2022 CAN-AM Ryker

When entering a left hand turn at moderate speed, the vehicle will go into a lurching, bucking, hesitation period, usually when under slight or moderate acceleration. This results in an uncontrolled wobble that will eventually smooth out but can also result in a sudden burst of power that tends to rapidly propel the vehicle further to the left unless the throttle is quickly relaxed. Hard to describe, but the sensation feels like you are being “squirted” out of the turn. I first noticed this barely a month after I took possession of the machine and thought it might be a normal handling trait. As I became more acquainted with the various user’s groups, I find it was not normal and a much more serious problem that apparently hasn’t been successfully addressed by the manufacturer over the years it has been reported. Unlike some of the others who have reported similar occurrences, my vehicle has not displayed any error codes on the display screen, nor has it gone into a limp mode. Due to these conditions, I will not take this vehicle on any road trips for fear of being stranded or involved in an accident being caused by this dangerous handling anomaly. I love this vehicle, but due to this issue, I don’t feel it is safe.

Vehicle developed right wheel wobble on left turns over 90 degrees, when speed is ~40 mph or above. Unable to safely make turn, at speed. 3 trips to dealership, issue persists. Vehicle threw a “VSS fault” and went into “limp mode” preventing me from driving over 40mph - was in the mountains, 60 miles from home. Serious safety issue, feel unsafe on the vehicle, no longer willing to ride.

Vehicle repeatedly goes in to limp mode for VSS faults related to steering codes. Dealers are unable to repair and report that many other of the same model have the same problem. Many other owners in the online community report the same issue with no fix in sight. The vehicle is essentially unusable and the manufacturer does not appear to have any intent to remedy the situation.

Bike intermittently goes into limp mode for VSS fault and codes related to the steering rate/yaw sensor. Had the problem confirmed and the manufacturer-recommended steering upgrade done by local Can-am dealer but the VSS fault and limp mode still happens, intermittently. My understanding, from reading forums online, is that this is a very common issue. I would rather they turn the VSS system off entirely than than have the vehicle be nearly unusable at random intervals. Getting slowed down to a max speed of 50 mph here in AZ where most of the highway speeds are 65 mph or higher, with no warning, is quite dangerous and nerve-wracking. I live right off of a 65 mph highway so driving a bike that randomly limits itself to 50 mph is not safe, let alone convenient.

On left hand turns only never right turns, if you are going over 30 mph the ABS/Stability controls turns on and make the wheels wobble and slows it down in the turn. This abrupt slow down cause vehicles behind me to slam on breaks because there is no brake lights warning them of the slow down. I took it to a shop and after a month in the shop, they replaced the yaw rate sensor which did not fix the issue. I have put the bike in the garage for a month now because it is too dangerous to drive until this issue is solved.

When making left turns, vehicle's rear tire wobbles severely. When doing this, it also causes the handle bars to try and straighten out during the turn almost causing the vehicle to hit a curb or guardrail. This only happens on left turns, never on right turns. After incident, the rear tire suspension feels spongy. I have taken the vehicle back to the dealer for this issue. The had it for 5 weeks and could never reproduce the issue. I have also contacted Can Am BRP about this issue who only recommended that I take the vehicle back to the dealership.

My vehicle start to lose control when I drive around left or right corner the rear end felt like it was bucking or slipping. The VSS fault error and Limp Mode kicked in and the speed doesn't really matter once you are over 20 mph. My vehicle is at the dealership as of 8/13/23 to replace the pitman arm to see if that fix the problem. The VSS fault error happens about 4 times since I brought the vehicle.

I have a 2022 Can-Am Ryker 900 sport. when I purchased it around a week or two later, my left brake and wheel started squeaking loud. I returned it to the dealer. One of the service men said its brand new brakes and tires give it time to wear down.low brake warning came across the screen and my handlebars started feeling loose,a lot of play. I returned it again. They checked my handlebars and fixed my front truck and said my brand new brakes were fine. It wasn’t my handlebars. It was my suspension starting to malfunction making my left brake pad wear uneven low brake warning came across again. I returned it again for the recalls the service man assured me this will fix my problem. last night August 5,2023 I was out, riding with friends, proceeded into a curve, and my handlebars would not allow me to turn my wheels. My left wheel seemed as though it was trying to lock up. I could not turn the curve.it started to do what they call the Death turn. Two of my friends almost ran into the back of me because the bike slowed itself down, My check engine light started flashing VVS fault code came across the screen, I end up hitting the curb scratching my rim, and now the bike is on limp mode.