If any liquid or debris material enters the console cover area where many controls for the car are located, the “command switch” (as described by the Mazda dealer) underneath is destroyed. Many items are affected as noted above (some of which I could not check off). They have not responded as to whether some type of shield or ev…
Read full complaint
If any liquid or debris material enters the console cover area where many controls for the car are located, the “command switch” (as described by the Mazda dealer) underneath is destroyed. Many items are affected as noted above (some of which I could not check off). They have not responded as to whether some type of shield or even tape could be used to prevent this fault.
NHTSA ODI #11566562
Mileage unknown · Dec 21, 2023
Electrical SystemExterior Lighting
After installing Mazda Genuine Accessory 4-pin trailer wiring harness (P/N VA40-V7-780A), and Mazda’s trailer hitch as well, found that the wiring does not operate correctly. When the turn signal or hazard lamps are activated while the brake is applied, the trailer lamps will operate erratically, flashing faster for a few cycles…
Read full complaint
After installing Mazda Genuine Accessory 4-pin trailer wiring harness (P/N VA40-V7-780A), and Mazda’s trailer hitch as well, found that the wiring does not operate correctly. When the turn signal or hazard lamps are activated while the brake is applied, the trailer lamps will operate erratically, flashing faster for a few cycles, then return to a normal flash rate before the erratic behavior repeats. The Mazda’s lamps operate normally. This has occurred with two different trailers, one with incandescent and one with LED lamps. To verify that the concern wasn’t with the trailers, a small trailer-side harness was made that used a floating ground, and with either incandescent or LED stop/tail/turn lamps plugged into it the concern was the same. Dealership verified the concern and verified correct installation of the vehicle harness. They were able to replicate the concern on another CX-50 as well. They reached out to Mazda’s technical assistance, but have not been advised of a repair. This was several months ago. Mazda’s customer service was of no help. May not be compliant with FMVSS No. 108, S14.9.3.5.3, S14.9.3.9.3, and Figure 2. Concerned that this may increase the risk of another vehicle striking a trailer attached to the Mazda. The vehicle is available for inspection upon request.
Mazda North American Operations (Mazda) is recalling certain 2022-2023 CX-30 and 2023 CX-50 vehicles. The anti-lock brake system (ABS) Hydraulic Control Unit (HCU) may be damaged, which can result in reduced braking ability.
Consequence & remedy
Consequence: Reduced braking ability can increase the distance required to stop the vehicle, increasing the risk of a crash.
Remedy: Dealers will inspect and replace the ABS HCU, as necessary, free of charge. Owner notification letters were mailed June 12, 2023. Owners may contact Mazda customer service at 1-800-222-5500 Option 6. Mazda's number for this recall is 5823D.
Mazda North America Operations (Mazda) is recalling certain 2023 CX-50 vehicles equipped with a Mazda Genuine Accessory trailer hitch. The trailer hitch harness may detach and become damaged, which can result in inoperative trailer lights and/or brakes.
Consequence & remedy
Consequence: Towing a trailer with inoperative lights or brakes can increase the risk of a crash.
Remedy: Dealers will repair the trailer hitch harness, free of charge. Owner notification letters were mailed April 11, 2023. Owners may contact Mazda customer service at 1-800-222-5500 option 6. Mazda's number for this recall is 5723B.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0
No exact-year investigations in this snapshot.
2023 Mazda CX-50 Problems, Complaints & Recalls | Skip That Year
Illustration