Nissan Altima electrical problems

WHEN I WAS CAME HOME FROM SHOPPING I STOP CAR AND SWITCH OFF AND GO HOME AFTER ABOUT 15 MIN GOING TO SOME WHERE BUT CAR TAKE TIME TO START AFTER FEW SECOND CAR START. TRY 3 TIMES SAME. NEXT DAY GOING TO WORK AND SAME STARTING PROBLEM START CAR AND GOING ABOUT 1 MILE DRIVE POWER CUT OFF AND LUCKILY NO ONE BEHIND ME ABLE TO GO ON SIDE BECAUSE CAN NOT DO ANYTHING NO BRAKE NO GAS GOD HELP ME AFTER ONE MINT START CAR AND RICH WORK ABOUT 2 MILE . AT WORK WE HAVE MECHANIC HE HAS SOFTWARE FOR CAR DIAGNOSIS HE CHECK AND TOLD ME CODE P0340 FOR CAMSHAFT POSITION SENSOR WE CHANGE ONE BOUGHT FROM DEALER AFTER 2 HR GOING HOME SAME PROBLEM STARTING. MECHANIC RESET AND GO HOME NEXT DAY GOING TO WORK SAME THING HAPPENED POWER SHUTOFF ABOUT 1 AND 1/2 ABLE TO PARK ONSIDE AND START AGAIN AND DROP TO REPAIR SHOP. HE CALLED ME AND TOLD ME YOU HAVE TO CHANGE ANOTHER CAMSHAFT SENSOR AFTER WOK FINE FOR UP TO NOW. BUT THEY RECALL SOME CAR BEFORE FOR THIS PROBLEM IF I WAS IN HIGHWAY THEN WHAT HAPPENED DO YOU THINK I WILL ABLE TO WRITE NOW OR DIE. CAN YOU CHECK ON THIS AND DO SOMETHING OTHERWISE SOME ONE DIE. [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6). *TR

TL* THE CONTACT OWNS A 2002 NISSAN ALTIMA. THE CONTACT STATED WHILE DRIVING 70 MPH, THE VEHICLE DECELERATED WITHOUT MANUAL FORCE AND A FIRE EMERGED FROM THE HARNESS OF THE VEHICLE. THE FIRE WAS PUT OUT BY THE CONTACT. A POLICE REPORT WAS FILED. THE CONTACT DID NOT SUSTAIN ANY INJURIES. THE VEHICLE WAS TOWED TO THE DEALER FOR DIAGNOSIS WHERE IT WAS STATED THE WIRING HARNESS NEEDED TO BE REPLACED. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS NOTIFIED. THE APPROXIMATE FAILURE MILEAGE WAS 100,000. UPDATED 12/12/13*CN

I WAS DRIVING DOWN THE INTERSTATE GOING 60-65 MPH, WITH MY GIRLFRIEND AND MY NEWBORN DAUGHTER. THE CHECK ENGINE LIGHT CAME ON, THE CAR SHUT OFF AND THE ENGINE STALLED WITH A RIVER OF TRAFFIC SURROUNDING AROUND ME. AFTER ABOUT 10 MINUTES THE CAR FINALLY STARTED BACK UP & RAN FINE. A FEW DAYS LATER THE CAR BECAME HARDER TO START AND THE ENGINE SHUT OFF ON THE INTERSTATE ONCE AGAIN. I GOT THE ENGINE CODE, CHECKED OUT AND IT WAS P0340 (CAM SHAFT POSITION SENSOR). UPON FURTHER RESEARCH I NOTICED THAT THIS IS A VERY COMMON NATIONWIDE PROBLEM. NOT ONLY DOES THE ENGINE STALL WHILE DRIVING, IT COMPLETELY CAUSES THE MOTOR TO SHUT OFF! THE MOTOR IN A VEHICLE SHUTTING OFF WHILE GOING DOWN A JAMMED INTERSTATE OR GOING ACROSS RAILROAD TRACKS IS EXTREMELY UNSAFE AND IT IS UNACCEPTABLE TO NOT GET RECOGNIZED. AFTER EXPERIENCING THIS HORRIBLE SITUATION, AND VIEWING THE COUNTLESS PEOPLE WHO HAVE EXPERIENCED IT AS WELL. I AM FLABBERGASTED THE CAM/CRANKSHAFT SENSOR FOR THE 2002-2005 ALTIMA HAS YET TO BE RECALLED. THE CHANCE OF THE PART BEING DEFICIENT IS ABNORMALLY HIGH. THE PART IS INCAPABLE OF PERFORMING IT PURPOSE, BECAUSE ONCE REPAIRED IT CONTINUOUSLY HAS TO BE REPLACED. NISSAN DOES STATE THAT THIS IS A DEFICIENT PART AND THERE IS A SERVICE BULLETIN ON IT. BUT A SERVICE BULLETIN DOES NOT DO ANYONE ANY JUSTICE WHEN THE SENSORS HAVE TO BE REPLACED ONCE A YEAR!! *TR

TL* THE CONTACT OWNS A 2011 NISSAN ALTIMA. THE CONTACT STATED THAT WHILE DRIVING 40 MPH, THE HEADLIGHTS SHUT OFF INDEPENDENTLY. THE CONTACT CRASHED INTO A POLE BECAUSE HE WAS UNABLE TO SEE WHILE TRYING TO PULL OVER AND PARK THE VEHICLE. THERE WERE NO INJURIES. THE VEHICLE LATER COULD NOT BE SHUT OFF USING THE PUSH-TO-START BUTTON. THE CONTACT TOOK THE VEHICLE TO THE DEALER, WHO T REPROGRAMMED THE BODY CONTROL MODULE. THE FAILURE MILEAGE WAS 23,000.

