Service Brakes. Review the 57 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Electrical System. Review the 56 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Power Train. Review the 56 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

14 crash reports0 fire reports6 injury reports

Power Train complaints

56 reports

Clear category filter

22,232 miles · Sep 26, 2017

Power Train

AFTER DRIVING AND PLACING THE VEHICLE IN PARK, THEN TURNING OFF THE ENGINE; WHICH IS DONE BY "PUSHING BUTTON CONTROL," THE INDICATOR READS " TRANSMISSION NOT IN PARK". ALTHOUGH THE GEAR HANDLE IS FULLY ENGAGED IN THE PARK POSITION. ONLY AFTER PUSHING THE GEAR HANDLE WITH A LITTLE FORCE TO ENSURE IT'S IN THE "PARK", POSITION, DOE…

Read full complaint

NHTSA ODI #11029879

62,788 miles · Aug 21, 2017

Power Train

Read full complaint

TL* THE CONTACT OWNS A 2014 FORD EDGE. WHILE ATTEMPTING TO PARK THE VEHICLE, THE "TRANSMISSION NOT IN PARK" WARNING INDICATOR ILLUMINATED. THE VEHICLE WAS TAKEN TO A LOCAL DEALER (BEYERS FORD LOCATED AT 170 RIDGEDALE AVE MORRISTOWN, NJ 07960) WHERE IT WAS DIAGNOSED THAT THE SHIFTER ASSEMBLY NEEDED TO BE REPLACED. THE VEHICLE WAS REPAIRED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE AND REFERRED THE CONTACT TO NHTSA. THE FAILURE MILEAGE WAS 62,788. UPDATED 10/05/17*LJ *TR

NHTSA ODI #11016520

21,800 miles · Oct 4, 2016

EnginePower Train

VEHICLE ABRUPTLY SLOWED DOWN WHILE GOING 35-40 MPH. ERROR MESSAGE ON DISPLAY SAID SEE OWNERS MANUAL WITH THE WRENCH SYMBOL WHICH IS A LOSS TO THE POWER TRAIN. VEHICLE HAD A ROUGH IDLE AND GAS PEDAL WAS NOT RESPONDING AND I HAD TO BE COAST TO SIDE OF ROAD AFTER WHICH IT WAS TURNED OFF. AFTER ABOUT 3-5 MINUTES I RESTARTED THE VEH…

Read full complaint

NHTSA ODI #10913742

4,400 miles · Jun 4, 2015

Engine And Engine CoolingPower TrainSteering

Read full complaint

I WAS DRIVING MY CAR DOWN A SIDE STREET WHEN ALL OF A SUDDEN THE DASHBOARD FLASHED "LOW ENGINE OIL PRESSURE" AND I LOST CONTROL OF THE STEERING, BRAKES, AND GAS. THE CAR ESSENTIALLY JUST STALLED OUT AND JUST STARTED ROLLING UNTIL I HIT THE EMERGENCY BRAKE. I HAD THE CAR TOWED TO THE DEALERSHIP AND AFTER LOOKING AT IT FOR TWO DAYS THEY COULDN'T REPLICATE THE ERROR AND COULDN'T FIND ANYTHING WRONG WITH THE CAR. THE COMPUTER REGISTERED NO ERRORS AND I WAS TOLD THERE WAS NOTHING THEY COULD DO. *TR

NHTSA ODI #10723522

3,500 miles · Nov 6, 2014

Electrical SystemPower Train

Read full complaint

TL* THE CONTACT OWNS A 2014 FORD EDGE. WHILE IDLING, THE VEHICLE STALLED AND THE WRENCH WARNING LIGHT ILLUMINATED. THE CONTACT ALSO STATED THAT THERE WAS A LOUD ABNORMAL NOISE COMING FROM THE TRANSMISSION. THE FAILURE OCCURRED ON NUMEROUS OCCASIONS. THE VEHICLE WAS TAKEN TO A DEALER ON SEVERAL OCCASIONS WHERE IT WAS DIAGNOSED THAT THE MAIN COMPUTER NEEDED TO BE REPROGRAMMED. THE VEHICLE WAS REPAIRED, BUT THE FAILURE PERSISTED. THE MANUFACTURER WAS MADE AWARE OF THE FAILURE. THE FAILURE MILEAGE WAS 3,500.

NHTSA ODI #10652982

1,000 miles · Oct 27, 2014

Power Train

TL* THE CONTACT OWNS A 2014 FORD EDGE. THE CONTACT STATED THAT THE VEHICLE ROLLED IN REVERSE WHILE THE CONTACT WAS CHANGING GEARS FROM PARK TO DRIVE. THE VEHICLE WAS TAKEN TO A DEALER, WHO WAS UNABLE TO REPLICATE THE FAILURE. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE APPROXIMATE FAILURE MIL…

Read full complaint

NHTSA ODI #10650486

Official recalls

20V692000 · Power Train:axle Assembly:axle Shaft

Nov 10, 2020

Ford Motor Company (Ford) is recalling certain 2014-2016 Explorer, 2014-2015 Taurus and 2014 Edge vehicles equipped with 2.0L or 2.3L engines and front wheel drive. The support bracket for the front drive axle halfshaft may fail.

