How this year compares
Owner complaints by model year
Other model years Selected year
Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
No component reports in this snapshot.
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 0 of 0 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
NHTSA owner reports · September 18, 2026 snapshot.
Official recalls
10Dec 15, 2014
Hino Motor Sales U.S.A., Inc. (Hino) is recalling certain model year 2005-2015 Hino ND8J, NE8J, and NF8J trucks manufactured August 26, 2003, to May 14, 2014. In the affected vehicles, components of the parking brake handle assembly may wear, resulting in either the parking brake unexpectedly releasing when engaged or preventing the parking brake from fully engaging.
Consequence & remedy
Consequence: Either parking brake condition may result in the vehicle rolling unexpectedly, increasing the risk of a crash.
Remedy: Hino will notify owners, and dealers will install a new parking brake lever that contains a two-way damper and a roller at the cable joining pin, free of charge. The recall began February 2, 2015. Owners may contact Hino customer service at 1-248-699-9330. Hino's number for this recall is A9970. Note: This recall supersedes 13V-614.
Dec 3, 2012
Hino is recalling certain model year 2005 through 2013 medium duty trucks, models NA6J, NB6J, NC6J, ND8J, NE8J, NJ8J, NF8J, and NV8J, manufactured from August 18, 2003, through November 16, 2011. Over time, the main B+ circuit from the battery to the starter could potentially short to ground due to wear that accumulates as a result of interference between the B+ circuit and its convoluted tubing sheath.
Consequence & remedy
Consequence: If the B+ circuit shorts to ground, it may lead to a fire.
Remedy: Hino will notify owners, and dealers will repair the vehicles free of charge. The recall began on January 17, 2013. Owners may contact Hino at 1-248-699-9390.
Additional source detail variants (2)
Electrical System:wiring
Hino is recalling certain model year 2005 through 2013 medium duty trucks, models NA6J, NB6J, NC6J, ND8J, NE8J, NJ8J, NF8J, and NV8J, manufactured from August 18, 2003, through November 16, 2011. Over time, the main B+ circuit from the battery to the starter could potentially short to ground due to wear that accumulates as a result of interference between the B+ circuit and its convoluted tubing sheath.
Consequence: If the B+ circuit shorts to ground, it may lead to a fire.
Remedy: Hino will notify owners, and dealers will repair the vehicles free of charge. The recall began on January 17, 2013. Owners may contact Hino at 1-248-699-9390.
Electrical SYSTEM:12V/24V/48V Battery:cables
Hino is recalling certain model year 2005 through 2013 medium duty trucks, models NA6J, NB6J, NC6J, ND8J, NE8J, NJ8J, NF8J, and NV8J, manufactured from August 18, 2003, through November 16, 2011. Over time, the main B+ circuit from the battery to the starter could potentially short to ground due to wear that accumulates as a result of interference between the B+ circuit and its convoluted tubing sheath.
Consequence: If the B+ circuit shorts to ground, it may lead to a fire.
Remedy: Hino will notify owners, and dealers will repair the vehicles free of charge. The recall began on January 17, 2013. Owners may contact Hino at 1-248-699-9390.
Apr 30, 2008
HINO IS RECALLING 16,805 MY 2005-2008 NA6J, NB6J, NC6J, ND8J, NE8J, NJ8J, AND NV8J TRUCKS. THE TWO VERTICAL RIGHT/LEFT SIDE FRONT SPRING BRACKET BOLTS WERE NOT TIGHTENED PROPERLY DURING THE ASSEMBLY PROCESS. THIS MAY CAUSE INCREASED STRESS ON THE SPRING BRACKET WHICH CAN LEAD TO CRACKING OF THE BRACKET.
Consequence & remedy
Consequence: THIS COULD REDUCE STEERING CONTROL INCREASING THE RISK OF A CRASH.
