IllustrationSame issue with the '22/'23 Honda Civic, which the Integra is based on -- "sticky steering". AutoBlog reported on it at https://www.autoblog.com/2023/03/21/nhtsa-honda-civic-sticky-power-steering-investigation/.
2023 Acura Integra
Owner reports · Recalls · Investigations
More warning signs than most Integra years
Owner complaints for the 2023 Acura Integra are substantially higher than the model-year median of 21.
About this comparison →How this year compares
Owner complaints by model year
Compare all Integra years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 4 of 207 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Steering. Review the 188 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Lane Departure. Review the 12 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Engine. Review the 5 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
5 crash reports0 fire reports2 injury reports
Steering complaints
188 reportsThe steering wheel sticks at times. Driving straight and in turns. It's a slight stick, but increasingly more noticeable. While driving straight it happens if I don't touch the wheel for a few seconds. Then I'll need to make a minor correction and it's stuck. I have to put some decent pressure on the wheel to make it unstuck, w…
Read full complaint
The steering wheel sticks at times. Driving straight and in turns. It's a slight stick, but increasingly more noticeable. While driving straight it happens if I don't touch the wheel for a few seconds. Then I'll need to make a minor correction and it's stuck. I have to put some decent pressure on the wheel to make it unstuck, which causes an over-correction. If i steadily make corrections it doesn't stick. Same in a turn. If I am making a slow or wide turn, wheel stays in same position for a second, it doesn't just roll out of the turn easily. I have to force it to come out of the turn. Again once it's unstuck it feels fine. Leaving it in one position for more than a second or two initiates the stuck.
Car at around 3K miles. The steering at higher speeds >40mph started to stick and takes some force to steer. It is most noticeable when driving in a straight line and the steering wheel will require some force to turn but then will be more fluid. But then returning to a straight line causes the same sticky feeling. Because the s…
Read full complaint
Car at around 3K miles. The steering at higher speeds >40mph started to stick and takes some force to steer. It is most noticeable when driving in a straight line and the steering wheel will require some force to turn but then will be more fluid. But then returning to a straight line causes the same sticky feeling. Because the steering sticks, it requires an overcorrection when trying to adjust directions.
Streering wheels when going straight on freeway speeds gets sticky so making minor adjustments tends to to be hard
This has started after approximately 5,000 miles on the vehicle. At highway speeds the steering wheel will feel sticky and/or jump when trying to apply small inputs. For example, after a few seconds of holding the steering wheel in a straight position or in a constant long radius turn, the steering wheel is resistant to moveme…
Read full complaint
This has started after approximately 5,000 miles on the vehicle. At highway speeds the steering wheel will feel sticky and/or jump when trying to apply small inputs. For example, after a few seconds of holding the steering wheel in a straight position or in a constant long radius turn, the steering wheel is resistant to movement and increased force is required to bring the steering back to center. This results in small over-corrections leading to a slight weaving while trying to stay in a lane.
I have noticed that the steering wheel seems to "stick" or feel "notchy" when making small adjustments from center (12 o clock) position. This is most noticeable when driving on a long, straight stretch of freeway requiring minor adjustments to keep the car centered. The steering will stick when attempting to making small correc…
Read full complaint
I have noticed that the steering wheel seems to "stick" or feel "notchy" when making small adjustments from center (12 o clock) position. This is most noticeable when driving on a long, straight stretch of freeway requiring minor adjustments to keep the car centered. The steering will stick when attempting to making small corrections, requiring extra force to overcome resistance. After providing more force, the steering will suddenly give way, typically causing overcorrection in the opposite direction
While driving at highway speeds (45-75 mph) the steering will begin to stick. The steering wheel requires extra force to make an adjustment. After getting past the friction point, the steering is normal but will soon gain the friction point back. On highway ramps, the steering will hold the turn without any additional pressure a…
Read full complaint
While driving at highway speeds (45-75 mph) the steering will begin to stick. The steering wheel requires extra force to make an adjustment. After getting past the friction point, the steering is normal but will soon gain the friction point back. On highway ramps, the steering will hold the turn without any additional pressure and fails to return to the straight position. Added force required to get it back to straight.
I was driving on December 19, 2022 and noticed difficulty steering at cruising speeds (45mph). The steering became resistant to small movements. It did not move smoothly when I turned it to make minor adjustments, it required extra force to move from a still position. Once I applied enough force to turn, it turned freely. At lo…
Read full complaint
I was driving on December 19, 2022 and noticed difficulty steering at cruising speeds (45mph). The steering became resistant to small movements. It did not move smoothly when I turned it to make minor adjustments, it required extra force to move from a still position. Once I applied enough force to turn, it turned freely. At low speeds such as turning in a parking lot, I did not notice any problems, but upon reaching approx 40mph, I did notice the problem. This makes the vehicle more difficult to operate in an unexpected manner and makes a collision more likely, thus putting the safety of myself, my passengers, and other drivers at risk. There were no warning lamps or messages. The only related symptom was that the CarPlay navigation display was not updating regularly during this drive. Normally this system works well, but on this day it was updating my position every 30 seconds or so. When I unplugged the USB cable between my iPhone and the vehicle, the steering issue disappeared. Additional details provided here: https://www.integraforums.com/forum/threads/sticky-jerky-steering-carplay-usb-related.50610/#post-823807 The contact stated that the issues they are experiencing are similar, if not the same, as the Honda Civic and Honda Civic Si.
