2024 GMC Canyon

Vehicle alerted driver that ECS and. Rake assist was needed and disabled abs and forward collision while lighting up multiple warning lights on dashboard. Lights eventually turned off leaving a check engine light on. Multiple codes pulled from system using obd2 reader. Communication bus B offline and U0074, U0151, U0447,U0452 all at same time.

I first noticed the brakes squealing in August 2025 at 15,000 miles. The dealership said I needed to resurface the front rotors. I mistook this a coating and brake debris, but it was actually the rotors warping. By 21,000 the vehicle is pulsing heavily when stopping. I went back to the dealer and this time they told me all 4 rotors are warped. GM denied coverage of the pads and rotors. Normal driving, no collisions or towing.

On 2 occasions the battery was drained and a tow truck had to jump the battery. On one occasion after the battery was jump started it took several hours before the brakes were able to be used and the car driven safely. Had to drive very slowly (under 50 mph) per note that appeared on dashboard. After nearly an hour of waiting Engine light stayed on and dealership ran diagnostic and found nothing wrong with the battery nor anything else. Have to start and run engine everyday to keep battery from dying. If not started in 24 to 36 hours, battery will die.

16,000 miles driven and my replace brake sensor light came on the dashboard. I took it in to get looked at and was told the Front Drivers Side has 1 brake pad showing a life of 5 while my other pads all showed a life of 9/10. I was told that most likely something stuck inside the brake pad itself causing it to wear unevenly but I don't drive anything but highway and paved roads. I looked around other forums and multiple others are complaining of the same issue. I contacted GM and they told me brakes are a wear item. The dealer told me they aren't sure how it happened, but this isn't right to be replacing brakes on a brand new vehicle I've only driven for 10 months. Multiple others are saying the same thing in GM/Colorado forums.

Break monitors for front breaks have dislodged and caused damage to rotors and pads. Dealer claims this is normal wear! Breaks shimmy when breaking in all directions and squeak when backing. I travel to my work requiring mountain passes during inclement weather. The most important safety method while traveling on snow and ice is smooth steering, acceleration and breaking. With my font breaks shimmying, I am concerned for my safe control of the vehicle. Thank you in advance for your attention to this matter.

On [XXX] I took a trip with family through Ohio from Pennsylvania. While truck was in adaptive cruise control on highway, phantom braking occurred where truck slowed down from 70mph to about 60mph 5 times. No objects or vehicles in front of truck or around truck during the braking. The weather was mostly clear overcast at times with no rain or snow. Concerned if vehicles were behind me during the breaking causing an accident. It was abrupt completely out of the blue when it happened. Took truck into service on 1/8/25 for oil change and braking issue, dealership states there’s no service bulletin for issue. I have not used adaptive cruise control since. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Battery dies during vehicle update spontanteniouly. After jumoing vehicle to start it all systems will not return to normal causing brakes not to function normally. I jumped my vehicle after one system update and brakes failed to engage almost causing an acident. these vehicles should not be on the road due to the software safety flaws. GMC is aware of this and still have no fix for the problem. There are numerous accounts of this happening to this vehicle on forums and solcial media.

Vehicle was brought in 5/18/24 for check engine light Dealer eventually found broken wire in headliner on right side Dealer repaired wire and I picked up vehicle 5/22/24. Vehicle was brought in 7/29/24 for park assist code dealer found short in wire. Dealer stated that to fix wire would require taking cab and bed off frame. Dealer ran a new wire along frame to avoid fixing properly. Vehicle picked up 8/1/24. Vehicle brought in 9/10/24 for a variety of sensors activated. Dealer stated to me that anti-lock brake module was on NATIONAL back order and not expected until 10/28/24. Ut was not safe to drive the vehicle, and they have had the vehicle from 9/10/24. Also, drivers power window module has to be replaced. This 2024 Canyon has been a problem. I have contacted GM and asked for a buyback of the vehicle which GM refused