2022 GMC Canyon

After driving vehicle and parking vehicle turn key off key will not turn all the way off to pull key out of ignition switch. The vehicle had 35,750 miles when brought to dealership I had told them this has happened multiple times I had to restart vehicle move vehicle shift vehicle manually or drive around block park again and then key would turn all the way off and come out, When I was contacted from the GMC dealership they said they could not duplicate the problem but I have paperwork from them and the mileage during drop off which was 35,750 miles and pickup at 35,751 miles I also told them to drive the truck it is not going to happen sitting in the dealership parking lot but they only went 1 mile, The warranty for this problem will be up at 36,000 miles. I drove the vehicle 8 miles from the dealership to my house no problems drove another drove another 6 miles to the car wash and went through the car wash went to park to vacuum and wipe exterior the key would not turn all the way off stuck in the accessory position had to back up and move vehicle to another spot park and then the key turned all the way off so I could get key out

While driving out of a parking lot, my power steering stopped working and I had to regain control to manually steer the vehicle. After stopping and turning off the engine to check the serpentine belt, the power steering came back on, but the lane departure assist function was no longer working. It appears to be the same problem that some of the 2015 and other GMC Canyon models had. Took it to my GMC dealer for warranty evaluation.

Service Power Steering, Drive with care warning comes on, vehicle looses all power steering. First time it happen was around November 2023. This will happen randomly, at various speeds, sometimes going straight, sometimes turning. Power steering will come back after a few minutes sometimes, a few times vehicle had to be turned off for a hour, but was out for over 3 days one time. During that incident we ran OBD scanner, C0800 code was showing for Power Steering Control Module, recommended repair was the replace battery, even though the battery was good. We went ahead and replaced the battery anyways, issue was not immediately resolved but after running the truck for an hour and then going for a test drive power steering returned a mile down the road. That was around May 11th. Issue hadn’t returned until today, June 22nd where it’s went on and off a handful of time before totally loosing power steering for over 5 hours now. 2015 model years had an issue the power steering rack wiring, dealer said they assume it could be same issue. Connections to the steering rack where check and corrosion was found but they won’t fix because it’s not a recall even though it’s the same corrosion issue the 2015 models had.

The contact owns a 2022 GMC Canyon. The contact stated that while driving approximately 5 MPH and making a right turn, the steering wheel became inoperable. The service power steering message was displayed. There were no warning lights illuminated. The vehicle was towed to the local dealer, where it was diagnosed that there was water intrusion into the electrical connector. The vehicle was repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 14,424.

The contact owns a 2022 GMC Canyon. The contact stated while driving approximately 70 MPH, the vehicle started to shake and vibrate from the front tires. Additionally, the steering wheel and steering column were also vibrating. The contact stated no warning light was illuminated. The contact drove the vehicle to a local dealer however, the vehicle was not diagnosed. The vehicle was not repaired. The manufacturer had been informed of the failure. The failure mileage was approximately 2,000.