I was driving my Ford Edge at approximately 35 mph. As I approached a stoplight, I depressed the brake pedal and it immediately went all the way to the floor with almost no braking action. I was able to get some braking by pumping the brakes continually, avoiding an accident at the light. As a local Pep Boys store had replaced t…
Read full complaint
I was driving my Ford Edge at approximately 35 mph. As I approached a stoplight, I depressed the brake pedal and it immediately went all the way to the floor with almost no braking action. I was able to get some braking by pumping the brakes continually, avoiding an accident at the light. As a local Pep Boys store had replaced the brake pads about 5 weeks earlier, I chose to slowly and carefully drive the car to their location. The brakes continued to require pumping for any braking action. At Pep Boys, I turned off the vehicle and went inside. They phoned me a few hours later to say that they found that the brakes worked fine. They found no fluid leaks, the master cylinder was full, and they could not duplicate any problem. I did a little research on the internet and found two reports of similar incidents at https://www.vehiclehistory.com/articles/ford-edge-master-cylinder-recalls-a-deeper-dive. The two excerpts read: "Brake Pedals Travel to the Floor "One Ford Edge owner reported that the vehicle suddenly lost braking power. The brake pedal pushed all the way to the floor, and they nearly were involved in a collision. After stopping the vehicle and turning it back on, the brakes began to work normally. "In another consumer complaint, the same issue happened. An independent repair shop reinstalled the master cylinder and manually bled the brake lines to fix the issue." I made an appointment with All American Ford in Old Bridge, NJ and dropped my car there on August 16, 2022. I was notified on August 20 that they could find nothing wrong with the vehicle. There was no warning nor prior symptoms of the brake failure. The brakes have continued to work since I turned the vehicle off at Pep Boys. No warning lamps or messages concerning the failure were displayed. I did come across similar failure reports for Edges that claimed the root cause was a combination of master cylinder, brake power booster and electronic brake control module, but my dealer was unaware.
NHTSA ODI #11480436
Mileage unknown · Aug 21, 2022
Service Brakes
1. Brakes failed, vehicle available upon request. 2. I avoided hitting the car in front of me and i was ok but I put myself and others at great risk driving my car as the brakes continue to fail intermittently. 3. Problem was reproduced. 4. I paid for 2 diagnosis and they are as follows; a) replace brake booster and master cyli…
Read full complaint
1. Brakes failed, vehicle available upon request. 2. I avoided hitting the car in front of me and i was ok but I put myself and others at great risk driving my car as the brakes continue to fail intermittently. 3. Problem was reproduced. 4. I paid for 2 diagnosis and they are as follows; a) replace brake booster and master cylinder b) ABS module, this mechanic told me he replaced the booster and master in a 2013 Edge to no avail and has now been waiting 2 months on the ABS module, driver has no vehicle. He also has 1 other 2013 Edge with the same problem. 5. There was no warning indicators.
NHTSA ODI #11480399
Mileage unknown · Jul 2, 2022
Service Brakes
Brake petal sinking to the floor. Brakes have been changed and caliper changed as well.
NHTSA ODI #11472106
Mileage unknown · Jun 15, 2022
Service Brakes
2014 Edge, The Vehicle won't stop on time, Brake pedal becomes very hard to press and vehicle will continue to roll out into the street. I've heard a beep at 3 different times, brake pedal will then go to the floor, but continues to roll, My child my family is in grave dander while in vehicle. This is a recall if every I've s…
Read full complaint
2014 Edge, The Vehicle won't stop on time, Brake pedal becomes very hard to press and vehicle will continue to roll out into the street. I've heard a beep at 3 different times, brake pedal will then go to the floor, but continues to roll, My child my family is in grave dander while in vehicle. This is a recall if every I've seen one... [XXX] INFORMATION Redacted PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6).
NHTSA ODI #11469437
Mileage unknown · Apr 27, 2022
Service Brakes
Pressing the brake while parking the car and later driving it on the road. Happened all of a sudden. Loss of break pressure when I put my foot on break peddle to stop. My foot went to the floor! No warning on dash, no idiot light, nothing.
NHTSA ODI #11462511
Mileage unknown · Oct 21, 2021
Service Brakes
Brake pedal became very hard to press down, severely limiting the ability to stop the vehicle. The brake booster is available for inspection. It appears that there was a recall for 2009-2013 models but not for the 2014. My car was built and assembled in December of 2013 at the same plant installed the defective boosters. The…
Read full complaint
Brake pedal became very hard to press down, severely limiting the ability to stop the vehicle. The brake booster is available for inspection. It appears that there was a recall for 2009-2013 models but not for the 2014. My car was built and assembled in December of 2013 at the same plant installed the defective boosters. There were no warning lights or indication of a problem. The brake booster has been replaced by a reputable shop.