Remedy: DEALERS WILL REPLACE THE VERTICAL FRONT SPRING BRACKET ATTACHMENT BOLTS ON RIGHT/LEFT HANGER BRACKETS AND RE-TORQUE ALL ASSOCIATED BOLTS FREE OF CHARGE. THE RECALL BEGAN ON SEPTEMBER 8, 2008. OWNERS MAY CONTACT HINO AT 248-699-9300.
May 9, 2007
ON CERTAIN TRUCKS EQUIPPED WITH BANDO BELT TENSIONER, CORROSION OR RUST MAY DEVELOP ON THE TENSIONER SPINDLE OR BUSHING CAUSING THE AUTO TENSIONER TO BECOME STIFF OR BIND. THIS CAN CAUSE THE DRIVE BELT TO SUDDENLY COME OFF OR THE AUTO TENSIONER MOUNTING BOLTS COULD SUDDENLY BREAK.
Consequence & remedy
Consequence: IF THE DRIVE BELT COMES OFF, THE ALTERNATOR WARNING LAMP WILL ILLUMINATE. IF THE WARNING IS IGNORED, THIS CONDITION COULD ULTIMATELY RESULT IN A LOSS OF VEHICLE POWER (ENGINE STALL) INCREASING THE RISK OF A CRASH.
Remedy: DEALERS WILL REPLACE THE AUTO TENSIONER, INSTALL UPGRADED MOUNTING BOLTS, AND REPLACE THE ACCESSORY DRIVE BELT FREE OF CHARGE. THE RECALL BEGAN ON APRIL 25, 2007. OWNERS MAY CONTACT HINO MOTORS AT 248-648-6430. NOTE: THIS RECALL SUPERSEDES A PREVIOUS CAMPAIGN (PLEASE SEE 06V157).
May 18, 2006
ON CERTAIN TRUCKS, DURING ASSEMBLY, THE DRAG LINK ATTACHMENT NUTS AT THE PITMAN ARM AND STEERING ARM MAY HAVE BEEN INCORRECTLY TORQUED. RESIDUAL GREASE AND PAINT WHICH WAS APPLIED AS A RUST INHIBITOR ON THE STEERING ARM MAY HAVE CONTRIBUTED TO A LOSS OF TORQUE AFTER ASSEMBLY.
Consequence & remedy
Consequence: INCREASED WEAR FOR THE DRAGLINK CONNECTIONS CAN OCCUR CREATING A NOTICEABLE INCREASE IN THE AMOUNT OF STEERING WHEEL FREE PLAY. IF THIS CONDITION WAS IGNORED, A LOSS OF STEERING CONTROL OF THE VEHICLE COULD OCCUR WHICH COULD RESULT IN A CRASH.
Remedy: DEALERS WILL INSPECT THE STEERING ARM TIGHTNESS AND REMOVE ALL GREASE AND PAINT FROM THE STEERING ARMS AND RETORQUE THE DRAGLINK ATTACHMENT NUTS AT THE STEERING ARM AND PITMAN ARM. THE RECALL BEGAN ON MAY 12, 2006. OWNERS MAY CONTACT HINO AT 1-248-648-6430.
May 10, 2006
ON CERTAIN TRUCKS EQUIPPED WITH BANDO BELT TENSIONER, CORROSION OR RUST MAY DEVELOP ON THE TENSIONER SPINDLE OR BUSHING CAUSING THE AUTO TENSIONER TO BECOME STIFF OR BIND. THIS CAN CAUSE THE DRIVE BELT TO SUDDENLY COME OFF OR THE AUTO TENSIONER MOUNTING BOLTS COULD SUDDENLY BREAK.
Consequence & remedy
Consequence: IF THE DRIVE BELT COMES OFF, THE ALTERNATOR WARNING LAMP WILL ILLUMINATE. IF THE WARNING IS IGNORED, THIS CONDITION COULD ULTIMATELY RESULT IN A LOSS OF VEHICLE POWER (ENGINE STALL) INCREASING THE RISK OF A CRASH.
