THE SUPPORT ROD FOR THE HOOD IS APPROXIMATELY 1 FT. IN LENGTH, AND IS LOCATED APPROXIMATELY ONE FOOT FROM THE HOOD HINGE. THE SUPPORT ROD ALSO CONTAINS A MANUFACTURED BEND IN THE CENTER THAT IS MEANT TO FOLD UNDER PRESSURE. IT FAILED. SLIGHT PRESSURE WAS APPLIED TO THE HOOD WHILE IN THE RAISED POSITION BETWEEN 1.5 AND 3.5 INCHES…
Read full complaint
THE SUPPORT ROD FOR THE HOOD IS APPROXIMATELY 1 FT. IN LENGTH, AND IS LOCATED APPROXIMATELY ONE FOOT FROM THE HOOD HINGE. THE SUPPORT ROD ALSO CONTAINS A MANUFACTURED BEND IN THE CENTER THAT IS MEANT TO FOLD UNDER PRESSURE. IT FAILED. SLIGHT PRESSURE WAS APPLIED TO THE HOOD WHILE IN THE RAISED POSITION BETWEEN 1.5 AND 3.5 INCHES . THE HOOD BENT ON THE ROD. THERE WAS NO EXTRA REINFORCEMENT IN THE MANUFACTURED PLACEMENT AREA PROVIDED FOR THE ROD. THE DAMAGE IS MINIMAL.....ONLY A 1/4 INCH DIMPLE IN THE HOOD, BUT THE HOOD IS SO THIN THAT THE ONLY MANUFACTURER RECOMMENDED REPAIR IS COMPLETE REPLACEMENT OF THE HOOD. I FEEL THAT THIS IS A DEFINITE DESIGN FLAW; THE ENTIRE WEIGHT OF THE HOOD PIVOTS ON THE ROD AT ONLY ONE FOOT IN DISTANCE FROM THE FULCRUM(HINGE). PHYSICALLY IT IS A CERTAINTY THAT DAMAGE IS INEVITABLE.
NHTSA ODI #715235
Mileage unknown · Oct 27, 1999
Structure
ON-GOING / INTERMITTENT PROBLEM OF ELECTRICAL SHORTS / STATISTIC ELECTRICITY RECEIVED FROM EITHER SIDE OF THE DOORS; DEALER NOTIFIED AND INFORMED THAT NOTHING COULD BE DONE. UNLESS CONSUMER IS WILLING TO PAY FOR ELECTRICAL DIAGNOSTIC OR REWIRING. *AK
NHTSA ODI #852046
Mileage unknown · Sep 8, 1999
Structure
CONSUMER GOT INTO ACCIDENT, CLAIMS THAT 2/3 OF THE DAMAGE COULD HAVE BEEN PREVENTED IF THE BUMPERS WERE MADE OUT OF A MORE CRUSH RESISTANT MATERIAL.
NHTSA ODI #609665
Mileage unknown · Sep 8, 1999
Structure
TRUNK LID WON'T STAY OPEN.
NHTSA ODI #609509
Mileage unknown · Feb 1, 1999
Structure
BUMPER FAILED. YH
NHTSA ODI #9292
Mileage unknown · Feb 1, 1999
Structure
REAR PASSENGER DOOR HANDLE GETS LOOSE EVEN AFTER REPAIR. YH
NHTSA ODI #608801
Mileage unknown · Feb 1, 1999
Structure
FAULTY HEAT SHIELD ON THE EXHAUST SYSTEM. *YC
NHTSA ODI #608172
Mileage unknown · Feb 1, 1999
Structure
FABRIC ON LEFT AND RIGHT DOOR PANEL WORN EXCESSIVELY.
NHTSA ODI #608160
Mileage unknown · Dec 29, 1998
StructureInjury
TRUNK LIFT SPRINGS ARE TOTALLY INEFFECTIVE AND ALLOW TRUNK LID TO DROP SUDDENLY STRIKING ANY PERSON OR OBJECT IN ITS PATH
NHTSA ODI #701707
Mileage unknown · Dec 10, 1998
Power TrainStructureSuspension
SUSPENSION VERY POOR CAUSING DRIFTING AND POOR STABILITY.
