EXHAUST MANIFOLD CRACKS, CAUSING HOT EXHAUST GASES AND POSSIBLE UNBURNED FUEL TO LEAK. *AK
2000 Honda Civic
Owner reports · Recalls · Investigations
Similar to other model years
Owner complaints for the 2000 Honda Civic do not stand out strongly from the model-year median of 183.5.
About this comparison →How this year compares
Owner complaints by model year
Compare all Civic years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
114 reports with mileage · 173 unknown
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Air Bags. Review the 82 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Engine And Engine Cooling. Review the 47 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Electrical System. Review the 38 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
What owners actually said
287 reportsFRONT END COLLIDED WITH ANOTHER CAR THEN HEAD FIRST INTO A CONCRETE BARRIER WITH ENOUGH FORCE TO CRUSH FRONT END AND MAKE THE CAR MOVE UP THE BARRIER. UPON IMPACT, AIR BAGS FAILED TO DEPLOY. *AK
TIRE BLEW WITH TREMENDOUS FORCE WHILE DRIVING ON FREEWAY, CAUSING THE CV BOOT TO BREAK, FIRESTONE DEALER EXAMINED THE TIRE AND STATED IT WAS DUE TO ROAD HAZARD, CONSUMER STATED THERE US A TINY HOLE THAT COULD BE A NAIL HOLE, BUT IS DOUBTFUL THAT IS WHAT CAUSED THE TIRE BLOW OUT,(FIRESTONE TIRES- TIRE SIZE P185/R14.*JB
NOISE FROM TRANSMISSION AREA. NOISE WHEN GAS PEDAL IS RELEASED, IN GEARS 5,4,3, AND MAYBE 2 &1 BUT RPM'S TOO HIGH TO HEAR. HAPPENS ONLY IN GEAR AND ONLY WHEN THE CLUTCH IS ENGAGED. LOCAL DEALER, STEVENS CREEK HONDA HAVE REPLACED THROW-OUT BEARING & GEAR BEARINGS WITH NO RELIEF.*AK
ORIGINAL TIRES ON A HONDA, CIVIC 2000, 185/65R14 855S, FR680 MF WHILE TRAVELING ON HIGHWAY RIGHT REAR TIRE BLEWOUT, TREAD CAME COMPLETELY OFF, AND THERE WERE NO SIDEWALLS.*AK *SLC
THE REAR SUB-FRAME ON MY 2000 HONDA CIVIC SI HAS RIPPED ON BOTH SIDES. THIS IS NOT JUST A PROBLEM I AM HAVING. I KNOW OF SEVERAL OTHER PEOPLE HAVING THIS VERY SAME PROBLEM. I DO NOT RACE THE CAR AND ALL OF THE DRIVING IS DONE ON ROAD. ASIDE FROM AN AFTERMARKET CLUTCH THE VEHICLE IS STOCK, NO SUSPENSION WORK AT ALL. THE CAR …
Read full complaint
THE REAR SUB-FRAME ON MY 2000 HONDA CIVIC SI HAS RIPPED ON BOTH SIDES. THIS IS NOT JUST A PROBLEM I AM HAVING. I KNOW OF SEVERAL OTHER PEOPLE HAVING THIS VERY SAME PROBLEM. I DO NOT RACE THE CAR AND ALL OF THE DRIVING IS DONE ON ROAD. ASIDE FROM AN AFTERMARKET CLUTCH THE VEHICLE IS STOCK, NO SUSPENSION WORK AT ALL. THE CAR COMES WITH A 13MM REAR SWAY BAR AS STOCK EQUIPMENT. WHEN I BEGAN HEARING ABOUT PEOPLE HAVING PROBLEMS WITH THE SUB FRAME RIPPING I PURCHASED REINFORCEMENT PLATES AND INSTALLED THEM IN AN EFFORT TO REDUCE THE STRESS PLACED ON THE SUB-FRAME. THIS IS A MAJOR PROBLEM! THIS IS STRUCTURAL FAILURE! AS SOON AS I NOTICED THE PROBLEM I TOOK THE CAR TO A FRAME SHOP AND HAD IT REPAIRED AT A COST OF $500. THE TECHNICAN WHO FIXED THE VEHICLE TOLD ME HE HOPED THIS WOULDN'T HAPPEN AGAIN BUT WITHOUT A STRONGER SUB FRAME HE SAW NO REASON THAT THIS WOULDN'T HAPPEN AGAIN. THIS OBVIOUSLY PRESENTS A SERIOUS SAFETY ISSUE.