Remedy: DEALERS WILL REPLACE THE AUTO TENSIONER, INSTALL UPGRADED MOUNTING BOLTS, AND REPLACE THE ACCESSORY DRIVE BELT FREE OF CHARGE. THE RECALL BEGAN ON MAY 2, 2006. OWNERS MAY CONTACT HINO MOTORS AT 248-648-6430. THIS CAMPAIGN HAS BEEN SUPERSEDED - PLEASE SEE 07V208.
Sep 20, 2004
ON CERTAIN TRUCKS, WHEN THE STEERING WHEEL IS BEING TURNED, THE DUST COVER MAY TWINE WITH THE STEERING SHAFT AND COULD RESULT IN THE STEERING WHEEL OPERATION BECOMING HEAVY.
Consequence & remedy
Consequence: LOSS OF STEERING CONTROL MAY OCCUR, WHICH COULD RESULT IN A CRASH.
Remedy: DEALERS WILL REMOVE THE OLD DUST COVER AND INSTALL A NEWLY DESIGNED COVER. THE RECALL BEGAN OCTOBER 8, 2004. OWNERS SHOULD CONTACT HINO AT 1-845-365-1400.
Sep 13, 2004
ON CERTAIN CAB AND CHASSIS TRUCKS, WHEN EXCESSIVE FORCE IS APPLIED TO THE ACCELERATOR PEDAL, BEYOND THAT REQUIRED TO ACHIEVE FULL ACCELERATION, THE PEDAL MAY BECOME WEDGED BETWEEN THE FLOOR PANEL AND THE CARPET.
Consequence & remedy
Consequence: WHEN THIS OCCURS, THE ACCELERATOR PEDAL WILL BECOME WEDGED IN THE FULL THROTTLE POSITION WHICH COULD RESULT IN A CRASH WITHOUT WARNING.
Remedy: DEALERS WILL INSPECT THE ACCELERATOR PEDAL HEIGHT TO DETERMINE IF IT IS WITHIN SPECIFICATIONS. IF EITHER THE PEDAL HEIGHT OR THE ACCELERATOR ROD IS NOT WITHIN SPECIFICATIONS, REPLACE THE ACCELERATOR ASSEMBLY. IN ADDITION, A NEW BRACKET CONTAINING AN ACCELERATOR PEDAL STOPPER WILL BE INSTALLED. THE RECALL BEGAN ON SEPTEMBER 8, 2004. OWNERS SHOULD CONTACT HINO CUSTOMER SERVICE AT 1-845-365-1400.
Aug 2, 2004
ON CERTAIN TRUCKS, THE POWER STEERING PIPE CLAMP WAS NOT INSTALLED.
Consequence & remedy
Consequence: THE PIPE COULD FRACTURE CAUSING THE LOSS OF POWER STEERING, WHICH COULD RESULT IN A CRASH.
Remedy: DEALERS WILL INSPECT EACH VEHICLE AND DETERMINE IF THE POWER STEERING CLIP IS INSTALLED. IF THE POWER STEERING PIPE CLIP IS NOT INSTALLED, THE CORRECT CLIP WILL BE ADDED. THE RECALL BEGAN ON AUGUST 23, 2004. OWNERS SHOULD CONTACT HINO AT 1-845-365-1400.
Apr 28, 2004
ON CERTAIN TRUCKS, THE PINCH BOLT NUT OF THE YOKE CONNECTING THE STEERING GEARBOX AND THE STEERING WHEEL SHAFT BACKED OUT.
Consequence & remedy
Consequence: THIS COULD CAUSE THE YOKE AND THE STEERING WHEEL SHAFT TO SEPARATE WHICH COULD RESULT IN LOSS OF STEERING INCREASING THE RISK OF A CRASH.
Remedy: DEALERS WILL INSPECT AND RETORQUE THE PINCH BOLT NUT AS NECESSARY. OWNER NOTIFICATION BEGAN MAY 7, 2004. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT HINO AT 1-845-365-1400.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
Illustration