2020 Jeep Gladiator

The contact owns a 2020 Jeep Gladiator. The contact stated that the instrument panel failed to illuminate or display the mileage, fuel level, and other information necessary to the operation of the vehicle. The contact stated that when the sun visor was down to block the sun and the vehicle was driven over uneven pavement, the sun visor occasionally slightly detached and blocked the view of the driver. The vehicle was taken to the dealer, who determined that the instrument panel needed to be replaced. The dealer confirmed that the failure was related to NHTSA Campaign Number: 24V652000 (Electrical System); however, the VIN was not included. The vehicle was not repaired. The manufacturer was not informed of the failure. The failure mileage was unknown.

The instrument cluster is not working. The 3.5” display is no longer functioning. This results in not knowing the oil pressure gauge, fuel gauge, odometer reading, temp gauge, and other warning/information gauges, etc. This issue has been confirmed but a service center, repair order attached. There was no warning to indicate a problem. The cluster just quick working.

My vehicle has a 3.6 pentastar engine. Around 60000 miles the engine developed a noticeable tick. Now the engine has multiple cylinder misfires, is leaking oil all over the engine compartment and causing issues with other electronic components (wheel speed sensors, power steering, electronic shifting, brake lights) Upon research I found this is to be a known issue with this motor. There apparently have been some associated recalls but I couldn’t find them. There are class action lawsuits as well

The contact owns a 2020 Jeep Gladiator. The contact stated that while driving at approximately 40 MPH, the vehicle had suddenly started to vibrate and shake. The contact stated that the vehicle was maintaining its lane but was lurching from left to right. No warnings illuminated. The contact stated that she pulled off to the side of the road; however, when she turned the vehicle on, it would start shaking again. The contact stated that she would keep driving while the vehicle was shaking, and the shaking would eventually stop. The contact stated that the shaking was occurring at any speed and was also triggered when she would drive over any small bumps or dips in the road. The contact stated recently, while she was driving in traffic at approximately 10 MPH, the vehicle started to shake again, however, this time violently. The contact stated that at the time, it was raining. The contact stated that it felt like the vehicle had lifted up, and then she crashed into the guard rail on the driver's side front bumper. The contact stated that the bumper and an LED light bar attached to the front grill had made contact and were slightly damaged, and the driver's side headlight stopped functioning. The police were not called, and the contact was not injured. The contact reported that the driver's side front air bag had deployed but had not inflated and was draped on her lap. The contact had not taken the vehicle to a local dealer or independent mechanic. The vehicle was not diagnosed and was not repaired. The contact reported that after the crash, she observed the check oil and check brake warnings illuminated. The contact stated that she needed to depress the brake pedal with more force in order to stop. The manufacturer was not informed of the failure. The failure mileage was approximately 109,000.

IPC instrument panel cluster flashing for about a week then went blank total black out could not read important data to operate the car example check engine light gas speedometer tire inflation all safety on operating vehicle not to mention tbe blinking on and off dir a week ir so distracting you from driving the vehicle or worrying if you had gas ir tire pressure or set controls for your vehicle . The jeep mopar site says ipc malfunctioning , drive shaft malfunctioning as well as 1 other recall . I even called the dealer . This is very unsafe .