OFFICIAL NHTSA RECALL
91V015000
Power Train:axle Assembly:axle Shaft
Reported Feb 15, 1991 · ISUZU MOTORS LIMITED
Summary
BEARINGS USED IN THE REAR AXLE HUBS ON THESE VEHICLES ARE IMPROPERLY MACHINED; BEARING COULD SEIZE AT LOW MILEAGES BEFORE SUFFICIENT RUN IN IS ACHIEVED.
Consequence
IF THE BEARING SIEZED, THE AXLE HUB WOULD BE NOISY ATBEST, AND IN THE WORST CASE, THE AXLE SHAFT COULD FALL OUT CAUSING LOSS OFVEHICLE CONTROL WHICH MAY RESULT IN AN ACCIDENT.
Remedy
INSTALL NEW REAR WHEEL INNER AND OUTER BEARINGS.
Notes
SYSTEM: REAR AXLE HUBS.VEHICLE DESCRIPTION: HEAVY TRUCKS.NOTE: THIS BEARING CONDITION IS KNOWN TO AFFECT ONLY THE REAR WHEEL AXLEBEARINGS MANUFACTURED BY KOYO. KOYO IS STAMPED ON THE BEARING INNER AND OUTERRINGS FOR IDENTIFICATION.
This campaign page uses the representative official campaign record. Applicability-specific source variants appear on the linked vehicle pages. Recall counts refer to campaigns, not affected vehicles.
Vehicle entries in this campaign
This is model-level recall history. It does not confirm whether a particular VIN is affected or has received the repair. Check with NHTSA ↗