IllustrationEA888 HAS A KNOWN TIMING CHAIN AND CHAIN TENSIONER ISSUE THAT CAUSES ENGINE FAILURE.
2008 Volkswagen Gti
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all Gti years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
360–25K
725–50K
350–75K
575–100K
4100–150K
1150K+
56 reports with mileage · 11 unknown
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Power Train. Review the 40 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Exterior Lighting. Review the 7 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Engine. Review the 4 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
3 crash reports0 fire reports2 injury reports
Engine complaints
4 reports2.0 T USE OF EXCESSIVE OIL BETWEEN OIL CHANGES
RECENTLY I PREFORMED A ROUTINE MAINTENANCE CHECK ON MY VEHICLE AND AS SUGGESTED BY ALL MARK 5 GTI OWNERS I CHECKED THE CAM FOLLOWER. I FOUND THE CAM FOLLOWER COMPLETELY WORN THROUGH. I CONTACTED VW TO MAKE SURE I WAS UNDER THE EXTENDED WARRANTY HANDED OUT TO ALL 2006-2007 AND SOME 2008 OWNERS TO FIND OUT I WAS NOT UNDER THE WARR…
Read full complaint
RECENTLY I PREFORMED A ROUTINE MAINTENANCE CHECK ON MY VEHICLE AND AS SUGGESTED BY ALL MARK 5 GTI OWNERS I CHECKED THE CAM FOLLOWER. I FOUND THE CAM FOLLOWER COMPLETELY WORN THROUGH. I CONTACTED VW TO MAKE SURE I WAS UNDER THE EXTENDED WARRANTY HANDED OUT TO ALL 2006-2007 AND SOME 2008 OWNERS TO FIND OUT I WAS NOT UNDER THE WARRANTY EXTENSION. RIGHT NOW I HAVE A THE PIECE OFF MY OLD CAM FOLLOWER SOMEWHERE IN MY ENGINE AND VW REFUSES TO SERVICE MY VEHICLE DUE TO THEIR NEW IMPROVED MODEL APPARENTLY THAT MANY OTHER OWNERS ARE EXPERIENCING. VW KNOWS THAT THE CAM FOLLOWER IS FAULTY BUT REFUSES TO SERVICE MANY OTHER 2008 OWNERS SUCH AS MYSELF. RIGHT NOW IT FEELS LIKE MY CAR IS A TICKING TIME BOMB WITH THE CAM FOLLOWER PIECE SOMEWHERE IN THE ENGINE.
THE CAM FOLLOWER HAS PREMATURELY WARN OUT CAUSING THE INTAKE CAMSHAFT TO WEAR PREMATURELY AS WELL, WHICH HAS IN TURN CAUSED THE HIGH PRESSURE FUEL PUMP TO FAIL. THIS IS A LONG-TERM, DEGENERATIVE ISSUE. VOLKSWAGEN HAS EXTENDED THE WARRANTY ON THESE PARTS FOR SOME 2006-2008 GTI'S BUT NOT MY VIN. THEIR WARRANTY EXTENSION WAS…
Read full complaint
THE CAM FOLLOWER HAS PREMATURELY WARN OUT CAUSING THE INTAKE CAMSHAFT TO WEAR PREMATURELY AS WELL, WHICH HAS IN TURN CAUSED THE HIGH PRESSURE FUEL PUMP TO FAIL. THIS IS A LONG-TERM, DEGENERATIVE ISSUE. VOLKSWAGEN HAS EXTENDED THE WARRANTY ON THESE PARTS FOR SOME 2006-2008 GTI'S BUT NOT MY VIN. THEIR WARRANTY EXTENSION WAS NOT BROAD ENOUGH AS THESE SAME PARTS HAVE FAILED IN MY CAR.
Official recalls
107V442000 · Exterior Lighting:headlights
Sep 24, 2007
CERTAIN VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." SOME VEHICLES MAY NOT HAVE HAD A REQUIRED CAP INSTALLED WHICH DISABLES THE HEADLIGHT HORIZONTAL AIM AND SOME VEHICLES MAY CONTAIN A CAP THAT DISABLES THE VERTICAL AIMING SCREW.
Consequence & remedy
Consequence: NONCOMPLIANCE CAN INHIBIT PROPER HEADLAMP AIM ADJUSTMENT FOR ROADWAY ILLUMINATION, IMPROPERLY AIMED HEADLAMPS COULD CAUSE REDUCED ROAD VISIBILITY, INCREASING THE RISK OF A CRASH.
