Engine running fine when initially starts but after it warms up then starts missing , backfiring and stalls continuously. Car is a 1993 Corvette LT 1 engine with only 1,3000 miles. as told it is the OptiSpark that is bad which is part of the distributor. This car is a 40th Anniv car and is a collector car that GM manufactured…
Read full complaint
Engine running fine when initially starts but after it warms up then starts missing , backfiring and stalls continuously. Car is a 1993 Corvette LT 1 engine with only 1,3000 miles. as told it is the OptiSpark that is bad which is part of the distributor. This car is a 40th Anniv car and is a collector car that GM manufactured with questionable engine components that go bad not from wear as in this case of only 13,000 miles but being made with poor components that should be recalled ,
THE POWER STEERING GEAR INLET HOSE ON THESE VEHICLES CAN FRACTURE, CAUSING POWER STEERING FLUID TO SPRAY FROM HOSE INTO THE ENGINE COMPARTMENT.
Consequence & remedy
Consequence: THE POWER STEERING FLUID IS FLAMMABLE AND COULD CAUSEAN UNDERHOOD FIRE IF EXPOSED TO A SOURCE OF IGNITION.
Remedy: REPLACE THE POWER STEERING GEAR INLET HOSE WITH AN IMPROVED DESIGN.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
1
DP96006 · Brake Pull
Opened May 14, 1996 · Closed Oct 18, 1996
Status: closed (inferred from source dates) · Service Brakes, Hydraulic
THE PETITIONS STATED THAT:WE REPRESENT THE OWNER OF A 1990 CHEVROLET CORVETTE WHICH, WHEN THE BRAKES WERE APPLIED, SUDDENTLY, VIOLENTLY, AND UNEXPECTEDLY PULLS TO THE LEFT.THIS IS A INTERMITTENT DEFECT WHICH DOES NOT OCCUR WITH AN REGULARITY.
1993 Chevrolet Corvette Problems, Complaints & Recalls | Skip That Year