ELECTRICAL SHORT, THE VEHICLE WAS IN MOTION AND THE VEHICLE STOPPED IN TRAFFIC. *AK
1993 Fleetwood Bounder
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all Bounder years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 1 of 11 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Service Brakes, Hydraulic. Review the 4 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Power Train. Review the 3 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Electrical System. Review the 2 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
Electrical System complaints
2 reportsTHE RIGHT/REAR SPRING BROKE TWICE. TT
Official recalls
394V003000 · Equipment:mechanical:integrated Jack/leveler/stabilizer
Oct 6, 1994
THE LEVELING JACK HYDRAULIC HOSE LINES ARE ROUTED CLOSE TO THE ENGINE EXHAUST MANIFOLD. THIS CAN CAUSE THE HOSE TO MELT AND RESULT IN A HYDRAULIC FLUID LEAK ONTO THE EXHAUST MANIFOLD.
Consequence & remedy
Consequence: HYDRAULIC FLUID MAY DRIP ONTO THE HOT EXHAUST MANIFOLD AND IGNITE CAUSING A FIRE. ALSO, LOSS OF LEVELING JACK HYDRAULIC FLUID WOULD MAKE IT IMPOSSIBLE TO RAISE OR LOWER THE LEVELING JACKS.
Remedy: DEALERS WILL REPLACE AND RELOCATE THE AFFECTED HYDRAULIC LINE.
94V105000 · Fuel System, Other:delivery:hoses, Lines/piping, And Fittings
Jun 9, 1994
THE LIQUID PROPANE GAS (LPG) PIPES AT THE REAR OF THE VEHICLE ARE ROUTED SO THEY CONTACT THE TAG AXLE DURING VERTICAL MOVEMENT. THIS CONTACT CAN RUPTURE THE LPG PIPE AND ALLOW LPG LEAKAGE.
Consequence & remedy
Consequence: CONSEQUENCE OF NON-COMPLIANCE: WHEN A MIXTURE OF LPG GAS AND OXYGEN IS EXPOSED TO A SOURCE OF IGNITION, AN EXPLOSION CAN RESULT AND IGNITE SURROUNDING COMBUSTIBLE MATERIALS.
Remedy: DEALERS WILL INSTALL A SECTION OF COPPER TUBING IN THE REAR OF THE VEHICLE TO REPLACE IRON PIPING IN AN AREA OUT OF THE SCOPE OF THE AXLE SWING AREA.
93V076000 · Vehicle Speed Control
Apr 30, 1993
WHILE OPERATING THE ENGINE IN REVERSE GEAR, ENGINE TORQUE CAUSES THE ENGINE TO ROLL, CAUSING THE THROTTLE MODULATOR CABLE ASSEMBLY TO CONTACT THE FLOOR AND BIND THE THROTTLE CABLE HOLDING THE THROTTLE IN AN OPEN POSITION.
Consequence & remedy
Consequence: THE THROTTLE CABLE BINDING WHILE THE THROTTLE IS IN ANOPEN POSITION CAUSES LOSS OF ENGINE SPEED CONTROL WHICH COULD RESULT IN ANACCIDENT.
Remedy: RELOCATION OF RAISED FLOOR SUPPORT HARDWARE ON THE BOX PORTION OF THE MOTORHOME.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0No exact-year investigations in this snapshot.
Illustration