Remedy: DEALERS WILL INSPECT FOR THE PRESENCE OF A CAP IN THE SOCKET OF THE LOW BEAM HORIZONTAL AIMING SCREW AND INSTALL ONE IF MISSING, AND INSPECT FOR THE PRESENCE OF A CAP IN THE SOCKET OF THE VERTICAL AIMING SCREW AND IF PRESENT, THE CAP WILL BE REMOVED. THE RECALL WILL BEGIN ON OCTOBER 31, 2007. OWNERS MAY CONTACT VW AT 1-800-822-8987.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
1PE09035 · Vehicle Stall/loss Motive Power
Opened Jul 17, 2009 · Closed Nov 19, 2009
Status: closed (inferred from source dates) · Power Train:manual Transmission
THE SUBJECT VEHICLES ARE EQUIPPED WITH DIRECT SHIFT GEARBOX (DSG) TRANSMISSIONS, WHICH FEATURE A 6-SPEED AUTOMATIC GEARBOX WITH TWO WET RUNNING CLUTCHES (DUAL CLUTCH) IN WHICH THE CLUTCH MECHANISM AND GEAR CHANGES ARE ELECTROHYDRAULICALLY OPERATED BY A MECHATRONIC CONTROL UNIT.THE DSG MECHATRONIC CONTROLLER INCLUDES EXTENSIVE SELF DIAGNOSTIC FUNCTIONS AND STRATEGIES TO ENSURE SAFE OPERATION AND PREVENT SYSTEM/COMPONENT DAMAGE IN THE EVENT OF COMPONENT FAILURES OR HARSH OPERATING CONDITIONS.THE BASIC HIERARCHY OF FAULT MODES INCLUDES SOME THAT ONLY RESULT IN THE STORAGE OF A DIAGNOSTIC TROUBLE CODE (DTC) AND CAUSE NO LOSS OF FUNCTION, SOME THAT STORE A DTC AND REDUCE VEHICLE OPERATION TO A LIMP HOME MODE, AND SOME THAT STORE A DTC AND CAUSE AN INTERRUPTION OF MOTIVE POWER (I.E., OPEN CLUTCH).THE DRIVER IS ALERTED TO THE LATTER TWO MODES BY THE DASH GEAR POSITION INDICATOR (PRNDS) FLASHING. ONE OF THE CONDITIONS THAT RESULTS IN INTERRUPTION OF MOTIVE POWER IS EXCESS GEARBOX TEMPERATURE.THE SYSTEM INITIALLY RESPONDS TO INCREASED GEARBOX TEMPERATURE BY RAMPING DOWN ENGINE TORQUE.IF THE TEMPERATURE KEEPS RISING THE MECHATRONIC UNIT RESPONDS BY OPENING THE CLUTCH.IN A DEFECT INFORMATION REPORT SUBMITTED TO NHTSA ON AUGUST 20, 2009, VOLKSWAGEN DESCRIBED A POTENTIAL DEFECT IN THE WIRING HARNESSES OF THE DSG GEARBOX TEMPERATURE SENSORS USED IN APPROXIMATELY 16,000 MODEL YEAR (MY) 2009 AND 2010 VOLKSWAGEN (EOS, JETTA AND GTI) AND AUDI (A3 AND TT/TT ROADSTER) VEHICLES EQUIPPED WITH DSG TRANSMISSIONS AND BUILT FROM SEPTEMBER 2008 THROUGH AUGUST 2009 (NHTSA RECALL NO. 09V-333, VOLKSWAGEN RECALL NO. 37E3/S7 AND AUDI RECALL NO 37E4/J7). VOLKSWAGEN PROVIDED THIS DESCRIPTION OF THE DEFECT, THE WIRING HARNESS OF A TEMPERATURE SENSOR IN THE DSG MAY HAVE CONNECTOR WIRES THAT WERE INSUFFICIENTLY CRIMPED BY THE CONNECTOR SUPPLIER DURING A LIMITED PRODUCTION PERIOD.WITH INSUFFICIENTLY CRIMPED CONNECTOR WIRES, A TEMPERATURE SENSOR HAS THE POTENTIAL TO FALSELY DETECT A HIGH GEARBOX OIL TEMPERATURE, CAUSING THE TRANSMISSION TO ABRUPTLY SHIFT TO NEUTRAL.IF THIS HAPPENS, THE SELECTOR LEVER POSITION INDICATOR WITHIN THE INSTRUMENT PANEL WILL FLASH.IN ADDITION, THE DEPRESS BRAKE PEDAL INDICATOR LIGHT WILL BE ILLUMINATED, ALERTING THE DRIVER TO APPLY THE BRAKES.IN HEAVY TRAFFIC, THE ABRUPT SHIFT TO NEUTRAL COULD LEAD TO A CRASH WITHOUT WARNING.VOLKSWAGEN ESTIMATED THAT LESS THAN ONE PERCENT OF THE RECALLED VEHICLES MAY CONTAIN THE DEFECT CONDITION. ODI IDENTIFIED 40 COMPLAINTS THAT APPEAR TO BE RELATED TO THE TEMPERATURE SENSOR DEFECT CONDITION DESCRIBED BY VOLKSWAGEN.VOLKSWAGEN RECEIVED 139 COMPLAINTS RELATED TO THE CONDITION, WITH 7 INVOLVING VEHICLES REPORTED TO ODI, RESULTING A 172 TOTAL COMPLAINTS TO ODI AND VOLKSWAGEN.ALL OF THESE COMPLAINTS INVOLVE THE MY 2009 AN 2010 VEHICLES SUBJECT TO RECALL 09V-333. ODI ALSO IDENTIFIED COMPLAINTS OF HARSH/JERKY SHIFTING IN SOME VOLKSWAGEN VEHICLES WITH DSG.VOLKSWAGEN ATTRIBUTED THIS CONDITION, WHICH TYPICALLY OCCURS AT VERY LOW SPEEDS, TO EXCESSIVE WEAR IN THE BUSHINGS OF THE TWO SOLENOID VALVES IN THE MECHATRONIC UNIT THAT CONTROL CLUTCH OPERATION.VOLKSWAGEN DOES NOT BELIEVE THAT THE THIS CONDITION IS A SAFETY DEFECT BECAUSE THE CHANGES IN SHIFT QUALITY DEVELOP GRADUALLY OVER TIME, DO NOT CAUSE A LOSS OF MOTIVE POWER AND HAVE NOT RESULTED IN ANY FATALITIES, INJURIES OR SERIOUS CRASHES (THERE WERE THREE REPORTED PROPERTY DAMAGE INCIDENTS RESULTING IN MINOR BODY DAMAGE IN VERY LOW SPEED, PARKING MANEUVERS).VOLKSWAGEN ADDRESSED THIS PROBLEM IN THE FIELD WITH A CUSTOMER SERVICE PROGRAM THAT INCLUDES THE REPLACEMENT OF POTENTIALLY AFFECTED MECHATRONIC UNITS AS WELL