IllustrationTHE ABS FAILED AND THE ABS LIGHT REMAINS ON. YH
1991 Chevrolet Blazer
Owner reports · Recalls · Investigations
More warning signs than most Blazer years
Owner complaints for the 1991 Chevrolet Blazer are substantially higher than the model-year median of 32.
About this comparison →How this year compares
Owner complaints by model year
Compare all Blazer years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 5 of 222 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Service Brakes, Hydraulic. Review the 125 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Seat Belts. Review the 26 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Electrical System. Review the 16 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
32 crash reports15 fire reports9 injury reports
What owners actually said
222 reportsWHEN APPLYING THE BRAKES VEHICLE DID NOT SLOW DOWN/PULSATE, OR SKID. DRIVER REAR ENDED ANOTHER VEHICLE. DEALER HAS NOT SEEN VEHICLE. *AK
INTERMITTENTLY WHEN THE BRAKES ARE APPLIED THE PEDAL GOES TO THE FLOOR, CAUSING A MINOR COLLISION . DEALER AND MANUFACTURER HAVE BEEN NOTIFIED. *AK
VEHICLE WAS PARKED IN A PARKING SPACE WHEN ANOTHER VEHICLE RAN IN THE BACK OF CONSUMER'S PARKED VEHICLE AND THE VEHICLE EXPLODED,. DEALER / MANUFACTURER WERE NOT CONTACTED AT THIS TIME. ASKING NHTSA TO PROVIDE INFORMATION ON THIS MATER.*AK
WHILE DRIVING AND ATTEMPTING TO STOP, VEHICLE IS IDLES AND SUDDENLY ACCELERATES. *AK
DEFECTIVE PAINT PEELING AND CHIPPING, BRAKES ONE OUT OF 4 WORK,DIGITAL DISPLAY ON DASH.
VEHICLE HAS ABS BRAKES. WHEN BRAKES ARE APPLIED, THEY ARE HARD & VERY QUICK. THE VEHICLE WOULD EXPERIENCE EXTENDED STOPPING DISTANCE BEFORE COMING TO A STOP. HAD REARENDED ANOTHER VEHICLE DUE TO LACK OF ABS BRAKING POWER. HAD BRAKES REPAIRED AT DEALER'S ON 8/11/99. THE ACCIDENT HAPPENED ON 8/13/99. *AK
THE ABS LIGHT STAYS ON, WHEN THE LETTER P LIGHT COMES, THE VEHICLE HAS NO BRAKING POWER. THE DEALER AND MNUFACTURER HAVE BEEN NOTIFIED. *AK
ON TWO OCCASIONS VEHICLE EXPERIENCED ERRATIC OPERATION OF THE ABS BRAKING SYSTEM. ON ONE OCCASION CONSUMER HAD TO APPLY BRAKE PEDAL HARD TO GET THE VEHICLE TO STOP PROPERLY TAKEN TO DEALER, AND CODE WAS RESET ON ABS EBCM. ON THE SECOND OCCASION, VEHICLE EXPERIENCED EXTENDED STOPPING DISTANCE. TAKEN TO DEALER AND DETERMINED…
Read full complaint
ON TWO OCCASIONS VEHICLE EXPERIENCED ERRATIC OPERATION OF THE ABS BRAKING SYSTEM. ON ONE OCCASION CONSUMER HAD TO APPLY BRAKE PEDAL HARD TO GET THE VEHICLE TO STOP PROPERLY TAKEN TO DEALER, AND CODE WAS RESET ON ABS EBCM. ON THE SECOND OCCASION, VEHICLE EXPERIENCED EXTENDED STOPPING DISTANCE. TAKEN TO DEALER AND DETERMINED THAT EBCM NEEDS TO BE REPLACED. PAVEMENT WAS WET ON BOTH OCCASIONS. ALSO, INTERMITTENTLY VEHICLE WOULD JERK WHILE STOPPING, AND ABS SENSOR LIGHT CAME ON. SEEKING HELP FROM NHTSA IN THIS MATTER. *ML
WHEN DRIVING AT ANY SPEED AND APPLYING THE BRAKES, BRAKE PEDAL GOES STRAIGHT TO THE FLOORBOARD. ALSO, ABS LIGHT IS ON, INDICATING AN ABS BRAKE FAILURE. *AK
Official recalls
499V193000 · Service Brakes, Hydraulic:antilock/traction Control/electronic Limited Slip
Jul 19, 1999
VEHICLE DESCRIPTION: CERTAIN 4-WHEEL DRIVE PICKUP TRUCKS AND SPORT UTILITY VEHICLES EQUIPPED WITH ABS (ANTILOCK BRAKING SYSTEM) MANUFACTURED FROM SEPTEMBER 1989 THROUGH AUGUST 1996. UNDER CERTAIN DRIVING CONDITIONS THE SWITCH WHICH SIGNALS THE ABS SYSTEM WHETHER THE VEHICLE IS IN 2-WHEEL OR 4-WHEEL DRIVE CAN MALFUNCTION CAUSING INCREASED STOPPING DISTANCES DURING ABS STOPS WHILE IN THE TWO-WHEEL DRIVE MODE.
Consequence & remedy
Consequence: IF THIS OCCURRED AT A TIME WHEN MINIMUM STOPPING DISTANCE WAS REQUIRED, A VEHICLE CRASH COULD OCCUR WITHOUT PRIOR WARNING.
