2020 Subaru Forester

Vehicle traveling W on [XXX] Bryan TX. Automobile suddenly started shaking and not developing power, Driver was able to pull off on the shoulder barely clearing the #2 lane. The engine would crank but not sustain operation. The auto required transport to the home garaging location. Subsequent analysis of the fuel showed it to be gasoline, no water, lacked appearance of any foreign matter. With the ignition on 12V were detected at the gas tank terminal, however the in tank pump would not produce fuel flow at the connection at the top of the tank. Had the vehicle been operating in the #1 lane it may not have been possible to clear the traveled lanes thus causing a traffic safety problem. A State Trooper did provide protection until the vehicle was transported. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

A week after my routine oil changed at 31K, the check engine light along with flashing "s" pop up. The next day the check engine disappeared. I was some what happy and continue to drive car as normal for 2 days, then check engine light came back again and this time is staying for good. I just can't believed that 4 years old car is having this issue. I've owned so many cars prior to this 2020 Subaru Forester, never once that those cars have problems like this one. I feel that i'm at risk driving without no eyesight or collision prevention warning.. when the check engine comes on, those two things are disable. After a long research and reading about so many people with same issues, i feel that they should be a recalling to fix the thermal valve control.

Within one month the same thing happened. I turn on the car and the eyesight warning light is on (eyesight feature disabled), flashing "S" drive is on, "break" light is on, and check engine light is on. Due to this cruise control isn't working. My plan was to take it to a mechanic/dealership that Monday. By Monday morning, after about 15 minutes of driving, all warning signs disappeared. This exact thing happened a few weeks later (this morning). I started googling issues and seems like this is an issue for many customers and is just a malfunctioning Thermo Control Valve, no actual problem. What do I do about this? This is much less important - but also seems like a quality issue, at drivers side, the seat cover is starting to crack, looking like this is car is over 10 years old, we've had it for less than 4 years and this shouldn't be happening on a car of this caliber. Photos attached

I picked-up my new 2020 Subaru Forester on January 2, 2020. Within two years the battery became too weak to start the engine. Since then, I've had to repeatedly charge the battery. Now a battery maintainer is constantly connected to the battery. I've seen online reports that multiple late model Subarus have had battery issues, and that Subaru of America voluntarily replaced batteries and addressed related electrical issues for some of its customers. Subaru of America has all of my contact information, but I was never informed of their voluntary fix of the battery issue. Due to the fact that I wasn't contacted about the battery failure issue, do I now have any recourse? Many late model Subarus have an automatic engine stop/start feature. I've read reports of Subarus not restarting in traffic, I therefore do not feel safe driving my 2020 Subaru Forester. Why didn't this dangerous problem trigger an NHTSA recall?

The thermo valve leaked into connector, causing engine to shut down abruptly to prevent overheating. This happened at 70 mph on interstate highway in traffic. Part was replaced with modified thermo valve later. Barely able to coast to narrow shoulder flanked by deep ditch, with vehicle very close to interstate traffic, so much so that exit from vehicle ill-advised. After towing, vehicle was serviced by Subaru dealer. At time of part failure many warning lights & messages appeared, but not before the event.

The thermo control valve on vehicle failed on 2020 Subaru Forester which is causing vehicle to loose acceleration, multiple errors codes displaying on the vehicle instrument dash panel and no heat in the vehicle (see attached photo for reference). The failure of this device could cause a vehicle fire depending on what position/ and or state the thermo valve failed in. There needs to be a manufacturer recall on this particular part as there is numerous amounts of complaints and issues. Subaru needs to make it right with the customer. we need to drive safe vehicles on the road.

1-16-24:car wouldn’t open and start; jump-started by AAA to dealer; dealer kept overnight & checked battery: said charge held, ready to go home. 1-30-24, 4 pm-ish: able to start n drive, but check engine& eyesight warning light came on- late in day, so didn’t drive to dealer. 1-31-24: car dead; jump-started by AAA again & drove to dealer. On 2-1-24, dealer sends a video & says replaced battery, but check engine light & eye sight warning light still on; investigated further & found there was a lot of water that had pooled under the passenger seat & caused some corrosion- I.e.: shorted out electrical system. I asked dealer to report to Subaru since this seemed like a car defect. 2-9-24- dealer says Subaru won’t repair it at their expense and it’s a 25 hour job & will cost a lot. Dealer wanted me to file a claim with my insurance, but car was not driven through rain, high water, or stored in a flooded garage or on a flooded street. The water in the car seems like a design defect on the part of Subaru.

I started the car to make a trip to town to run some errands. When I cranked the engine the Check Engine light came on. The S for Sport Mode was flashing and a No Eyesight warning came on. Also SRS Side Airbag light came on to indicate it was not working. And another light came on showing a car going out of its lane, but I don't know if it was the Lane Keep Assist light or not.