2003 Toyota Tacoma

I took my 2003 Toyota Tacoma and for a tire alignment and was told by an employee of the tire shop that my rack and pinion needed to be replaced and lower ball joints. I checked the VIN number and it said I have zero recalls, but there is a general recall on this make a model that I have what do I do? I also have the steering has a lot of play whenever I go for a bump in the road like the tires catch the road so I kind of swerve a little bit and I feel that it’s very unsafe to me and other drivers.

Invoice no. XXX Frame recall. I have a receipt stating…”J# 20TOZFRAM,;CS FRAM Inspection TECY(S):351 Warrenty inspected Frame, Frame failed, perforation, Replaced Frame at Dealer”. Except they did not replace the frame, I have a receipt stating they replaced the “ spare tire rack assembly. Now, my frame is so rusted it will not pass inspection next September. It has been welded already, at the tune of $2500.00. This truck has 122,000 miles. I want the truck fixed. I’ve been in touch with the BBB and the attorney general, and others. The attorney general suggested I get a lawyer. This is a a gross deception from the Orleans Dealer in [XXX] . INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

While driving at both high speeds (highway) and local road speed limits, Toyota Tacoma's rear passenger side frame split completely in half. While performing maneuvers such as right turns, vehicle wobbled and I, driver, lost temporary control of vehicle. Upon further inspection, rear driver side frame also contains stress fractures which are symmetric to the rear passenger side of truck. Potential for accident has increased exponentially. Pictures provided. Brought evidence of clear safety hazard to local Metro Detroit dealership at 773 S Rochester Rd Unit B, Rochester Hills, MI 48307 on 04NOV25, and called Toyota Corporate on 05NOV25. Toyota Corporate neglected my concerns about safety hazard and potential harm to myself and family. Safety recall needs to be issued immediately. This issue stems from a well known recall from Toyota of Toyota Tacoma's, 1996-2004, which contained an OEM defect of excessive corrasion to the frames, causing premature failure of the frames due to excessive rust build up which impacts frame integrity and increases probability of failures such as observed in my case.

Prior to July, 2010, I received a letter from Toyota stating my Tacoma Frame was recalled. I wouldn’t have known otherwise. I set up an appointment with the Orleans Toyota dealer and set up an appointment. They gave me a loaner and had my truck for two weeks. I thought my frame had been replaced. All this time went by and now my frame is dangerously rusted. Last year I spent $2500 getting it spot welded. This year the mechanic says he may not be able to pass it next time. This provoked me to research all my bills for the truck. What I found was unbelievable to me. I never looked at my billing receipt from Orleans Toyota, but believed the frame was done. Not the case. They replaced the 83341 Spare Tire Carrier 5092 Wpt. Part=04002-11204. My Tacoma has 122,000 on it now. I’m [XXX]. I cannot afford a new car payment . From what I understand there are 100s of people with the same problem of seriously rusted frames. I need your help. Thank youL [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

What component or system failed or malfunctioned, and is it available for inspection upon request? While driving over railroad tracks, the lower ball joint separated from its socket, which caused the CV axle shaft to break apart and led to the separation of the upper ball joint. As a result, the front driver's side tire folded under the fender, causing the truck to abruptly veer off the road and into the right shoulder All parts are available for inspection How was your safety or the safety of others put at risk? When the failure occurred, I was driving over a series of railroad tracks when the truck suddenly veered off the road onto the shoulder. This abrupt veering and stopping put my safety—and the safety of others—at risk, as the drivers behind me had to react suddenly to avoid a collision. Has the problem been reproduced or confirmed by a dealer or independent service center? The truck was serviced in 2006 in response to the recall, having the lower ball joints replaced, however the replacement parts may have failed Has the vehicle or component been inspected by the manufacturer, police, insurance representatives or others? No Were there any warning lamps, messages or other symptoms of the problem prior to the failure, and when did they first appear? No

The contact owns a 2003 Toyota Tacoma. The contact stated while driving at an undisclosed speed, the front driver’s side wheel detached from the vehicle. The contact was able to navigate the vehicle to safety. The vehicle was towed to an independent mechanic where it was diagnosed that the front driver’s side ball joint had failed and needed to be replaced. The contact was informed that the VIN was included in NHTSA Campaign Number: 05V225000 (Suspension). The vehicle was towed to the dealer where the vehicle remained and was diagnosed that the rear frame was rusted and needed to be replaced. The dealer informed the contact that the vehicle was included in an unknown warranty extension; however, the vehicle was not repaired. The manufacturer was notified of the failure, but no assistance was provided. The failure mileage was approximately 310,000.

I was driving home on March 10 2023 well out of no where my Toyota Tacoma something on the front end suspension broke it looks to me the recal that Toyota fixed before I even got the truck well sent me into 3 trees head on 55mph no airbag deployed I didn't have a chance to try and stop the vehicle I thought I was going to die I know the road I was on isn't the best shape I need help

The contact owns a 2003 Toyota Tacoma. The contact stated that the entire subframe of the vehicle was rusted due to severe corrosion. There were no warning lights illuminated. The vehicle was taken to an independent mechanic who confirmed the subframe corrosion. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 200,000. The VIN was not available. The contact stated that there was an opportunity to have the frame of the vehicle coated but that make the corrosion worse. The contact feels as though the vehicle is unsafe to drive.

While driving, on the highway, the rear shock absorber support mount came loose, allowing the truck bed to come loose from the frame/chassis. Fortunately only the passenger side came loose, keeping the truck's bed attached to the rear of the truck I later found that this particular model has a problem with Frame rot which generated a Toyota bulletin. I bought the truck from Toyota, as a used truck in 2011, but received no notifications of this potentially hazardous vehicle. If the bed had come loose at highway speed, any vehicle following the 2003 Toyota Tacoma truck would have been severely damaged or potentially resulted in the death of the people in the cars following behind me and the truck. There was a Toyota bulletin issued previously which was not disclosed to me at the time of purchase. The vehicle has been in Toyota shops regularly for inspections, maintenance and other repairs but the shop never mentioned anything about a "rusty" frame. Upon further research, I have found multiple Toyota Tacoma owners with similar issues with the frame. I believe Toyota knowingly manufactured and sold a defective product with serious potential safety issues. This vehicle either should be banned from the road for the safety of all drivers.