2017 Ford Expedition

In 2022, around mileage of 67000, our SUV was climbing a steep road when it suddenly made a pop sound & went into limp mode with the wrench light showing and the engine sounding rough. It felt like no fuel was getting to the engine & the gas pedal was non-responsive. The RPMs didn't change when the gas pedal was pressed. The grade was so steep, we barely made it to the side of the road without rolling backwards into traffic behind us. After turning the engine off and sitting about 10 mins, we tried starting the engine again. The car seemed to have reset itself! It ran fine; the wrench light turned off, and the gas pedal was responsive again. (At the time, we were on vacation at the coast and had traveled from our home at about elevation 3500'. We had also recently had to buy gas from a small no name gas station, so we feared we may have gotten bad fuel). From there, we returned home without re-occurrence, and we used fuel cleaning additive to our Chevron fuel for the next 2 fill ups. Then, approximately 600 miles later on a flat grade, it happened again without the pop sound. We immediately went to our Ford dealer who found no error code but found our purge valve stuck open. They recommended we replace it, which we did, and we operated the vehicle for 2 years without re-occurrence and using only Chevron gas. Recently, it happened again! Luckily, we weren't on a steep grade this time or on the freeway, but if a car would have been behind us, we would have likely been rear ended, especially had we been on the freeway. Once again, we shut the engine off, and it reset with the wrench light disappearing, so no diagnostic code got thrown AGAIN! Based on many complaints, this appears to be a common problem. It's very dangerous as the car immediately losses power to a crawl no matter what speed you are traveling at the time. It seems to be the electronic throttle body in instances where the SUV can stay running, so a code can be obtained before it resets.

The contact owns a 2017 Ford Expedition. The contact stated while reversing at an undisclosed speed, the back over prevention camera failed to function as intended. The contact stated that the back over prevention camera displayed colorful lines but not the proper image. The vehicle was not diagnosed or repaired by an independent mechanic or the dealer. The manufacturer was made aware of the failure and a case was filed. The failure mileage was 36,830.

Brake master cylinder rear seal failed and engine vacuum drew all fluid from reservoir into brake booster as vehicle idled in park. Both front and rear brakes were inoperable because one reservoir serves both systems and that reservoir was emptied by engine vacuum. Pedal went to floor with zero brake actuated. At highway speed this would result in a severe accident due to the rapid loss of fluid with no prior change in braking effort. Vehicle could only be slowed with parking brake. Ford dealer service department inspected and confirmed loss of fluid into booster. Brake warning light and low fluid message displayed as reservoir was drained by engine vacuum.

The contact owns a 2017 Ford Expedition. The contact stated while driving approximately 50 MPH, the transmission unexpectedly downshifted to first gear, causing the vehicle to abruptly slow down. The contact stated that after restarting the vehicle, the failure was corrected. The vehicle was driven to the local dealer who diagnosed the vehicle and determined that the transmission lead frame was faulty and needed to be replaced. The vehicle was repaired. The manufacturer was notified of the failure, but no assistance was offered. The failure mileage was 170,000.

The contact owns a 2017 Ford Expedition. The contact stated after the vehicle had been repaired under an unidentified recall, the instrument panel and central electrical console were flickering. The contact stated that the headlights were also flickering. In addition, there was an abnormal burning odor coming through the air vents. The battery was replaced and drained prematurely. The vehicle was taken to a local dealer where it was diagnosed that the blower motor assembly had failed. The contact stated that the vehicle had been diagnosed by several local dealers, but no repairs had been performed due to parts not being available. The manufacturer was made aware of the failure. The failure mileage was approximately 125,000.

This issue has happened multiple times, once on the highway the vehicle felt like it lost gear/ the engine completely cut off. multiple warning lights came on such as airbag, ABS, engine light. was eventually able to get to the shoulder and after multiple attempts it started back up, showed no warning lights. drove the rest of the way fine. another time that could have put other at risk is when driving in the city, the vehicle lost power and also lost the ability to stee. causing me to be standstill in the roadway. the vehicle started back up after two attempts. the vehicle has been to the local deal a total of 4 times with the last time requesting a through inspection of the grounds, as this seems like an electrical or mechanical issue the service manager requesting me "not to bring it back until it's broken" leaves me lost.

Tailgate opens and closes at random times while stationary or in motion. When the tailgate opens and closes, anything behind the back seat could fall out onto any vehicle. Has been reported to the dealer and repaired but has relapsed to previous condition. Serra Hyundai Birmingham, Alabama has been aware of this condition as recent as May 10, 2024. Problem surfaced mid September, 2023.

The contact owns a 2017 Ford Expedition. The contact stated that while his wife was driving at an undisclosed speed, the vehicle stalled. The wheels then seized, causing the vehicle to jerk. Additionally, the speedometer was inoperable while driving. The "Blind Spot System Fault" and "See Manual - Transmission" messages were displayed and the check engine warning light was illuminated. The vehicle was able to be restarted. The vehicle was taken to an independent mechanic, who diagnosed that the molded leadframe needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure and a case was opened. The contact was informed that the failure was related to Customer Satisfaction Program: 19N01 (Transmission Molded Leadframe Extended Coverage); however, the VIN was not included. The failure mileage was approximately 120,000.