SkipThatYearREAL DATA. SMARTER CAR DECISIONS.
← New search

1990 Oldsmobile Ciera

Owner reports · Recalls · Investigations

Limited comparison data

There is not enough comparable history to draw a useful model-year comparison.

About this comparison →
20Owner complaints

Model-year median: 15.5

2Recall campaigns

View recall details →

1Investigations

View investigation details →

How this year compares

Owner complaints by model year

Other model years Selected year
17
198725
198831
198920
1990
Compare all Ciera years →

Counts vary with age, sales and reporting. They are not failure rates.

What owners reported most

Vehicle Speed Control
7Electrical System
3Engine And Engine Cooling
3Seat Belts
2Service Brakes, Hydraulic
2
All reported categories
Structure
2Equipment
1Exterior Lighting
1Seats
1Steering
1Visibility
1

Tap a category to read its complaints. One report may name several components.

When problems were reported

Mileage at the reported incident

Limited mileage data: 0 of 20 reports include usable mileage. There isn’t enough coverage to show a useful chart.

NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.

What to inspect

Issues worth paying extra attention to based on owner reports.

  • Vehicle Speed Control. Review the 7 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
  • Electrical System. Review the 3 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
  • Engine And Engine Cooling. Review the 3 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

6 crash reports0 fire reports2 injury reports

Steering complaints

1 reports
Clear category filter
Mileage unknown · Aug 20, 2002
Steering

BEGAN NOTICING STEERING COLUMN WOULD NOT STAY LOCKED INTO DESIRED ANGLE. FURTHER NOTICED ENTIRE WHEEL WOULD HAVE SIDE-TO-SIDE MOVEMENT. AT THIS STAGE IT HAS ABOUT 1-INCH PLAY IN ALL DIRECTIONS, FEEL UNSAFE WHEN STEERING. REPAIR SHOP SAID IT IS COMMON PROBLEM IN THIS CAR; REPAIR INVOLVES REMOVING MOST UPPER COMPONENTS AND TIGHTEN…

Read full complaint

BEGAN NOTICING STEERING COLUMN WOULD NOT STAY LOCKED INTO DESIRED ANGLE. FURTHER NOTICED ENTIRE WHEEL WOULD HAVE SIDE-TO-SIDE MOVEMENT. AT THIS STAGE IT HAS ABOUT 1-INCH PLAY IN ALL DIRECTIONS, FEEL UNSAFE WHEN STEERING. REPAIR SHOP SAID IT IS COMMON PROBLEM IN THIS CAR; REPAIR INVOLVES REMOVING MOST UPPER COMPONENTS AND TIGHTENING 2 BOLTS AT BASE OF COLUMN AT DASHBOARD. BECAUSE OF COMPLEXITY OF DISASSEMBLY, REPAIR REQUIRES 2 TO 3 HOURS @ $75/HOUR NYC RATES. I FEEL THIS TYPE OF DEFECT SHOULD HAVE SOME RECOURSE THROUGH MANUFACTURER SINCE THIS IS A MAJOR DRIVEABILITY ISSUE WHICH COULD CAUSE SERIOUS ACCIDENT IF NOT CORRECTED.*AK

NHTSA ODI #765912

Official recalls

2

95V173000 · Seat Belts:front:anchorage

Sep 15, 1995

THESE VEHICLES WERE ASSEMBLED WITH REAR OUTBOARD SAFETY BELT ANCHORAGES THAT MAY NOT WITHSTAND THE REQUIRED LOAD. THIS DOES NOT COMPLY WITH FMVSS NO.210, "SEAT BELT ASSEMBLY ANCHORAGES."

Consequence & remedy

Consequence: CONSEQUENCE OF NON-COMPLIANCE: IN A COLLISON, STRESS CAN CAUSE THE ATTACHMENT METAL TO TEAR AND ALLOW THE ANCHORAGE TO SEPARATE FROM THE BODY OF THE VEHICLE. THE SAFETY BELT MAY NOT PROTECT AN OCCUPANT IN THE EVENT OF A VEHICLE CRASH.

Remedy: DEALERS WILL REPLACE THE EXISTING ANCHOR BOLTS WITH A NEW SHOULDER BOLT AND THREAD LOCKING ADHESIVE. ADDITIONALLY, NOISE CONTROL PATCHES WILL BE APPLIED AT EACH ANCHORAGE.

92V124000 · Seats:front Assembly:recliner

Sep 1, 1992

THE POWER SEAT OR RECLINER WIRING HARNESS CAN BE PINCHED OR CAN CHAFE ON THE SEAT FRAME OR SPRING SUPPORT ROD, WEARING THROUGH THE WIRE INSULATION AND CAUSING AN ELECTRICAL SHORT.

Consequence & remedy

Consequence: THE HIGH CURRENT CAUSED BY THE ELECTRICAL SHORT WELDS THECIRCUIT BREAKER ELEMENTS TOGETHER IN THE CLOSED POSITION, LEAVING THE CIRCUITUNPROTECTED AND GENERATING SUFFICIENT HEAT TO BURN THE WIRE INSULATION ANDIGNITE THE SEAT CUSHION MATERIAL.

Remedy: REPAIR ANY ABRADED WIRING AND REROUTE THE WIRING HARNESS USING A WIRING HARNESS CLIP.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

1

PE94048 · SUB-FRAME Absorber Failure

Opened Jun 21, 1994 · Closed Dec 30, 1994

Status: closed (inferred from source dates) · Engine And Engine Cooling

There is no summary currently available