Honda (American Honda Motor Co.) is recalling certain 1998 Acura 2.2CL, 1998-1999 Acura 2.3CL, 1998-1999 Acura 3.0CL, 2001 Acura 3.2CL and Acura MDX, 1998-2000 Honda Accord Coupe, Accord Sedan, Civic Sedan, Odyssey and Acura 3.5RL, 1999-2000 Acura 3.2TL, 1996-2000 Civic Coupe, 1997-2000 CR-V, 1997-1998 EV Plus, and 1998-1999 Isuzu Oasis vehicles. These vehicles were equipped with Non-Azide Driver air bag Inflators (NADI) and do not contain phase stabilized ammonium nitrate (PSAN) propellant. Due to a manufacturing issue, the NADI inflators may absorb moisture, causing the inflators to rupture or the air bag cushion to underinflate.
Consequence & remedy
Consequence: In the event of a crash necessitating air bag deployment, an inflator rupture may result in metal fragments striking the driver or other occupants. An underinflated air bag cushion may not properly protect the occupant. These scenarios increase the risk of serious injury or death.
Remedy: Honda will notify owners, and dealers will inspect the driver frontal air bag inflator, and replace it if necessary, with an inflator of a different design, free of charge. The recall began October 1, 2020. Owners may contact American Honda's Customer Support & Campaign Center at 1-888-234-2138 or Isuzu customer service at 1-800-255-6727.
ON CERTAIN COMPRESSED NATURAL GAS (CNG) VEHICLES, IN THE EVENT OF A SEVERE INTERIOR FIRE IN THE AREA OF THE REAR SEAT, THE CNG TANK MAY BE HEATED UNEVENLY, PREVENTING THE PRESSURE RELIEF DEVICE FROM VENTING THE CONTENTS OF THE TANK AS DESIGNED.
Consequence & remedy
Consequence: THIS COULD RESULT IN A TANK RUPTURE, EXPLOSION, AND EJECTION OF THE TANK FROM THE VEHICLE.
Remedy: DEALERS WILL INSTALL A HEAT INSULATOR MATERIAL TO THE REAR SEAT BACK. AN INTERIM OWNER LETTER WAS MAILED TO OWNERS BEGINNING NOVEMBER 26, 2007. WHEN PARTS ARE AVAILABLE, OWNERS WILL BE RENOTIFIED ASKING THEM TO BRING IN THEIR VEHICLE FOR REPAIR. OWNERS MAY CONTACT HONDA AT 1-800-999-1009.
ON CERTAIN SEDANS, COUPES, HATCHBACKS, AND SPORT UTILITY VEHICLES, ELECTRICAL CONTACTS IN THE IGNITION SWITCH CAN DEGRADE DUE TO THE HIGH ELECTRICAL CURRENT PASSING THROUGH THE SWITCH WHEN THE VEHICLE IS STARTED.
Consequence & remedy
Consequence: WORN CONTACTS COULD CAUSE THE ENGINE TO STALL WITHOUT WARNING, INCREASING THE RISK OF A CRASH.
Remedy: DEALERS WILL REPLACE THE IGNITION SWITCH. OWNER NOTIFICATION BEGAN JUNE 14, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT HONDA AT 1-800-999-1009 OR ACURA AT 1-800-382-2238.
VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE FRONT PASSENGER AIR BAG MODULES HAVE BEEN IMPROPERLY ASSEMBLED. THE CLOTH FLAPS COVERING THE FOLDED AIR BAG MAY HAVE BEEN TUCKED IN TOO FAR.
Consequence & remedy
Consequence: THIS CONDITION COULD PREVENT PROPER DEPLOYMENT OF THE AIR BAG. IN A CRASH, AN IMPROPER AIR BAG DEPLOYMENT COULD INCREASE THE RISK OF INJURY TO A FRONT SEAT PASSENGER.
Remedy: DEALERS WILL REPAIR THE FRONT PASSENGER'S AIR BAG MODULE TO PREVENT THIS PROBLEM FROM OCCURRING.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
1
SQ98012 · Condenser Fan Motor Inoperative
Opened Jun 30, 1998 · Closed Nov 2, 1998
Status: closed (inferred from source dates) · Equipment:appliance:air Conditioner
Illustration