ON JUNE 30,2001 MY DAUGHTER JENNIFER WAS IN A CAR ACCIDENT. JENNY WAS STOPPED AT A RED LIGHT WHILE WAITING FOR THE LIGHT TO CHANGE OUR HONDA CIVIC 2000, WAS REAR ENDED. THE CIVIC WAS PUSHED INTO THE CAR IN FRONT.THE CIVIC HAS DAMAGE TO THE FRONT AND REAR ENDS OF THE CAR. THE 2000 HONDA WAS TOTALED,THE AIRBAGS NEVER DEPLOYED.I WO…
Read full complaint
ON JUNE 30,2001 MY DAUGHTER JENNIFER WAS IN A CAR ACCIDENT. JENNY WAS STOPPED AT A RED LIGHT WHILE WAITING FOR THE LIGHT TO CHANGE OUR HONDA CIVIC 2000, WAS REAR ENDED. THE CIVIC WAS PUSHED INTO THE CAR IN FRONT.THE CIVIC HAS DAMAGE TO THE FRONT AND REAR ENDS OF THE CAR. THE 2000 HONDA WAS TOTALED,THE AIRBAGS NEVER DEPLOYED.I WOULD LIKE TO KNOWN WHY THE AIRBAGS DID NOT GO OFF. *AK
THE RACK AND PINION DEVELOPED A LEAK WHICH CAUSED A LOUD NOISE WHEN TURNING THE WHEEL, THE VEHICLE HAS BEEN AT THE DEALER FOR 27 DAYS BUT HAS NOT BEEN REPAIRED BECAUSE THE PART IS ON BACK ORDER, THE CONSUMER IS REQUESTING REIMBURSEMENT. NLM
NO SUMMARY LISTED FOR ABOVE VEHICLE. *AK
THE ANTENNA DOES NOT SLIDE DOWN INTO THE VEHICLE AS STATED AT THE HONDA DEALERSHIP, DUE TO THIS PROBLEM THE ANTENNA BROKE OFF DURING CAR WASHING. *YH
Official recalls
620V026000 · Air Bags:frontal:driver Side:inflator Module
Jan 17, 2020
Honda (American Honda Motor Co.) is recalling certain 1998 Acura 2.2CL, 1998-1999 Acura 2.3CL, 1998-1999 Acura 3.0CL, 2001 Acura 3.2CL and Acura MDX, 1998-2000 Honda Accord Coupe, Accord Sedan, Civic Sedan, Odyssey and Acura 3.5RL, 1999-2000 Acura 3.2TL, 1996-2000 Civic Coupe, 1997-2000 CR-V, 1997-1998 EV Plus, and 1998-1999 Isuzu Oasis vehicles. These vehicles were equipped with Non-Azide Driver air bag Inflators (NADI) and do not contain phase stabilized ammonium nitrate (PSAN) propellant. Due to a manufacturing issue, the NADI inflators may absorb moisture, causing the inflators to rupture or the air bag cushion to underinflate.
Consequence & remedy
Consequence: In the event of a crash necessitating air bag deployment, an inflator rupture may result in metal fragments striking the driver or other occupants. An underinflated air bag cushion may not properly protect the occupant. These scenarios increase the risk of serious injury or death.
Remedy: Honda will notify owners, and dealers will inspect the driver frontal air bag inflator, and replace it if necessary, with an inflator of a different design, free of charge. The recall began October 1, 2020. Owners may contact American Honda's Customer Support & Campaign Center at 1-888-234-2138 or Isuzu customer service at 1-800-255-6727.
20V027000 · Air Bags:frontal:driver Side:inflator Module
Jan 17, 2020
Honda (American Honda Motor Co.) is recalling certain 2001-2002 Acura 3.2CL, 2000-2003 Acura 3.5RL, 2000-2001 Acura 3.2TL, Honda CR-V and Honda Odyssey, 2001-2002 Acura MDX and 2000 Accord Coupe, Accord Sedan, Civic Coupe, and Civic Sedan vehicles. These vehicles may have received a replacement driver frontal air bag module as part of a vehicle repair. Due to a manufacturing issue, the replacement NADI inflator may absorb moisture, causing the inflator to rupture or the air bag cushion to underinflate.
Consequence & remedy
Consequence: In the event of a crash necessitating air bag deployment, an inflator rupture may result in metal fragments striking the driver or other occupants. An underinflated air bag cushion may not properly protect the occupant. These scenarios increase the risk of serious injury or death.
Remedy: Honda will notify owners, and dealers will inspect the air bags in the vehicles, replacing the driver frontal air bag inflator with an inflator of a different design, as necessary, free of charge. The recall began October 1, 2020. Owners may contact American Honda's Customer Support & Campaign Center at 1-888-234-2138.
