2022 CAN-AM Ryker

The issue with my 2022 rally my dealership said they can recalibrate the sensor but this is the 2nd time it has been braking. I was coming home and on sharp curves roads it start to brake left but turning right was fine i was able to go around 50mph but going left it was slowing me down to 10-35mph i even had a guy in a BMW tailgate me because my bike would slow down. This is extremely dangerous and can get me killed.

On left hand turns only never right turns, if you are going over 30 mph the ABS/Stability controls turns on and make the wheels wobble and slows it down in the turn. This abrupt slow down cause vehicles behind me to slam on breaks because there is no brake lights warning them of the slow down. I took it to a shop and after a month in the shop, they replaced the yaw rate sensor which did not fix the issue. I have put the bike in the garage for a month now because it is too dangerous to drive until this issue is solved.

The cruise control will disconnect randomly causing sudden deceleration. Sometimes it will go off almost immediately after setting it and others it may stay engaged for several miles. It disengaging randomly is a safety issue as I’m not expecting the sudden deceleration and it could cause a vehicle that is following closely to hit me. This issue has been present since I purchased the vehicle and it has been looked at 3 times by the dealer. The first time they adjusted the brake pedal switch, the second time that switch was replaced under recall and the last time the cruise control cable was replaced.

This motorcycle continues to go into "Limp Mode". This has happened now two times with no explanation from the manufacture as to why. The bike will lose engine power and immediately drop to speeds no higher than 55mph. This was advised to dealer and they were very familiar with this, and initially told me the repairs were denied by BRP, but that they covered the issue and fixed it. Less than 1 week later, the same thing happened. The check engine light comes on and the gauges read VSS Fault, Limp Mode. This is very unsafe as there is no explanation as to why this happens and engine power is loss at any given moment. I fear riding the bike on the freeway at high speeds and this happening and potentially causing me to be hit by another vehicle from the immediate loss of power. This is a well known issue and I don't feel this bike is safe for the road.