Owner reports · Recalls · Investigations
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →Owner complaints by model year
Compare all Pacemaker years →Counts vary with age, sales and reporting. They are not failure rates.
No component reports in this snapshot.
Tap a category to read its complaints. One report may name several components.
Mileage at the reported incident
Limited mileage data: 0 of 0 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
NHTSA owner reports · September 18, 2026 snapshot.
No matching complaints in this snapshot.
May 7, 1979
THE INVOLVED BUSES FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 222, "SCHOOL BUS PASSENGER SEATING AND CRASH PROTECTION". THE SAFETY BARRIERS FAILED TO EXHIBIT THE PROPER IMPACT ABSORBING QUALITIES WHEN TESTED FOR COMPLIANCE.
Consequence: Not supplied
Remedy: DEALER WILL INSTALL TWO 7 GAUGE PLATES MOUNTED AT BOTH LOWER CORNERS ON THE FRONT OF EACH BARRIER.
Nov 22, 1978
THE INVOLVED VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 217, "BUS WINDOW RETENTION AND RELEASE". VEHICLES LACK THE PROPER NUMBER OF EMERGENCY EXITS.
Consequence: Not supplied
Remedy: DEALER WILL INSPECT INVOLVED VEHICLES FOR PROPER NUMBER OF EXITS. ALSO, WHERE REQUIRED, STATIONARY SASHES WILL BE REMOVED AND HINGED EMERGENCY EXITS WILL BE INSTALLED.
Sep 6, 1978
THE LETTERING LOCATION FOR BRAKE FLUID RESERVOIR LABELING FAILS TO MEET THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 105, "HYDRAULIC BRAKE SYSTEMS". THE REQUIREMENT STATES THAT THE LETTERING MUST BE VISIBLE BY DIRECT VIEW EITHER ON OR WITHIN 4 INCHES OF THE BRAKE FLUID RESERVOIR FILLER CAP.
Consequence: Not supplied
Remedy: DRAWINGS AND INSTRUCTIONS WILL BE SENT TO ENABLE OWNER TO REMOVE AND REINSTALL THE RESERVOIR CAP PROPERLY.
Jun 14, 1978
THE BRAKE WARNING LIGHT IS NOT ACTIVATED WHEN THE PARKING BRAKE IS APPLIED AND THE IGNITION SWITCH IS IN THE "ON" POSITION. THIS CONSTITUTES A NON-COMPLIANCE TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 105, "HYDRAULIC BRAKE SYSTEMS". ALSO, THE BRAKE LAMP CHECK FUNCTION IS INOPERABLE.
Consequence: Not supplied
Remedy: DEALER WILL LENGTHEN THE WIRE CONNECTION BETWEEN THE PARKING BRAKE AND THE WIRING HARNESS TO ENSURE PROPER BRAKE LIGHT OPERATION. A GROUNDING WIRE WILL ALSO BE INSTALLED TO ENSURE PROPER OPERATION OF THE LAMP CHECK FUNCTION.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
No exact-year investigations in this snapshot.
Illustration