Consequence & remedy

Consequence: The failed bracket could result in a loss of park function which can cause unintended vehicle movement, and loss of motive power while driving which increases the risk of a crash.

Remedy: Ford will notify owners, and dealers will replace the link shaft bracket, free of charge. Parts are not currently available. Owners received an interim notification detailing safety risk December 8, 2020. A second letter will be mailed when parts become available in January 2021. The recall began February 2, 2021. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 20S63.

15V005000 · Fuel System, Gasoline:delivery:fuel Pump

Jan 9, 2015

Ford Motor Company (Ford) notified the agency on January 8, 2015, that they are recalling certain model year 2014 Ford Escape vehicles manufactured April 15, 2014, to May 8, 2014, and 2015 Lincoln MKC vehicles manufactured April 21, 2014, to May 15, 2014. On April 30, 2015, Ford expanded the recall to cover an additional 45,505 vehicles, including certain model year 2014-2015 Ford Transit Connect vehicles manufactured November 11, 2013, to August 29, 2014, 2014-2015 Ford Fiesta vehicles manufactured April 10, 2014, to June 17, 2014 and 2014 Ford Edge vehicles manufactured April 30, 2014, to May 21, 2014. Improper nickel plating of components within the fuel pump may result in the fuel pump failing.

Consequence & remedy

Consequence: If the fuel pump fails, the vehicle may stall without warning, increasing the risk of a crash.

Remedy: Ford will notify owners, and dealers will replace the fuel pump, free of charge. The recall began on February 27, 2015. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 14S30.

14V393000 · Power Train:axle Assembly:axle Shaft

Jul 2, 2014

Ford Motor Company (Ford) is recalling certain model year 2012-2014 Ford Edge and Lincoln MKX vehicles manufactured September 2, 2010, to November 30, 2013; 2013-2014 Ford Taurus and Lincoln MKS vehicles manufactured August 25, 2011, to November 30, 2013; and 2013-2014 Ford Flex and Lincoln MKT vehicles manufactured September 12, 2011, to November 30, 2013. In the affected vehicles, the halfshaft retention circlip may not have been properly installed, and as a result, the halfshaft may move outward and disengage from the linkshaft while driving and without prior warning.

Consequence & remedy

Consequence: If the halfshaft and linkshaft become disengaged while driving, power will no longer be transmitted to the wheels, increasing the risk of a vehicle crash. Additionally, if the parking brake is not applied before exiting the vehicle, the vehicle may roll away despite the transmission being placed in 'Park', increasing the risk of injury to exiting occupants and bystanders.

Remedy: Ford will notify owners, and dealers will inspect the vehicles to make sure that the halfshaft is properly retained. If it is not, dealers will replace the linkshaft and also replace the halfshaft if it shows evidence of spline damage, free of charge. The recall began on August 4, 2014. Owners may contact Ford customer service at 1-800-392-3673. Ford's number for this recall is 14S10.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

PE15020 · Wheel Separation

Opened May 20, 2015 · Closed Jan 4, 2016

Status: closed (inferred from source dates) · Wheels:rim

On November 29, 2014, ODI received a complaint reporting the complete separation of an original equipment 22-inch alloy wheel rim mounted on the right front position of a model year 2014 Ford Edge vehicle (VOQ 10661278).The driver indicated that the right-front corner of the vehicle suddenly dropped while driving, causing the vehicle to go off the road to the right and into a field.The right-front wheel rim was found to have broken into two pieces. The owner said that there was no prior warning or wheel related problems with the vehicle. The vehicle had been driven approximately 8,500 miles at the time of the incident.On May 29, 2015 ODI sent an information request to Ford asking for detailed information related to the specific 22 inch alloy wheel used on the Edge as well as any peer vehicles which used the same type of wheel.On July 17, 2015 Ford provided ODI with the requested information. Ford's search showed that the single incident reported to ODI is the only instance of a wheel failure on the subject or peer vehicles.The failed wheel was sent to the National Transportation Service Board (NTSB) materials analysis laboratory for examination. The NTSB determined that the wheel failed because of a severe impact that caused a crack that rapidly propagated around the circumference of the wheel, The rim fracture surface had a predominantly rough appearance consistent with an overstress fracture (rapid fracture)There were no abnormalities or unique features associated with the fracture initiation site.Metallurgical analysis of the rim found that the material was within specification and no anomalies were identified that could have contributed to the failure.See the full NTSB report for more details.Based on the absence of additional failures and the results of the wheel material testing and failure analysis, this investigation is closed. The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exist. The Agency will continue to monitor complaints and other information relating to the alleged defect in the subject vehicles and take further action in the future if warranted.The following VOQ is associated with this investigation: 10661278