembly production dates, and replace the assemblies, as necessary, free of charge. The recall began February 7, 2020. Owners may contact Toyota customer service at 1-888-270-9371. Toyota's numbers for this recall are 19TB22 and 19TA22.
Additional source detail variants (2)
Seat Belts: Rear/other:buckle Assembly
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2019-2020 C-HR and 2020 Corolla and Corolla Hybrid vehicles equipped with rear seat belt assemblies with a dual-mode locking mechanism. The seat belt webbing sensor locking mechanism may not lock as intended.
Consequence: In the event of a crash involving multiple impacts, the seat belt may not properly restrain the occupant, increasing the risk of injury.
Remedy: Toyota will notify owners, and dealers will inspect the rear seat belt assembly production dates, and replace the assemblies, as necessary, free of charge. The recall began February 7, 2020. Owners may contact Toyota customer service at 1-888-270-9371. Toyota's numbers for this recall are 19TB22 and 19TA22.
Seat Belts:rear/other
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2019-2020 C-HR and 2020 Corolla and Corolla Hybrid vehicles equipped with rear seat belt assemblies with a dual-mode locking mechanism. The seat belt webbing sensor locking mechanism may not lock as intended.
Consequence: In the event of a crash involving multiple impacts, the seat belt may not properly restrain the occupant, increasing the risk of injury.
Remedy: Toyota will notify owners, and dealers will inspect the rear seat belt assembly production dates, and replace the assemblies, as necessary, free of charge. The recall began February 7, 2020. Owners may contact Toyota customer service at 1-888-270-9371. Toyota's numbers for this recall are 19TB22 and 19TA22.
Gulf States Toyota (GST) is recalling certain 2019 C-HR, 4Runner, Avalon, Avalon Hybrid, Camry, Camry Hybrid, Highlander, Land Cruiser, Prius, RAV4, Sequoia, Tacoma, Sienna, Tundra and Yaris vehicles. The text on the load capacity label may become illegible. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 110, "Tire Selection and Rims."
Consequence & remedy
Consequence: If the driver cannot read the label, they may unknowingly overload the vehicle, increasing the risk of a crash.
Remedy: GST will notify owners, and dealers will provide corrected load carrying capacity modification labels, free of charge. The recall began May 24, 2019. Owners may contact GST customer service at 1-800-444-1074. GST's number for this recall is 19R1.
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2019 Toyota C-HR vehicles. The rear axle hub bearing bolts may have been insufficiently tightened, causing the bolts to loosen and damage the rear brake components or cause a rear wheel to detach.
Consequence & remedy
Consequence: If the bolts loosen and damage the rear brake components, or cause a rear wheel to detach, it would increase the risk of a crash.
Remedy: Toyota will notify owners, and dealers will inspect the rear axle hub bearing bolts. If a bolt is found to be loose or detached, the dealer will replace the rear axle hub bearing assembly and rear axle carrier sub-assembly, free of charge. The recall began November 6, 2018. Owners may contact Toyota customer service at 1-888-270-9371. Toyota's number for this recall is J0Y.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0
No exact-year investigations in this snapshot.
2019 Toyota C-HR Problems, Complaints & Recalls | Skip That Year
Illustration