HANDLING OF THE NISSAN ALTIMA CRANK SHAFT SENSOR RECALL IS COMPLETELY UNACCEPTABLE. NO NOTICE OF THE RECALL WAS EVER SENT, WHICH MEANT WE FOUND OUT THE HARD WAY: WHEN THE CAR STALLED OUT IN THE MIDDLE OF A MAJOR HIGHWAY, WITHOUT WARNING (EXACTLY AS DESCRIBED IN THE RECALL THAT WASN'T SENT) I ONLY FOUND THE RECALL AFTER A LOCAL NON-NISSAN MECHANIC TOLD ME ABOUT IT, AND THEN WHEN I BROUGHT IT INTO THE DEALER, THEY DIDN'T UNDERSTAND THE NATURE OF THE RECALL. PLEASE HELP! *TR

THE BEST I CAN DO TO EXPLAIN THE PROBLEM I AM HAVING WITH MY 2013 ALTIMA IS TO COMPARE IT TO THE JERKING YOU WILL EXPERIENCE IN A STICK SHIFT VEHICLE IF YOU DO NOT CLUTCH AND SHIFT PROPERLY ALMOST CAUSING THE VEHICLE TO STOP. ONCE I WAS ENTERING ONTO THE HIGHWAY, THE CAR ACTED AS IF THE PARKING BRAKE WAS APPLIED WHILE DRIVING. I TOOK MY CAR TO THE DEALER FROM WHICH I PURCHASED IT (ST.CLAIR AUTO MALL), THE MECHANIC DROVE IT AND ALMOST IMMEDIATELY HE EXPERIENCED THE PROBLEM. WE DROVE BACK TO THE DEALERSHIP (SERVICE DEPT.). HE LOOKED UP SOME INFORMATION IN THE COMPUTER, SAID DIAGNOSTICS TESTS WERE RAN BUT THE TEST(S) TURNED UP NOTHING. AND ALSO THERE WERE NO LIGHTS ON THE DASH INDICATING A PROBLEM. SO, FOR THAT REASON NOTHING COULD BE DONE. *TR

TL* THE CONTACT OWNS A 2008 NISSAN ALTIMA. THE CONTACT STATED THAT THE INTELLIGENT KEY WOULD NOT UNLOCK THE DOORS FOR A CONSIDERABLE AMOUNT OF TIME. AFTER THE DOORS WERE UNLOCKED, THE CONTACT ATTEMPTED TO START THE VEHICLE BUT THE NO KEY WARNING LIGHT ILLUMINATED. THE CONTACT THEN CHANGED THE BATTERIES IN THE KEY FOB BUT THE FAILURE RECURRED. THE VEHICLE HAD NOT BEEN REPAIRED. THE VIN WAS UNAVAILABLE. THE FAILURE AND CURRENT MILEAGE WAS 35,000.

TL* THE CONTACT OWNS A 2010 NISSAN ALTIMA. THE CONTACT STATED THAT THE AUTOMATIC PUSH-TO-START IGNITION WOULD NOT OPERATE WHEN ENGAGED. THE VEHICLE WAS NOT TAKEN TO A DEALER FOR DIAGNOSTIC TESTING. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE VEHICLE WAS NOT REPAIRED. THE APPROXIMATE FAILURE MILEAGE WAS 48,000 AND THE CURRENT MILEAGE WAS 49,000. *TR

VEHICLE STALLED WHILE DRIVING IN HEAVY TRAFFIC WHILE ON MY WAY HOME. AFTER SEVERAL MINUTES, VEHICLE STARTED AND I WAS ABLE TO DRIVE HOME. SEL CAME ON AND ERROR CODE SAID "CRANKSHAFT POSITION SENSOR". TOOK IT TO MY LOCAL GARAGE AND WAS TOLD THIS WAS A VERY COMMON PROBLEM ON NISSAN ALTIMA. CONTACTED DEALERSHIP AND WAS TOLD THERE WAS NO ISSUE WITH THIS CAR OR SENSOR BUT THEY COULD REPROGRAM THE ECM TO FIX IT. WENT ONLINE AND I SEE NUMEROUS ISSUES WITH THIS SENSOR. NISSAN MECHANIC ADMITTED THE SENSOR WAS FAULTY AND THAT THE REPLACEMENT PART WAS REDESIGNED TO CORRECT THE ERROR AND INCLUDES A CAM SHAFT POSITION SENSOR AS WELL SINCE THEY GO OUT FREQUENTLY AS WELL. IF NISSAN IS AWARE OF ISSUE AND HAS REDESIGNED THE REPLACEMENT PART, WHY NO RECALL. I AM OUT $150 WHICH IS NO BIG DEAL, BUT A VEHICLE STALLING ON A HIGHWAY WHEN NISSAN KNOWS THE PART IS FAULTY IS EXTREMELY CONCERNING TO ME. *TR