2025 Chevrolet Blazer

windshield leaking water inside of drivers compartment, headliner & side pillars (causing stained areas) as well as the top of onstar and electrical buttons on the overhead console . Found wet cup holder. Vehicle does not have a sun roof. GM is aware of this issue from the factory GM plant in Ramos Arizpe, Mexico. This defect is because of lack of not being sealed properly during the assembly process. The windshield has a factory OEM rubber seal attached to a NEW windshield. This rubber seal is NOT a part that can be purchased separately to fix the problem. By replacing the entire windshield with the new factory rubber seal and the channel that the entire windshield fits into is resealed with urethane should fix the issue.. Trying to reuse the current windshield & rubber seal and using sealer to reinstall it stretches out the rubber seal & will still leak. This leak can get into the electrical controls for safety system overhead controls. Extra care must be taken to remove the windshield as to not damage the roof line in anyway. Vehicle is going back into dealership to fix issue again. Vehicle was resealed with existing windshield and showing signs of leaking on L&R pillars.

I was driving on a rainy day, and noticed my windshield wipers were not working. I tried adjusting wiper speed and even the spray function, which sprayed but did not wipe. At this point I had driven over a mile and had to pull over because visibility through the windshield had gotten so bad. I restarted the car and the wipers functioned normally again. There were no warning lights of any kind or software notifications, and the wipers had worked previously that day.