Remedy: DEALERS WILL REPLACE OR REPAIR THE 4-WHEEL/2-WHEEL DRIVE SWITCH.
96V142000 · Seat Belts:rear/other
Jul 31, 1996
THESE VEHICLES EXHIBIT A CONDITION IN WHICH A REAR SEAT BELT BUCKLE RELEASE BUTTON CAN STICK IN THE UNLATCHED (DOWN) POSITION UNDER CERTAIN CONDITIONS BECAUSE THE BUCKLE ASSEMBLY CAN MOVE INSIDE THE SEAT BELT COVER. IF THE COVER MOVES FAR ENOUGH, IT CAN CREATE AN INTERFERENCE CONDITION WITH THE LATCH RELEASE BUTTON. WHEN IT DOES, THE SEAT BELT BUCKLE CANNOT BE LATCHED.
Consequence & remedy
Consequence: THE REAR BELTS MAY NOT HOLD AN OCCUPANT IN THE EVENT OF A VEHICLE ACCIDENT INCREASING THE RISK OF PESONAL INJURY.
Remedy: DEALERS WILL REPLACE THE THREE REAR-SEAT BELT BUCKLES (ONE ASSEMBLY) WITH A NEW, REVISED DESIGN.
93V119000 · Service Brakes, Hydraulic:foundation Components:disc:rotor
Aug 2, 1993
SEVERE CORROSION DUE TO ROAD SALT AT THE JOINT OF THE STAMPED STEEL CENTER SECTION AND THE CAST OUTER SECTION CAN CAUSE THE SECTIONS TO SEPARATE.
Consequence & remedy
Consequence: SEPARATION OF THE ROTOR SECTIONS CAN CAUSE LOSS OFBRAKING ABILITY IN THE AFFECTED WHEEL. THIS COULD RESULT IN INCREASED STOPPINGDISTANCE AND/OR LOSS OF VEHICLE CONTROL AND AN ACCIDENT.
Remedy: REPLACE THE FRONT BRAKE ROTORS WITH NEW ROTORS WITH A CORROSION PROTECTION COATING. HOWEVER, IF REPLACEMENT OF BRAKE LININGS ARE NECESSARY, IT WILL BE DONE AT OWNER'S EXPENSE SINCE BRAKE LININGS ARE NORMAL MAINTENANCE ITEMS.
91V108000 · Fuel System, Gasoline:storage
Jun 21, 1991
VEHICLES HAVE BEEN SHIPPED WITH THE FUEL TANK SENDER SEAL OUT OF POSITION.
Consequence & remedy
Consequence: IN THE EVENT OF ROLLOVER ACCIDENT, AN OUT OF POSTIONSEAL COULD ALLOW FUEL SPILLAGE IN EXCESS OF THE AMOUNT PRESCRIBED BY FMVSS 301.SPILLED FUEL COULD IGNITE NEAR AN IGNITION SOURCE.
Remedy: REPLACE SENDER SEALS.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
8EA95031 · Rear Seat Belt Failure
Opened Oct 31, 1995 · Closed Jul 31, 1996
Status: closed (inferred from source dates) · Seat Belts:rear/other
COMPLAINTS INDICATE THAT THE REAR SEATBELT BUCKLES DO NOT WORK, WHICH PREVENTS USAGE OF THE BELTS.
EA94038 · Abs Braking System
Opened Oct 31, 1994 · Closed Feb 28, 2000
Status: closed (inferred from source dates) · Service Brakes, Hydraulic
THIS INVESTIGATION RESULTED IN A SAFETY RECALL, 99V-193, AND A SERVICE CAMPAIGN, 99I-006.
Additional source detail variants (2)
Service Brakes, Hydraulic
THIS INVESTIGATION RESULTED IN A SAFETY RECALL, 99V-193, AND A SERVICE CAMPAIGN, 99I-006.
Service Brakes, Hydraulic
THIS INVESTIGATION RESULTED IN A SAFETY RECALL, 99V-193, AND A SERVICE CAMPAIGN, 99I-006.
EA94029 · Engine Compartment Fires
Opened Jul 29, 1994 · Closed Jul 31, 1996
Status: closed (inferred from source dates) · Engine And Engine Cooling
AN ALLEGED MALFUNCTION IN THE ATLERNATOR RESULTING IN ENGINE COMPARTMET FIRES.
PE94046 · Abs Braking System Fails
Opened Jun 17, 1994 · Closed Oct 31, 1994
Status: closed (inferred from source dates) · Service Brakes, Hydraulic
There is no summary currently available
EA92015 · High Idle Flare
Opened May 22, 1992 · Closed May 28, 1993
Status: closed (inferred from source dates) · Vehicle Speed Control:linkages
There is no summary currently available
PE92001 · High Idle Flare
Opened Jan 7, 1992 · Closed May 22, 1992
Status: closed (inferred from source dates) · Vehicle Speed Control:linkages
There is no summary currently available
EA91028 · Brake Failure
Opened Jun 10, 1991 · Closed Jun 30, 1992
Status: closed (inferred from source dates) · Service Brakes, Hydraulic
===
PE91052 · Brake Failure
Opened Feb 22, 1991 · Closed Jun 10, 1991
Status: closed (inferred from source dates) · Service Brakes, Hydraulic
There is no summary currently available