When problems were reported
Mileage at the reported incident
Limited mileage data: 0 of 0 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
NHTSA owner reports · September 18, 2026 snapshot.
Official recalls
11Aug 21, 2026
Altec Industries, Inc. (Altec) is recalling certain 2019-2026 AN Series, 2023 AA Series, 2022-2026 Digger Derrick, and 2025 AM Series vehicles. The Bendix automatic braking system was not recalibrated after relocating the front radar box.
Consequence & remedy
Consequence: An improperly calibrated system may have a delayed braking response, increasing the risk of a crash.
Remedy: Altec will update the collision mitigation system with the revised the parameters, recalibrate, and test the system, free of charge. Owner notification letters are expected to be mailed October 16, 2026. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN-3356.
Feb 6, 2026
Altec Industries, Inc. (Altec) is recalling certain 2021-2025 Digger Derrick and 2021-2025 AM Series Aerial Device vehicles. The chassis engine may start unintentionally due to a missing diode in the Altec power distribution module.
Consequence & remedy
Consequence: An engine that starts unexpectedly increases the risk of injury to anyone near the engine compartment during maintenance operations.
Remedy: Altec will provide instructions to inspect the power distribution module for a diode, and provide a repair kit as necessary, free of charge. Owner notification letters were mailed March 27, 2026. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN-3281.
Aug 29, 2025
Altec Industries Inc. (Altec) is recalling certain 2011-2025 Aerial Device, Digger Derrick, and 2022-2025 Service Body vehicles. The cable step wire rope assembly may be improperly secured, which can allow the cable entry step to detach from the vehicle.
Consequence & remedy
Consequence: A cable step that fails during use increases the risk of injury.
Remedy: Altec will provide owners with instructions to inspect the cable crimps. If the cables are improperly crimped, Altec will provide instructions and a kit to replace the wire rope assemblies. Repairs will be performed free of charge. Owner notification letters were mailed October 24, 2025. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN-3246.
Sep 14, 2023
Altec Industries, Inc. (Altec) is recalling certain 2004-2023 DL42 and DL45 Digger Derricks. The incorrect hydraulic load holding valve may have been installed, which can cause the winch to lower uncontrollably and the load to fall.
Consequence & remedy
Consequence: An uncontrolled load falling increases the risk of injury to personnel or others nearby.
Remedy: Altec will replace the load holding valve, free of charge. Owner notification letters are expected to be mailed October 6, 2023. Owners may contact Altec's customer service at 1-877-462-5832. Altec's number for this recall is MAB 3113.
Jul 27, 2023
Altec Industries, Inc. (Altec) is recalling certain 2022-2023 Aerial Devices (AT, TA, L44, L45, LR8, AA, AM, AN) and D series Digger Derricks (DH, DL, DM, DT). The power inverter that converts electrical DC power to AC power may have been installed without a circuit breaker to protect the AC output circuit.
Consequence & remedy
Consequence: Without a circuit breaker, the AC circuit may overheat, increasing the risk of a fire.
Remedy: Altec will install a 20-amp circuit breaker in the AC circuit, free of charge. Owner notification letters were mailed December 21, 2023. Owners may contact Altec's customer service at 1-877-462-5832. Altec's number for this recall is CSN 3103.
May 18, 2023
Altec Industries, Inc. (Altec) is recalling certain 2021-2023 Aerial Devices, Digger Derricks, Service Bodies and Cranes. Water can leak into the strobe lights, which could cause an electrical short-circuit.
Consequence & remedy
Consequence: An electrical short-circuit can increase the risk of a fire.
Remedy: Altec will provide instructions to inspect the light assembly for moisture and install a new fuse. If moisture is found or the light is inoperative, a light replacement kit will be installed. Repairs will be performed free of charge. Owner notification letters are expected to be mailed July 14, 2023. Owners may contact Altec's customer service at 1-877-462-5832. Altec's number for this recall is CSN 3079.
May 11, 2023
Altec Industries, Inc. (Altec) is recalling certain 2021-2023 DT85 Digger Derricks. The Boom pressure limiter may allow the boom to lift loads above the rated capacity and over the Hydraulic Overload Protection (HOP) setting.
Consequence & remedy
Consequence: Lifting loads above the boom capacity could overload the unit and cause instability, increasing the risk of injury.
Remedy: Altec will provide instructions to owners to test the boom lift pressure limiter setting and set it to the correct pressure, free of charge. Owner notification letters are expected to be mailed July 7, 2023. Owners may contact Altec's customer service at 1-877-462-5832. Altec's number for this recall is CSN 3078.
May 4, 2023
Altec Industries, Inc. (Altec) is recalling certain 2017-2022 DC, DB, DL, DM, DH, DT, and D2/3/4000 Digger Derricks. The hardware that secures the removable auger hex extension bar to the drive unit coupler was not installed, which may cause it to detach.
Consequence & remedy
Consequence: An auger extension bar that detaches while the digger drive unit is deployed, can increase the risk of injury to nearby personnel.
Remedy: Altec will provide instructions for owners to inspect the auger extension assembly for missing hardware. If hardware is found to be missing, a replacement kit will be provided by Altec, free of charge. Owner notification letters are expected to be mailed June 30, 2023. Owners may contact Altec's customer service at 1-877-462-5832. Altec's number for this recall is CSN 3076.
Mar 30, 2023
Altec Industries, Inc. (Altec) is recalling certain 2016-2022 DM, DH, DC, DL, D2000, D3000, and D4000 series digger derricks, and AM55 aerial devices. The base of the rear pole rack may be missing a weld.
Consequence & remedy
Consequence: A missing weld on the rear pole rack can lead to a crack that could cause the pole and rack to drop in height, increasing the risk of an injury.
Remedy: Altec will inspect the rear pole rack mounting plate, and if necessary, replace any required welds, free of charge. Owner notification letters are expected to be mailed May 26, 2023. Owners may contact Altec's customer service at 1-877-462-5832. Altec's number for this recall is CSN 3064.
Jan 12, 2023
Altec Industries, Inc. (Altec) is recalling certain 2022 DC & DM Series Digger Derrick vehicles. During production, an incorrect bolt may have been used to attach the derrick rotation bearing.
Consequence & remedy
Consequence: An incorrect bolt in the derrick rotation bearing may cause the adjacent bolts to be overloaded during operation, which could cause separation of the rotation bearing, and increase the risk of an injury.
Remedy: Altec will inspect and if an incorrect bolt is found, replace the bolts affected bearing race, free of charge. Owner notification letters are expected to be mailed March 10, 2023. Owners may contact Altec's customer service at 1-877-462-5832. Altec's number for this recall is CSN 3045.
May 18, 2022
Altec Industries, Inc. (Altec) is recalling certain 2016-2022 E-series & DH-H series Digger Derricks. The relay connectors may have been reattached to the incorrect plug after a stability test was performed. If the connections are not correct, the hydraulic overload protection system will not function.
Consequence & remedy
Consequence: A nonfunctional overload protection system may result in the operator unknowingly overloading the system, increasing the risk of injury.
Remedy: Altec will inspect and reattach the connectors, if necessary, free of charge. Owner notification letters were mailed on June 29, 2022. Owners may contact Altec's customer service at 1-877-462-5832. Altec's number for this recall is CSN 858.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
Illustration