2018 Mazda MAZDA6

Have had 3 seats replaced under warranty by Graco and was told to make a report with you. The rigid latch anchors on two have been faulty after 2 months. The second one got stuck in the installed base and pulling the release button did nothing. The rigid latch on the first got stuck in the open position. The second they would move independently of each other and not lock in. The third is starting to have the same issue with getting stuck in the base. These have all happened within two months of normal use.

The car only has 70k miles on it. The engine started smoking under the hood. Immediately stopped to look. There was oil leaking but I could not see from where. I took it across the street to the Toyota dealership and had them look at it. They explained to me that there was a crack in the cylinder head and oil was leaking everywhere. Potentially causing a fire or even an explosion. The old was leaking all over the exhaust manifold and engine. I had my 2 toddlers in the car not long before this happened. This is extremely unacceptable. Currently Mazda is saying it will be 7200 to replace the engine and that cost is on me. I think that is absolutely absurd being there are only 70k miles on the car and I bought it brand new. I also kept up with all of the required maintenance.

Got error message that said "Forward Smart City Brake Support Malfunction" slso fot "smart brake malfunction" while driving. The ac stopped, the car speedometer kept going from 50 to zero. The car died and couldn't open doors, windows. Lost steering while driving. We were able to get off road and restart and fine for 2 weeks. While at still light tonight, the car turned off. Windows were up, couldn't open door, emergency blinkers would not come on. This is very dangerous.

My cylinder head is leaking coolant. There is a well known and well documented issue with these cylinder heads cracking due to poor casting. This has become such a big issue that Mazda has even recalled the cylinder heads, BUT, only if the engine is equipped with Turbo. However, this issue is becoming enormous even for non turbo owners and is a huge safety issue as it can lead to overheating, stalling, and further damage to other components. I feel very strongly that it is time for Mazda to take some responsibility and extend the cylinder head recall to the non turbo engines.

System Failure: The Power Train (6-speed Automatic Transmission) suffered a major malfunction, documented by diagnostic codes P0731 (Gear 1 Incorrect Ratio) and P0780 (Shift Error). The vehicle is available for inspection. Safety Risk: The failure caused a sudden loss of propulsion while attempting to accelerate. This created an immediate risk of a rear-end collision and left the vehicle unresponsive in the path of oncoming traffic. The transmission's unpredictable shifting makes the vehicle unsafe to operate. Confirmation: The failure and the P0731 code were officially confirmed by Castle Mazda on March 2, 2026. The manufacturer (Mazda) has been notified but has denied a remedy, despite TSB MC-10160555-0001 addressing this specific internal defect. Warning Symptoms: There was no Check Engine Light or dashboard warning prior to or during the failure. The only warning was an extreme, abnormal mechanical grinding/clunking noise from the transmission. The lack of a malfunction indicator light (MIL) meant I had no electronic warning of a looming mechanical failure while in motion.

Per Mazda inspection, the back side of cylinder head #3 has an oil leak which is leaking onto the exhaust manifold. This creates a direct fire hazard as Mazda said they highly recommend not driving it for that reason. The Mazda dealership inspected and confirmed the issue, it in February 2026, with only 74,000 miles on the vehicle.

I recently discovered a significant oil leak near the exhaust manifold of my 2018 Mazda 6 (2.5L NA), which has resulted in visible smoke and a burning oil odor. Upon taking the vehicle to the nearest Mazda dealership for a diagnosis, the service department informed me that the vehicle has suffered a cracked cylinder head. An active oil drip is visible behind the engine near the exhaust manifold immediately upon starting the car; consequently, the engine is leaking oil directly onto the exhaust components. This condition not only renders the vehicle inoperable but also presents a significant safety and fire hazard. At the time of this writing, my vehicle has only 46,996 miles and has been meticulously maintained. This mileage is well under the 60,000-mile powertrain threshold and represents a premature failure of a major internal engine component. There are numerous reports on Mazda owner forums describing this identical issue occurring in Mazda 6, CX-5, and CX-9 models. Some owners have even reported instances of minor fires or active burning under the hood due to oil contacting hot engine components. Mazda released Technical Service Bulletin TSB #MC-10241612-0001 (SA-037-23), which includes a redesigned cylinder head for 2018–2020 Mazda 6, 2019 CX-5, and 2016–2020 CX-9 models, demonstrating Mazda’s awareness of this design flaw. While the TSB currently only specifies the 2.5L Turbo engines and not the naturally aspirated variants, there is substantial evidence that this is a widespread defect across these model years, unrelated to owner misuse or vehicle mileage. Mazda should take full responsibility by issuing a formal recall or providing an extended warranty to cover naturally aspirated engines, thereby addressing this problem and preventing further safety risks.