NHTSA ODI #11437720
68,000 miles · Oct 18, 2021
Service Brakes
The contact's mother owns a 2014 Ford Edge. The contact stated that while the brake pedal was depressed, the brake pedal was traveling to the floorboard. The vehicle was taken to the dealer where the contact was unaware if there was a diagnostic test performed. The vehicle was not repaired. The manufacturer was notified of the f…
Read full complaint
The contact's mother owns a 2014 Ford Edge. The contact stated that while the brake pedal was depressed, the brake pedal was traveling to the floorboard. The vehicle was taken to the dealer where the contact was unaware if there was a diagnostic test performed. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 68,000.
NHTSA ODI #11437215
128,000 miles · Aug 4, 2021
Service Brakes
The contact owns a 2014 Ford Edge. The contact stated that while driving at an undetermined speed, the brake pedal was depressed however, the pedal was hard to depress to the floorboard. Additionally, while starting the vehicle, there was an abnormal squealing sound detected. While driving up hill with the cruise control engaged…
Read full complaint
The contact owns a 2014 Ford Edge. The contact stated that while driving at an undetermined speed, the brake pedal was depressed however, the pedal was hard to depress to the floorboard. Additionally, while starting the vehicle, there was an abnormal squealing sound detected. While driving up hill with the cruise control engaged, the brake pedal was hard to depress and the cruise control failed to disengage. The vehicle was taken to the local dealer but was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was 128,000.
NHTSA ODI #11427756
Mileage unknown · Jul 1, 2021
Service Brakes
Brake Booster issue. Brake pedal feels spongy/soft when trying to stop. Vehicle makes a whirring/hissing noise when letting off the brake pedal. The car feels like it won't stop in time for a stop sign or stop light while going as slow as 25 mph. There is an extended warranty on this make/model, but Ford refuses to honor it …
Read full complaint
Brake Booster issue. Brake pedal feels spongy/soft when trying to stop. Vehicle makes a whirring/hissing noise when letting off the brake pedal. The car feels like it won't stop in time for a stop sign or stop light while going as slow as 25 mph. There is an extended warranty on this make/model, but Ford refuses to honor it and fix it. I have a vehicle with less than 65,000 miles that is undriveable. No warning lights came on the dashboard at all. The brakes got spongy out of no where. No warning. Ford has confirmed the issue. No accidents in the vehicle because I refuse to drive it now.
NHTSA ODI #11423174
105,000 miles · Mar 31, 2021
Service Brakes
TL* THE CONTACT OWNS A 2014 FORD EDGE. THE CONTACT STATED WHILE DRIVING 65 MPH, THE BRAKES FAILED TO ENGAGE AND WAS DIFFICULT TO DEPRESS. THERE WAS NO WARNING LIGHT ILLUMINATED. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC TO BE DIAGNOSED. THE CONTACT WAS INFORMED THAT THE BRAKE BOOSTER NEEDED TO BE REPLACED. THE CONTACT REL…
Read full complaint
TL* THE CONTACT OWNS A 2014 FORD EDGE. THE CONTACT STATED WHILE DRIVING 65 MPH, THE BRAKES FAILED TO ENGAGE AND WAS DIFFICULT TO DEPRESS. THERE WAS NO WARNING LIGHT ILLUMINATED. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC TO BE DIAGNOSED. THE CONTACT WAS INFORMED THAT THE BRAKE BOOSTER NEEDED TO BE REPLACED. THE CONTACT RELATED THE FAILURE TO AN UNKNOWN RECALL. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS INFORMED OF THE FAILURE AND INFORMED THE CONTACT THAT THE VIN WAS NOT UNDER RECALL. THE FAILURE MILEAGE WAS APPROXIMATELY 105,000.
Ford Motor Company (Ford) is recalling certain 2014-2016 Explorer, 2014-2015 Taurus and 2014 Edge vehicles equipped with 2.0L or 2.3L engines and front wheel drive. The support bracket for the front drive axle halfshaft may fail.
Consequence & remedy
Consequence: The failed bracket could result in a loss of park function which can cause unintended vehicle movement, and loss of motive power while driving which increases the risk of a crash.
