CONSUMER DISCOVERED SEVERAL CRACKS IN THE TRAILER FRAME AND HAD IT WELDED A COUPLE OF TIMES BUT IT KEEPS BREAKING. *NJ DURING ROUTINE MAINTENANCE, THE CONSUMER DISCOVERED CRACKS IN THE TRAILER FRAME AT SEVERAL LOCATIONS. CRACKS WERE DISCOVERED AT THE LEFT REAR AXLE MOUNTING POINT TO THE BOTTOM FLANGE OF THE I-BEAM ALSO IN THE…
Read full complaint
CONSUMER DISCOVERED SEVERAL CRACKS IN THE TRAILER FRAME AND HAD IT WELDED A COUPLE OF TIMES BUT IT KEEPS BREAKING. *NJ DURING ROUTINE MAINTENANCE, THE CONSUMER DISCOVERED CRACKS IN THE TRAILER FRAME AT SEVERAL LOCATIONS. CRACKS WERE DISCOVERED AT THE LEFT REAR AXLE MOUNTING POINT TO THE BOTTOM FLANGE OF THE I-BEAM ALSO IN THE WEB OF THE I-BEAM FRAME ADJACENT TO THE WELDS ATTACHING THE BODY TO THE FRAME SUPPORT BRACKETS. THE CRACKS WERE VISIBLE AND VERIFIED BY DYE PENETRANT INSPECTION. THE TRAILER HAS LESS THAN 10,000 MILES ON IT AND HAS BEEN IN USE LESS THAN A YEAR. IT HAS NOT BEEN INVOLVED IN ANY ACCIDENTS THAT COULD HAVE CAUSED DAMAGE OF THIS MAGNITUDE. THE CONSUMER CONTACTED THE DEALER ABOUT THE PROBLEM, BUT WAS REFERRED TO THE MANUFACTURER. THE MANUFACTURER INDICATED THE DEALER MUST INITIATE ACTION. *JB
NHTSA ODI #10236108
Mileage unknown · Jun 2, 2005
Structure
DURING ROUTINE MAINTAINENCE, I DISCOVERED NUMEROUS CRACKS IN TRAILER FRAME AT SEVERAL LOCATIONS. CRACKS WERE DISCOVERED AT THE LEFT REAR AXLE MOUNTING POINT TO THE BOTTOM FLANGE OF THE I-BEAM FRAME ALSO IN THE WEB OF THE I-BEAM FRAME A DJACENT TO THE WELDS ATTACHING THE BODY TO FRAME SUPPORT BRACKETS. THESE CRACKS WERE VISIBLE A…
Read full complaint
DURING ROUTINE MAINTAINENCE, I DISCOVERED NUMEROUS CRACKS IN TRAILER FRAME AT SEVERAL LOCATIONS. CRACKS WERE DISCOVERED AT THE LEFT REAR AXLE MOUNTING POINT TO THE BOTTOM FLANGE OF THE I-BEAM FRAME ALSO IN THE WEB OF THE I-BEAM FRAME A DJACENT TO THE WELDS ATTACHING THE BODY TO FRAME SUPPORT BRACKETS. THESE CRACKS WERE VISIBLE AND VERIFIED BY DYE PENETRANT INSPECTION. THE TRAILER HAS LESS THAM 10K MILES ON IT AND HAS BEEN IN ACTUAL USE LESS THAN 1 YEAR. IT HAS NOT BEEN INVOLVED IN ANY INCIDENT THAT COULD HAVE CAUSED DAMAGE OF THIS SORT. I CALLED THE DEALER REGARDING THIS PROBLEM ,HE REFERED ME TO THE MANUFACTURER. THE MANUFACTURER INDICATED THE DEALER MUST INITIATE ANY ACTION. IT IS MY CONCERN THESE CRACKS WILL PROPAGATE RAPIDLY AND CAUSE CATASTROPIC FAILURE. SHOULD THIS OCCOUR, A HIGH PROBABILITY OF NUMEROUS FATALITIES IS POSSIBLE.
