WHILE DRIVING ON HIGHWAY THE VAN STARTED TO SHAKE WHILE APPLYING THE BRAKE AND THEN THERE WAS NO POWER AS THE GAS WAS PRESSED. THE GAS WAS TO THE FLOOR AND THE MAX SPEED WAS 50 MPH. THE MORE YOU DROVE THE WORST IT GOT. I AM ONLY TALKING DRIVING APPROXIMATELY 15-20 MILE. WHEN YOU FIRST START OUT IT IS NOT AS BAD, BUT IT IS ABSOLU…
Read full complaint
WHILE DRIVING ON HIGHWAY THE VAN STARTED TO SHAKE WHILE APPLYING THE BRAKE AND THEN THERE WAS NO POWER AS THE GAS WAS PRESSED. THE GAS WAS TO THE FLOOR AND THE MAX SPEED WAS 50 MPH. THE MORE YOU DROVE THE WORST IT GOT. I AM ONLY TALKING DRIVING APPROXIMATELY 15-20 MILE. WHEN YOU FIRST START OUT IT IS NOT AS BAD, BUT IT IS ABSOLUTELY NOT SAFE TO DRIVE NOR AM I WILLING TO DRIVE IT ANYMORE. I HAVE READ ARTICLES ON THIS AND IT CERTAINLY SEEMS LIKE A COMMON PROBLEM. LETS GET IT TOGETHER NISSAN!!!!! I REALLY WANT TO KNOW IF GOING IMPORT IS WORTH IT. I HAVE A 2001 GMC WITH OVER 175,000 WITH NO PROBLEMS. *TR
NHTSA ODI #10499833
75,000 miles · Jun 22, 2012
Service Brakes
TL* THE CONTACT OWNS A 2006 NISSAN QUEST. WHILE DRIVING APPROXIMATELY 55 MPH THE TRACTION CONTROL, ABS AND SLIP WARNING LIGHTS ILLUMINATED ON THE INSTRUMENT PANEL. THERE WAS ALSO A VIBRATION COMING FROM THE FRONT END OF THE VEHICLE. AFTER STOPPING AND RESTARTING THE VEHICLE, THE WARNING LIGHTS SHUT OFF. THE VEHICLE WAS TAKEN TO …
Read full complaint
TL* THE CONTACT OWNS A 2006 NISSAN QUEST. WHILE DRIVING APPROXIMATELY 55 MPH THE TRACTION CONTROL, ABS AND SLIP WARNING LIGHTS ILLUMINATED ON THE INSTRUMENT PANEL. THERE WAS ALSO A VIBRATION COMING FROM THE FRONT END OF THE VEHICLE. AFTER STOPPING AND RESTARTING THE VEHICLE, THE WARNING LIGHTS SHUT OFF. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC FOR DIAGNOSTICS. THE MECHANIC STATED THAT THE ACTUATOR PUMP WOULD HAVE TO BE REPLACED. THE VEHICLE WAS NOT REPAIRED. THE APPROXIMATE FAILURE MILEAGE WAS 75,000.
ON CERTAIN MINI VANS, THERE IS A SEAT ADJUSTMENT MECHANISM THAT CONTAINS EXPOSED MOVING COMPONENTS LOCATED AT THE REAR INSIDE EDGE OF THE SECOND ROW SEAT.
Consequence & remedy
Consequence: WHEN THE OPERATOR ATTEMPTS SEAT ADJUSTMENT, A FINGER MAY BE PINCHED IN THE MOVING SEAT ADJUSTMENT MECHANISM WHICH COULD CAUSE AN INJURY.
Remedy: ON EARLIER MODEL VEHICLES BUILT THROUGH JUNE 28, 2004, DEALERS WILL REPLACE THE INBOARD SECOND ROW SEAT ADJUSTMENT HANDLE, RIVET A PLASTIC REINFORCEMENT TO BACKSIDE OF THE EXISTING SEAT BACK COVER CARPETING, INSTALL TIE-DOWNS AND A FLANGE TO THE INBOARD SIDE SHIELD. ON VEHICLES PRODUCED FROM JUNE 29, 2004 THROUGH SEPTEMBER 26, 2005, DEALERS WILL RIVET A PLASTIC REINFORCEMENT TO THE BACKSIDE OF THE EXISTING SEAT BACK COVER CARPETING, INSTALL TIE-DOWNS AND A FLANGE ON THE INBOARD SIDE SHIELD. THE RECALL BEGAN ON DECEMBER 19, 2005. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0
No exact-year investigations in this snapshot.
2006 Nissan Quest Problems, Complaints & Recalls | Skip That Year
Illustration