2013 Nissan Murano

I am the second owner of a 2013 Nissan Murano, purchased from my friend's estate in 2026. Recently, the drivers seat belt was found to be shredding in two places. I did a search for open recalls on seal belt fabrics but there are none. I do not know what to do about it. I have placed thin shipping tape over the rips and tears. It appears that something in the roll up mechanism is tearing the seat belt. Please help me. Thank you.

I am the second owner of a 2013 Nissan Murano, purchased from my friend's estate in 2026. Recently, the drivers seat belt was found to be shredding in two places. I did a search for open recalls on seal belt fabrics but there are none. I do not know what to do about it. I have placed thin shipping tape over the rips and tears. It appears that something in the roll up mechanism is tearing the seat belt. Please help me. Thank you.

While driving, the rear arm connected to the rear driver-side wheel broke off. According to my Nissan dealership diagnosis, this was due to excessive rust/rot of the whole subframe. The 2013 Nissan Murano rear arm cannot re attach the wheel to the sub frame due to so much rust/rot on the sub frame. The whole subframe would need replacement. When doing an estimate on fixing, Nissan called and stopped the estimate when replacement of the subframe, fixing of the arm, and additional rust/replacement exceeded the value of the car. My son and I were driving on the road when the arm broke off the rear wheel, the wheel went sideways and we skidded to a stop, so our safety was at risk. There were no warning lights or signs of this happening. While driving on the road, my car felt unstable then seconds later the arm broke off. The car was at Nissan 4 months prior to have work done, I had them do a multipoint inspection when there was a problem/engine light with the vehicle and it would not go more than 15mph. Nissan fixed loose RF hub, plus they replaced a right and left front sway bar. This is right on the sub frame, there was no warning given to me that the sub frame was rusted or could give out.

The contact owns a 2013 Nissan Murano. The contact stated that the driver's side sun visor had detached and was hanging down, blocking the visibility of the roadway. The vehicle was not diagnosed or repaired by an independent mechanic or the dealer. The manufacturer was not notified of the failure. The failure mileage was approximately 103,000.

The contact owns a 2013 Nissan Murano. The contact stated that while driving 30 MPH, the air bag warning light was blinking. The contact stated that the failure was related to NHTSA Campaign Number: 16V244000 (Air Bags). The vehicle was taken to the local dealer where it was diagnosed and determined that the occupant sensor module had cause the failure and recommended that the seat frame be replaced. The vehicle was not repaired. The manufacturer was contacted, and confirmed that the VIN was not under recall. The failure mileage was approximately 94,500.

The air bag light started blinking. We took the car to our local Nisan dealership. We had to pay $220.77 just to have them look at it. They said there was an occupant sensor unit malfunction and it needed the bottom seat pad replaced. We were then told “that it is discontinued “! We are left with an air bag that doesn’t work, and a blinking air bag warning sign that constantly reminds us of the danger we are in. I am frightened to death to drive the car and angry that it cost $220.77 for nothing. When I asked what I could do - they said “You can trade it in and buy a new Nisan”! We will never buy another Nisan!! Can you help?

The contact owns a 2013 Nissan Murano SL. The contact stated while driving 65 MPH, the vehicle lost power. The check engine warning light was illuminated. The vehicle was taken to the local mechanic who would not perform the work due to recalls on the transmission. The vehicle was taken to the dealer but has not been repaired. The contact stated the vehicle was repaired under a previous manufacturer recall that replaced the transmission, however, the failure persisted. The manufacturer was notified of the failure and a complaint was filed. The failure mileage was approximately 166,000.