2013 Scion FR-S

On approximately May 27, 2026 I delivered my 2013 Scion FR-S (approx. 105,000 miles) to an authorized Toyota dealer for Safety Recall J02 (NHTSA 18V-772, engine valve spring replacement). I picked it up on June 3, 2026. Immediately the engine ran sluggish and the air conditioning, which had worked, stopped blowing cold. On June 7, 2026 - four days and only a few miles later - the engine spun a rod bearing and began knocking loudly. The vehicle is now inoperable. This recall requires removing and disassembling the engine and is widely documented to cause oil starvation and spun bearings when excess RTV sealant from reassembly clogs the oil pickup screen. My engine ran normally for years and failed within days of the recall repair. The recall repair caused catastrophic engine failure. No crash or injury has occurred; the vehicle is parked to prevent further damage.

sometimes the car randomly stalls out during driving. usually off cold starts if i let it warm up for even 5 minutes it still will stall out sometimes. its not super common id say it does it once every 2 days maybe. the car is also misfiring and ive noticed a large loss of power from the car. it started back in june and i just havent really gotten it fixed yet. usually when im driving itll kind of just buffer and a check engine light is thrown on but it ends up going off after a couple drives.

The engine suffered catastrophic failure 2,988 miles after the J02 Saftey recall was performed by Preston Toyota of New Castle, PA. I was travelling at highway speeds when the engine died and would not turn on. I lost all power brakes and could have wrecked and injured myself, others or worse, caused a fatality. The car was towed to a toyota dealership that confirmed the issue was due to the work performed during the recall on the car. The oil light flashed a few times then shut off and then a few seconds later the engine died.

It is my belief that the valve spring on the engine broke, even after the recall work had been done. I was getting out of my car and heard, what sounded like, metal under tension popping really loudly. After that the engine made a rattling noise. In hindsight I should have known something was wrong, but I had an oil change at the dealer in 2 days and thought they would hear it. After the oil change they didn't say anything so I felt it was ok. On my way home from work the following day, less than 40 miles after the oil change, the car suddenly completely shut off while I was driving home on the highway. What saved my life was that I was getting off the highway in the right lane and was able to roll the car slightly off the highway. Had this been in any other lane I might have been in an accident. Trying to restart the car on the side of the road it had a terrible knocking noise and sounded like something was spinning freely. I had it towed to the dealer as they had just changed the oil thinking that was it. They "looked" at it a couple days later and said it was a spun bearing and that it was normal wear and tear. The car only has 103,000 miles on it and was driven normally, with regular maintenance. Upon retrieving the car the tow truck driver stated that's not normal to happen, and I noticed the car was in the same place as where I had it towed originally. The dealer never actually inspected or looked at the car and just made the spun bearing assessment without trying to start it, as the battery was dead from trying to restart on the highway. No one has since touched the car, and some research online shows that I am not the only person this has happened to. The recall stated that the valve springs could break while driving and the car would suddenly shut off with no warning. This is exactly what happened, while driving on the highway home. According to the dealer it is a spun bearing but that is not what it sounds like at all. It definitely sounds like a rod.