Official recalls
224V744000 · Steering
Oct 3, 2024
Honda (American Honda Motor Co.) is recalling certain 2023-2025 Acura Integra, Civic Type R, CR-V Hybrid, CR-V, HR-V, 2022-2025 Civic, Civic Hatchback, 2024-2025 Acura Integra Type S, 2025 CR-V Fuel Cell EV, Civic Hybrid, and Civic Hatchback Hybrid vehicles. The steering gearbox assembly may have been manufactured incorrectly, which can cause excessive internal friction and lead to difficulty steering the vehicle.
Consequence & remedy
Consequence: Difficulty steering can increase the risk of a crash.
Remedy: Dealers will replace the worm gear spring and redistribute or add grease as necessary, free of charge. Owner notification letters were mailed November 18, 2024. Owners may contact Honda Customer Service at 1-888-234-2138. Honda's numbers for this recall are SJS, MJU, QJT and VJV.
23V430000 · Service Brakes, Hydraulic:antilock/traction Control/electronic Limited Slip:control Unit/module
Jun 15, 2023
Honda (America Honda Motor Co.) is recalling certain 2023 Civic, Acura RDX, Acura Integra, and 2022 Honda Accord vehicles. A ball valve in the vehicle stability assist (VSA) modulator may leak brake fluid, which can result in unintended vehicle movement when the brake hold feature is engaged or an unexpected increase in brake pedal travel.
Consequence & remedy
Consequence: Unintended vehicle movement or an unexpected increase in brake pedal travel can increase the risk of a crash or injury.
Remedy: Dealers will replace the VSA modulator, free of charge. Owner notification letters were mailed July 24, 2023. Owners may contact Honda customer service at 1-888-234-2138. Honda's numbers for this recall are OEJ, XEK, AEY, XEX and OEW.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
1EA23003 · Momentary Increased Steering Effort
Opened Nov 29, 2023 · Closed Jan 28, 2025
Status: closed (inferred from source dates) · Steering
On November 29, 2023, the Office of Defects Investigation (ODI) opened this Engineering Analysis (EA23003) to assess allegations of momentary increase in steering effort in model years (MY) 2022-2023 Honda Civic, 2023MY Honda CR-V, and 2023MY Acura Integra vehicles (subject vehicles). The complaints received by ODI alleged that the subject vehicles experienced a momentary increase in required steering effort (described as “sticky steering”) occurring mostly at highway speeds after driving for an extended amount of time; these complaints could not be duplicated during dealer service technicians’ quick test drives. The complaints had been received over the previous two years with most occurring with low vehicle mileage. The steering gear of these vehicles is aided by an electrical power assist unit. This power assist unit inputs force on the steering rack via a worm gear and worm wheel assembly. During PE23005, Honda stated this condition of momentary increase in steering effort occurs due to two factors within this power assist unit. First, during manufacturing, the steering worm wheel goes through annealing and component conditioning processes. These processes cause internal stress and strain within the steering worm wheel. This strain is slowly released over the first few months of the vehicle life. Over time, the released strain causes deformation of the teeth on the worm wheel, causing the worm gear to catch on the worm wheel. This catching results in the driver’s momentary increased steering effort. Second, the manufacturing process did not guarantee consistent grease application and, therefore, some subject vehicles received insufficient grease which contributed to the momentary increase in steering effort. During EA23003, ODI further analyzed the potential safety related consequences of the momentary increase in steering effort. NHTSA’s Vehicle Research and Test Center (VRTC) duplicated the allegations of increased steering effort. In addition, VRTC discovered the steering worm wheel and worm gear tended to push grease out of the meshing area, resulting in large amounts of grease resting on top of the worm wheel. Information Request responses collected and reviewed by ODI showed Honda had also discovered this additional root cause during NHTSA’s EA. In addition, Honda discovered the preload of the worm wheel gear spring was set too high, increasing the gear slide load and resulting in higher friction and increased torque fluctuation when steering. The number of consumer complaints made to ODI continued to increase with the expansion of scope from the PE to the EA. Additionally, during EA23003, ODI received ten complaints alleging a crash, in addition to the 13 complaints ODI had received as of the time it opened EA23003. In total, 23 crashes have been reported to ODI due to this alleged defect. On October 3, 2024, Honda filed NHTSA Recall No. 24V-744 to address this defect. The recall will provide consumers with a new steering worm wheel gear spring with a decreased load. Additionally, dealerships will add additional grease and relocate any grease sitting on top of the worm wheel back into the meshing area. The scope of this recall includes all Honda vehicles that were manufactured with this specific improperly produced steering worm wheel and spring. In view of the recall action being taken by Honda, ODI is closing EA23003. NHTSA reserves the right to take additional action if warranted by future circumstances. To review the ODI reports cited in the Closing Resume ODI Report Identification Number document, go to NHTSA.gov.