2017 Chevrolet Camaro

The vehicle has repeatedly lost electrical power while driving. During one incident at approximately 50 mph, the vehicle’s electronics shut off and power steering assist stuttered/lost assist for several seconds, causing reduced vehicle control. During another incident while turning/in a turning lane, the engine and electronics shut off and the vehicle had to be restarted. Afterward, the vehicle struggled to restart and displayed a warning to drive cautiously due to power steering loss. The vehicle also has recurring hot-start/no-start symptoms and electrical loss after shutting the engine off. Based on my research, GM Bulletin 19-NA-052 appears to describe a related condition on 2016–2019 Chevrolet Camaro 6.2L vehicles where circuit 1 may short to ground at the starter heat shield, causing loss of electrical power or failure to start, with repair involving the starter solenoid cable. This appears to be a safety-related manufacturing/design defect because the vehicle can lose electrical power and steering assist while in motion. The vehicle/component is available for inspection upon request.

The power steering locks up and message appears saying power steering enabled please drive carefully. When this happens the steering wheel becomes very hard to turn, sometimes making it impossible to turn right or left if it is a sharp turn. I then have to shut car off and start it again and move steering wheel in order for it to steer properly again. Sometimes I have to repeat this process over and over again while driving from point A to B. Then at other times I have no issue. As of today(4/27/2026) this has been happening on a daily basis for the past 2 weeks. Before then, it was occasionally beginning in November 2025. A friend told me there was a recall but there are none listed for this car on the dealership site. When I googled recalls, it stated there were 3 critical recalls 1 being this power steering issue.

The back glass on my convertible is separating from the fabric. This isn't something I did or anyone else has done. This is a huge problem with thousands of camaro owners that have a convertible. Something needs to be done because its obvious that the design that was used on mine and many many others alike is a flawed and something that we should not have to deal with. Right now my only options are to buy a new top and spend over $3,000 to have it installed or buy some glue and rig it up myself but I refuse to do that. Please, this is my first Camaro and I love it and just want it fixed. I don't see any Mustangs or other convertibles having this issue. Attached with my photos is a screenshot from a Facebook post with over 300 comments of people having the same issue and also a service bulletin that was put out a while back. There needs to be a recall on this issue or lawsuits are going to start being filed. Thats what most people are threatening to do now.

The contact owns a 2017 Chevrolet Camaro. The contact stated that while driving 75 MPH, the brake pedal became firm while depressed. There was no warning light illuminated. The contact used excessive force while depressing the brake pedal to stop the vehicle. Upon investigation, the contact associated the brake failure with NHTSA Campaign Number: 18V576000 (Service Brakes, Hydraulic); however, the VIN was not under recall. The vehicle was not yet diagnosed or repaired. Neither the dealer nor the manufacturer was notified of the failure. The failure mileage was approximately 85,000.