Remedy: Ford will notify owners, and dealers will replace the link shaft bracket, free of charge. Parts are not currently available. Owners received an interim notification detailing safety risk December 8, 2020. A second letter will be mailed when parts become available in January 2021. The recall began February 2, 2021. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 20S63.
Ford Motor Company (Ford) notified the agency on January 8, 2015, that they are recalling certain model year 2014 Ford Escape vehicles manufactured April 15, 2014, to May 8, 2014, and 2015 Lincoln MKC vehicles manufactured April 21, 2014, to May 15, 2014. On April 30, 2015, Ford expanded the recall to cover an additional 45,505 vehicles, including certain model year 2014-2015 Ford Transit Connect vehicles manufactured November 11, 2013, to August 29, 2014, 2014-2015 Ford Fiesta vehicles manufactured April 10, 2014, to June 17, 2014 and 2014 Ford Edge vehicles manufactured April 30, 2014, to May 21, 2014. Improper nickel plating of components within the fuel pump may result in the fuel pump failing.
Consequence & remedy
Consequence: If the fuel pump fails, the vehicle may stall without warning, increasing the risk of a crash.
Remedy: Ford will notify owners, and dealers will replace the fuel pump, free of charge. The recall began on February 27, 2015. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 14S30.
Ford Motor Company (Ford) is recalling certain model year 2012-2014 Ford Edge and Lincoln MKX vehicles manufactured September 2, 2010, to November 30, 2013; 2013-2014 Ford Taurus and Lincoln MKS vehicles manufactured August 25, 2011, to November 30, 2013; and 2013-2014 Ford Flex and Lincoln MKT vehicles manufactured September 12, 2011, to November 30, 2013. In the affected vehicles, the halfshaft retention circlip may not have been properly installed, and as a result, the halfshaft may move outward and disengage from the linkshaft while driving and without prior warning.
Consequence & remedy
Consequence: If the halfshaft and linkshaft become disengaged while driving, power will no longer be transmitted to the wheels, increasing the risk of a vehicle crash. Additionally, if the parking brake is not applied before exiting the vehicle, the vehicle may roll away despite the transmission being placed in 'Park', increasing the risk of injury to exiting occupants and bystanders.
Remedy: Ford will notify owners, and dealers will inspect the vehicles to make sure that the halfshaft is properly retained. If it is not, dealers will replace the linkshaft and also replace the halfshaft if it shows evidence of spline damage, free of charge. The recall began on August 4, 2014. Owners may contact Ford customer service at 1-800-392-3673. Ford's number for this recall is 14S10.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
1
PE15020 · Wheel Separation
Opened May 20, 2015 · Closed Jan 4, 2016
Status: closed (inferred from source dates) · Wheels:rim
On November 29, 2014, ODI received a complaint reporting the complete separation of an original equipment 22-inch alloy wheel rim mounted on the right front position of a model year 2014 Ford Edge vehicle (VOQ 10661278).The driver indicated that the right-front corner of the vehicle suddenly dropped while driving, causing the vehicle to go off the road to the right and into a field.The right-front wheel rim was found to have broken into two pieces. The owner said that there was no prior warning or wheel related problems with the vehicle. The vehicle had been driven approximately 8,500 miles at the time of the incident.On May 29, 2015 ODI sent an information request to Ford asking for detailed information related to the specific 22 inch alloy wheel used on the Edge as well as any peer vehicles which used the same type of wheel.On July 17, 2015 Ford provided ODI with the requested information. Ford's search showed that the single incident reported to ODI is the only instance of a wheel failure on the subject or peer vehicles.The failed wheel was sent to the National Transportation Service Board (NTSB) materials analysis laboratory for examination. The NTSB determined that the wheel failed because of a severe impact that caused a crack that rapidly propagated around the circumference of the wheel, The rim fracture surface had a predominantly rough appearance consistent with an overstress fracture (rapid fracture)There were no abnormalities or unique features associated with the fracture initiation site.Metallurgical analysis of the rim found that the material was within specification and no anomalies were identified that could have contributed to the failure.See the full NTSB report for more details.Based on the absence of additional failures and the results of the wheel material testing and failure analysis, this investigation is closed. The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exist. The Agency will continue to monitor complaints and other information relating to the alleged defect in the subject vehicles and take further action in the future if warranted.The following VOQ is associated with this investigation: 10661278
2014 Ford Edge Problems, Complaints & Recalls | Skip That Year