07V512000 · Fuel System, Other:storage:tank Assembly
Nov 1, 2007
ON CERTAIN COMPRESSED NATURAL GAS (CNG) VEHICLES, IN THE EVENT OF A SEVERE INTERIOR FIRE IN THE AREA OF THE REAR SEAT, THE CNG TANK MAY BE HEATED UNEVENLY, PREVENTING THE PRESSURE RELIEF DEVICE FROM VENTING THE CONTENTS OF THE TANK AS DESIGNED.
Consequence & remedy
Consequence: THIS COULD RESULT IN A TANK RUPTURE, EXPLOSION, AND EJECTION OF THE TANK FROM THE VEHICLE.
Remedy: DEALERS WILL INSTALL A HEAT INSULATOR MATERIAL TO THE REAR SEAT BACK. AN INTERIM OWNER LETTER WAS MAILED TO OWNERS BEGINNING NOVEMBER 26, 2007. WHEN PARTS ARE AVAILABLE, OWNERS WILL BE RENOTIFIED ASKING THEM TO BRING IN THEIR VEHICLE FOR REPAIR. OWNERS MAY CONTACT HONDA AT 1-800-999-1009.
02V120000 · Electrical System:ignition:switch
May 16, 2002
ON CERTAIN SEDANS, COUPES, HATCHBACKS, AND SPORT UTILITY VEHICLES, ELECTRICAL CONTACTS IN THE IGNITION SWITCH CAN DEGRADE DUE TO THE HIGH ELECTRICAL CURRENT PASSING THROUGH THE SWITCH WHEN THE VEHICLE IS STARTED.
Consequence & remedy
Consequence: WORN CONTACTS COULD CAUSE THE ENGINE TO STALL WITHOUT WARNING, INCREASING THE RISK OF A CRASH.
Remedy: DEALERS WILL REPLACE THE IGNITION SWITCH. OWNER NOTIFICATION BEGAN JUNE 14, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT HONDA AT 1-800-999-1009 OR ACURA AT 1-800-382-2238.
02V051000 · Seat Belts:front:buckle Assembly
Feb 8, 2002
CERTAIN SEDANS AND COUPES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES." CERTAIN REAR SEAT BELT BUCKLES WERE IMPROPERLY MANUFACTURED.
Consequence & remedy
Consequence: THE REAR SEAT BELTS WILL WORK PROPERLY AND PROVIDE PROTECTION IN A CRASH, BUT THE OWNER MAY EXPERIENCE DIFFICULTY UNFASTENING THE BELT AFTER THE CRASH.
Remedy: IN A PREVIOUS RECALL (01V-380), ONLY RIGHT AND LEFT BUCKLES WERE INSPECTED. THE REAR CENTER BUCKLE SHOULD ALSO BE INSPECTED AND CORRECTED IF NECESSARY. THIS RECALL IS BEING CONDUCTED ONLY FOR THE CENTER BUCKLE. DEALERS WILL INSPECT THE VEHICLES AND REPLACE THE SEAT BELT ASSEMBLIES THAT WERE IMRPOPERLY MANUFACTURED. ONLY BUCKLES THAT ARE MARKED (ON THE BACK SIDE OF THE BUCKLE) WITH AN ASSEMBLY NUMBER BEGINNING WITH 00185, 00186, OR 00187, WILL BE REPLACED. OWNERS SHOULD CONTACT THEIR DEALER FOR THIS REPLACEMENT. OWNER NOTIFICATION BEGAN MARCH 5, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT HONDA AT 1-800-999-1009.
01V380000 · Seat Belts:front:buckle Assembly
Dec 13, 2001
VEHICLE DESCRIPTION: CERTAIN SEDANS AND COUPES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES." CERTAIN REAR SEAT BELT BUCKLES WERE IMPROPERLY MANUFACTURED.
Consequence & remedy
Consequence: THE REAR SEAT BELTS WILL WORK PROPERLY AND PROVIDE PROTECTION IN A CRASH, BUT THE OWNER MAY EXPERIENCE DIFFICULTY UNFASTENING THE BELT AFTER THE CRASH.
Remedy: DEALERS WILL INSPECT THE VEHICLES AND REPLACE THE SEAT BELT ASSEMBLIES THAT WERE IMPROPERLY MANUFACTURED. ONLY BUCKLES THAT ARE MARKED (ON THE BACK SIDE OF THE BUCKLE) WITH AN ASSEMBLY NUMBER BEGINNING WITH 00185, 00186, OR 00187, WILL BE REPLACED. OWNERS SHOULD CONTACT THEIR DEALER FOR THIS REPLACEMENT. OWNER NOTIFICATION BEGAN JANUARY 22, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT HONDA AT 1-800-999-1009.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0No exact-year investigations in this snapshot.
Illustration