NHTSA ODI #10124024
Mileage unknown · Oct 19, 2004
Structure
AXLE SPRING HANGER BROKE, LOOSE FROM I-BEAM FRAME. PART OF STEEL FROM BEAM BROKE AWAY. *BF THE CONSUMER BELIEVES THE STEEL IS WEAK OR IS TOO LIGHT FOR THE WEIGHT OF THE RV. THERE WAS NO DAMAGE NOR DID THE TRAILER HIT ANYTHING. THE FAILURE WAS DISCOVERED WHILE THE VEHICLE WAS PARKED. *NM
NHTSA ODI #10097565
Mileage unknown · Sep 2, 2003
Structure
CONSUMER STATED WHILE DRIVING AND WITH NO WARNING, THE LEFT AXLE SNAPPED AND CAUSED THE VEHICLE TO ROLL BACKWARDS. DEALER NOTIFIED. *AK (ABNORMAL PLACEMENT AND FUNCTION OF THE WHEELS). THE METAL TORE THE FRAME. THE AXLE DID NOT SNAP. THE HANGER THAT HELD THE SPRING AND AXLE TOGETHER HAD NEARLY TORE THE FRAME AND CAUSE…
Read full complaint
CONSUMER STATED WHILE DRIVING AND WITH NO WARNING, THE LEFT AXLE SNAPPED AND CAUSED THE VEHICLE TO ROLL BACKWARDS. DEALER NOTIFIED. *AK (ABNORMAL PLACEMENT AND FUNCTION OF THE WHEELS). THE METAL TORE THE FRAME. THE AXLE DID NOT SNAP. THE HANGER THAT HELD THE SPRING AND AXLE TOGETHER HAD NEARLY TORE THE FRAME AND CAUSED THE REAR AXLE TO MOVE OUT OF ALIGNMENT. THIS HAD TORE THE WELD ON THE HANGER TO 1/4 INCH OF BREAKING ALL THE WAY THOUGH. A WELDER SAID THE MATERIAL WAS TOO SKIMPY. *SCC *JB
CERTAIN MOTOR HOMES AND TRAVEL TRAILERS EQUIPPED WITH A TWO-DOOR REFRIGERATOR, MANUFACTURED BY THE DOMETIC CORPORATION, MAY HAVE A DEFECT IN THE BOILER TUBE. PRESSURIZED COOLANT SOLUTION COULD BE RELEASED INTO AN AREA WHERE AN IGNITION SOURCE (GAS FLAME) IS PRESENT.
Consequence & remedy
Consequence: RELEASE OF COOLANT UNDER CERTAIN CONDITIONS COULD IGNITE AND RESULT IN A FIRE.
Remedy: FLEETWOOD WILL BE WORKING WITH DOMETIC IN ORDER TO REPAIR THESE REFRIGERATORS (PLEASE SEE 06E076). DOMETIC WILL REPAIR THESE REFRIGERATORS BY INSTALLING A SECONDARY BURN HOUSING, A THERMAL FUSE, AND A MELT FUSE FREE OF CHARGE. DOMETIC HAS RETAINED STERICYCLE INC. TO MANAGE THIS CAMPAIGN. STERICYCLE WILL ASSIST YOU IN LOCATING DEALERSHIPS OR SERVICE CENTERS AND WILL PROVIDE ASSISTANCE WITH SCHEDULING OF APPOINTMENTS. OWNERS MAY CONTACT DOMETIC/STERICYCLE AT 1-888-446-5157 OR FLEETWOOD AT 1-800-322-8216.
ON CERTAIN TRAVEL TRAILERS EQUIPPED WITH SAMSUNG MICROWAVE OVENS, THESE OVENS WERE PRODUCED WITH A DEFECTIVE PANEL. AN ELECTRICAL SHORT CAN OCCUR BETWEEN CIRCUIT PATTERNS ON THE MEMBRANE PANEL, ESPECIALLY OVERLAPPED BY A "JUMPER" OR JUMP WIRE. THIS MAY CAUSE THE OVEN TO ACTIVATE WITHOUT PRESSING ANY KEY PADS.
Consequence & remedy
Consequence: AN ELECTRICAL SHORT CAN OCCUR CAUSING THE OVEN TO ACTIVATE WITHOUT PRESSING ANY KEY PADS. THIS COULD RESULT IN EXCESSIVE HEAT, SMOKE, OR POSSIBLY A FIRE.
