2018 Mazda MAZDA3

The contact owns a 2018 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated that while her son was driving at an undisclosed speed, the back over prevention camera was flickering and distorted. The vehicle was taken to the dealer on two occasions. The dealer was made aware of the failure but confirmed that parts were not yet available. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 80,000. VIN tool confirms parts not available.

The contact owns a 2018 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention). The local dealer was made aware of the issue and an appointment was scheduled to have the vehicle serviced. The contact arrived for the appointment but was informed a few hours later that parts for the recall repair were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2018 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact stated while driving 40 MPH, the parking brake light illuminated, and the vehicle decelerated and was losing motive power. The contact pressed the parking brake button off and on and the warning light stopped, and the contact was able to drive normally. Additionally, the contact stated that in other instances the forward sensing camera and the lane departure systems were also independently engaging. The contact stated that it was difficult to maintain the lane she was driving in. The contact stated that several unknown warning lights were illuminated. The contact stated that the failure occurred at various speeds. The contact drove the vehicle to a dealer who diagnosed the vehicle and flashed the Powertrain Control Module (PCM). The vehicle was repaired. The contact stated that the failures reoccurred and the battery short-circuited. The contact had taken the vehicle to a non-manufacturer dealer who used a handheld scanner and retrieved the following codes: C1001 Type 97, U3003, and B13D3. The vehicle was not repaired. The failure mileage was 31,321. VIN tool confirms parts not available.

I took my vehicle into RBMC dealership due to the vehicle was experiencing electrical issues and had an open recall / still does. The dealership said I can’t have a dash cam plugged in to a charging port. FCM / LDW / E-Break staying on / throwing error codes = C1001 FSC failure type 97 & U3003 EPB control module power supply failure type 16. They gave me back the car the battery failed the next day and when I called them they banned the VIN of this car to ever return to them. ( the battery was under factory warranty) the issue has only gotten worse and removed my dash cam as they demanded and now I can’t get the car fixed and the issue has gotten worse then taking the car to this dealership less then 30 days ago. They also did not perform the recall when the car was there. The car now has the fallowing codes B13D3 / C1001 / U3003 & possibly more codes because the whole dash is flashing auto light / fcm/ LDW and Break. My [XXX] grandma can’t even take the car in to get fixed the refuse to touch it after it had issues when they gave it back to us and it’s under a extended warranty and was a CPO and has a extended warranty through Mazda. Car only has 31k miles on it and is dangerous for her to drive and myself. Issue has been on going for over a month. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The contact owns a 2018 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was not contacted due to the local dealer going out of business. The manufacturer was made aware of the issue and informed the contact that a second notice would be mailed when the part to do the recall repair was available. The contact had not experienced a failure. VIN tool confirms parts not available.

I’m getting water in my trunk. Dealership replaced left tail light and both lights on the right. The left is dry and the right is soaked again. At least a gallon of water sitting where spare tire is. I’m seeing many other Mazda owners are having the same issue online. This should be a recall. If the water issue doesn’t get fixed it will lead to rusting and mold. My spare tire already is showing rusting.

There is a known issue with the infotainment system referred to as ghost tough. This causes the system to randomly change stations/songs, etc while the car is in motion. There is also a delamination issue. Mazda issued a recall for 2014-2016 vehicles, however a quick internet search shows that this issue continues to be a problem. This issue can be extremely distracting as the driver attempts to stop the system from changing.

This is in reference to the recall for the rear view camera on 7/14/2023 Manufacturer Recall Number6023G NHTSA Recall Number23V-487 Mazda has still NOT come up with an adequate remedy solution. The dealerships continue to state that they do not have the parts to replace it even though this recall was made 8 months ago. This is unacceptable as the rear view camera is an essential safety mechanism. If Mazda is unable to repair this defect, drivers should be allowed to get it repaired at other more component repair shops and be reimbursed.

The review camera for my vehicle has been unreliable since 2022, if not longer, despite being fully replaced at no cost by the dealer once while still under warrantee. I received a recall notification regarding this issue via mail in September 2023 (recall no. 60232G, NHTSA campaign no. 23V-487), but later learned the recall was initiated two months prior, in mid-July 2023. Since then, my review camera has continued to malfunction with increasing frequency and severity. Some days it doesn't work at all (screen completely black), some days it works for a few seconds at a time but otherwise does not, and some days it works but only poorly (grainy or scrolling video feed with poor visibility). It has now been more than 7 months since this recall was issued, and the status is still "recall incomplete, remedy not yet available." This is an essential safety feature, and the continued lack of action on Mazda's part is unacceptable.