OFFICIAL NHTSA RECALL
17V535000
Steering:linkages:tie Rod Assembly
Reported Aug 31, 2017 · Mack Trucks, Inc.
Summary
Mack Trucks, Inc. (Mack) is recalling certain 2016 Pinnacle CHU and CXU diesel trucks equipped with certain Dana steer axles. The castellated nut and cotter pin on the steer axles may not have been properly torqued, allowing the tie rod to loosen within the steer axle.
Consequence
If the tie rod loosens, it may disconnect from the steering knuckle, causing a complete loss of steering, increasing the risk of a crash.
Remedy
Mack will notify owners, and dealers will inspect the torque of the castellated nut and tie rod, tightening it as necessary. If the tie rod stud and knuckle on units cannot be sufficiently torqued, the dealer will replace the knuckle and tie rod end assembly, free of charge. The recall began on October 17, 2017. Owners may contact Mack customer service at 1-800-866-1177. Mack's number for this recall is SC0408.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
This campaign page uses the representative official campaign record. Applicability-specific source variants appear on the linked vehicle pages. Recall counts refer to campaigns, not affected vehicles.
Vehicle entries in this campaign
This is model-level recall history. It does not confirm whether a particular VIN is affected or has received the repair. Check with NHTSA ↗