Remedy: SAMSUNG WILL NOTIFY CUSTOMERS AND REPAIR THE PANEL FREE OF CHARGE. IN THE MEANTIME, CONSUMERS SHOULD UNPLUG THEIR MICROWAVE, IF POSSIBLE. IF THE CONSUMER IS UNABLE TO UNPLUG THE MICROWAVE, THEY SHOULD LEAVE THE DOOR AJAR UNTIL THE PANEL IS REPLACED. CONSUMERS SHOULD NEVER USE THE MICROWAVE OVEN FOR STORAGE OR LEAVE ANY TOWELS, PAPER, CLOTH OR OTHER PRODUCTS IN THE MICROWAVE AFTER USE. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT SAMSUNG AT 800-932-3837 OR FLEETWOOD AT 1-800-629-8454.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
2
PE06005 · Inadvertent SLIDE-OUT Extension Movement
Opened Jan 20, 2006 · Closed May 2, 2006
Status: closed (inferred from source dates) · Equipment:recreational Vehicle/trailer
THIS INVESTIGATION WAS OPENED BASED ON ODI'S RECEIPT OF A CONGRESSIONAL LETTER ON BEHALF OF A CONSTITUENT.THE CONSTITUENT REPORTED INCIDENTS WHERE THE SLIDE OUT ROOM OF HIS MOTOR HOME WOULD INADVERTENTLY MOVE (EXTEND) DURING HIGHWAY USE.ODI WAS CONCERNED THAT A FULLY EXTENDED SLIDE OUT WOULD DEGRADE THE VEHICLE'S DYNAMIC HANDLING CHARACTERISTICS AND/OR POSSIBLY IMPACT AN OBJECT OR ANOTHER VEHICLE, RESULTING IN A CRASH.ODI CONTACTED FLEETWOOD AND DISCOVERED THAT SLIDE OUT ROOMS WERE INSTALLED IN MOTOR HOMES, TRAVEL TRAILERS AND FOLDING TRAILERS. AS PART OF THE INVESTIGATION ODI VISITED A RV SHOW AND THE FLEETWOOD PAXINOS PLANT TO EXAMINE SLIDE OUTS IN VARIOUS NEW MAKE AND MODEL VEHICLES AND GAIN AN UNDERSTANDING OF HOW THE SYSTEMS WORK.DURING THE INVESTIGATION ODI LEARNED THAT THERE ARE TWO METHODS USED TO EXTEND SLIDE OUT ROOMS.SOME MANUFACTURERS USE HYDRAULIC SYSTEMS AND OTHERS, SUCH AS FLEETWOOD, USE AN ELECTRIC MOTOR. (CONTINUED ON PAGE 2)
RQ03009 · Wheel Separations
Opened Nov 21, 2003 · Closed Mar 17, 2004
Status: closed (inferred from source dates) · Wheels:lugs/nuts/bolts/studs
FLEETWOOD ENTERPRISES DETERMINED THAT THE WHEEL MOUNTING NUTS HAD BEEN INADEQUATELY TORQUED IN FIFTH WHEEL AND TRAVEL TRAILERS BUILT WITH ALUMINUM WHEELS SINCE JUNE 2002.FLEETWOOD ALERTEDOWNERS VIA A CUSTOMER ADVISORY NOTICE IN APRIL AND MAY OF 2003.ON OCTOBER 29, 2003, FLEETWOOD MADE A DEFECT DETERMINATION AND RENOTIFIED OWNERS. IN RESPONSE TO ODI'S INVESTIGATION, FLEETWOOD PROVIDED CERTAIN PRELIMINARY INFORMATION TO ODI, BUT THIS INFORMATION DOES NOT ADEQUATELY EXPLAIN THE REASON(S) FOR WHEEL SEPARATIONS, AND ODI CONTINUES TO BE CONCERNED THAT THE CORRECTIVE ACTIONS MAY NOT COMPLETELY ADDRESS THE ISSUE. FLEETWOOD'S CAMPAIGN DIRECTIVE REQUESTED THAT OWNERS RE-TORQUE THE WHEEL MOUNTING NUTS.ALTHOUGH RE-TORQUING IS CONSISTENT WITH GOOD MAINTENANCE PRACTICE, ODI IS CONCERNED THAT THE NEED TO FREQUENTLY RE-TORQUE THE WHEEL MOUNTING NUTS MAY BE INDICATIVE OF UNDERLYING DESIGN, ASSEMBLY, OR APPLICATION ISSUES THAT COULD AFFECT THE RETENTION INTEGRITY OF THE WHEEL MOUNTING SYSTEM.ALTHOUGH FLEETWOOD HAS ADVISED ODI THAT NO ADDITIONAL WHEEL SEPARATIONS HAVE OCCURRED SINCE THEIR OCTOBER 29, 2003 DEFECT REPORT AND ASSOCIATED OWNER NOTIFICATION, ODI WILL OPEN AN ENGINEERING ANALYSIS TO FURTHER INVESTIGATE THE ISSUES THAT MAY BE CONTRIBUTING TO WHEEL SEPARATIONS IN FLEETWOOD VEHICLES.
2002 Fleetwood Prowler Problems, Complaints & Recalls | Skip That Year
Illustration