Corp. Micro Bird, Inc. (Micro Bird) is recalling certain 2003-2026 MB II, 2006-2026 G5, and 2015-2026 T-Series school buses. An installation error may prevent the wheelchair tie-downs from locking, leaving the wheelchair improperly secured.
Consequence & remedy
Consequence: An unsecured wheelchair can move during transit or a crash, increasing the risk of injury.
Remedy: Dealers will inspect and secure the anchor screw cap as necessary, free of charge. Owner notification letters were mailed April 28, 2026. Owners can contact Micro Bird Customer Service at 819-477-2012. Micro Bird's number for this recall is 26-120-AUS.
Corp. Micro Bird, Inc. (Micro Bird) is recalling certain 2022-2025 MB II, T-Series, and 2021-2026 G5 school buses. The power cable providing electricity to the air conditioning control board may have a loose connection to the power stud on the board.
Consequence & remedy
Consequence: A loose power cable connection may cause the control board to overheat and melt, increasing the risk of a fire.
Remedy: Dealers will secure the power cable and power stud as necessary, free of charge. Owner notification letters were mailed February 2, 2026. Owners can contact Micro Bird Customer Service at 819-477-2012. Micro Bird's number for this recall is 25-118-SUC.
Corp. Micro Bird, Inc. (Micro Bird) is recalling certain 2008-2025 G5, 2008-2024 MBII, and 2015-2024 T-Series school buses. The rear emergency door exterior handle may unexpectedly break under applied force.
Consequence & remedy
Consequence: In the event of an emergency, a broken door handle can prevent or delay emergency responders from entering the bus, increasing the risk of injury.
Remedy: Dealers will replace the rear emergency door exterior handle, free of charge. Owner notification letters were mailed August 15, 2024. Owners may contact Micro Bird customer service at 1-819-477-2012. Micro Bird's number for this recall is 24-109-EUS.
Additional source detail variants (2)
Structure:body:door:handle:exterior
Corp. Micro Bird, Inc. (Micro Bird) is recalling certain 2008-2025 G5, 2008-2024 MBII, and 2015-2024 T-Series school buses. The rear emergency door exterior handle may unexpectedly break under applied force.
Consequence: In the event of an emergency, a broken door handle can prevent or delay emergency responders from entering the bus, increasing the risk of injury.
Remedy: Dealers will replace the rear emergency door exterior handle, free of charge. Owner notification letters were mailed August 15, 2024. Owners may contact Micro Bird customer service at 1-819-477-2012. Micro Bird's number for this recall is 24-109-EUS.
Structure:emergency:escape/egress/exit
Corp. Micro Bird, Inc. (Micro Bird) is recalling certain 2008-2025 G5, 2008-2024 MBII, and 2015-2024 T-Series school buses. The rear emergency door exterior handle may unexpectedly break under applied force.
Consequence: In the event of an emergency, a broken door handle can prevent or delay emergency responders from entering the bus, increasing the risk of injury.
Remedy: Dealers will replace the rear emergency door exterior handle, free of charge. Owner notification letters were mailed August 15, 2024. Owners may contact Micro Bird customer service at 1-819-477-2012. Micro Bird's number for this recall is 24-109-EUS.
Corp. Micro Bird, Inc. (Micro Bird) is recalling certain 2021-2023 G5, 2022-2023 MBII, and 2022 T-Series school buses. The seat-level rub rails may be incorrectly attached to the side of the bus.
Consequence & remedy
Consequence: Incorrectly attached rub rails may not offer adequate protection against an impact, increasing the risk of injury.
Remedy: Micro Bird will inspect and secure the rub rails, as necessary, free of charge. Owner notification letters were mailed December 22, 2022. Owners may contact Micro Bird customer service at 1-819-477-2012. Micro Bird's number for this recall is 22-098-RUS.
Corp. Micro Bird, Inc. (Micro) is recalling certain 2012-2023 G5, 2012-2023 MBII and 2015-2022 T-Series school buses. The power cable that provides electricity to the air conditioning control board may have a loose connection to the power stud on the board.
Consequence & remedy
Consequence: A loose power cable connection may cause the control board to overheat and melt, increasing the risk of a fire.
Remedy: Dealers will redirect the power cable and secure the power cable connect as necessary, free of charge. Owner notification letters were mailed on March 2, 2023. Owners may contact Micro Bird customer service at 1-819-477-2012. Micro Bird's number for this recall is 22-096-VUS.
Corp. Micro Bird, Inc. (Micro Bird) is recalling certain 2021-2022 G5, MBII, and T-Series school buses. The inside panels under the windows may have been insufficiently attached. As such, these vehicles fail to comply with the requirements of the Federal Motor Vehicle Safety Standard number 221, "School Bus Body Joint Strength."
Consequence & remedy
Consequence: Insufficiently attached panels may separate during a crash, increasing the risk of an injury.
Remedy: Dealers will provide parts and instructions on how to correct the defect, free of charge. The manufacturer has not yet provided a schedule for recall notification. Owners may contact Micro Bird's customer service at 1-819-477-2012. Micro Bird's number for this recall is 22-094-PUS.
Corp. Micro Bird, Inc. (Micro Bird) is recalling certain 2003-2022 MBII, T-Series, and G5 school buses. The emergency release handle on the service door may bind, not allowing the door panels to open.
Consequence & remedy
Consequence: The service door may not open, preventing evacuation of the vehicle in case of emergency, and increasing the risk of injury.
Remedy: Dealers will provide instructions on how to correctly adjust the service door, free of charge. Owner notification letters were mailed on September 8, 2021. Owners may contact Micro Bird customer service at 1-819-477-2012. Micro Bird's number for this recall is 21-087-DUS.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
1
PE23016 · 6L90 Transmission Failure
Opened Sep 27, 2023 · Closed Jan 10, 2025
Status: closed (inferred from source dates) · Power Train; Power Train:automatic Transmission; Power Train:automatic Transmission:fluid/lubricant:valves/valve Body
The Office of Defects Investigation (ODI) opened this Preliminary Evaluation (PE) after receiving one Vehicle Owner Questionnaire (VOQ) complaint related to four school buses built on General Motors (GM) van chassis. The VOQ alleged transmission failure resulting in a loss of all forward gear. In ODI's pre-investigative discussions with GM, ODI learned that valve body separator plates had been machined out of tolerance during production periods between October 2016 to April 2017 and February 2021 to April 2021. This out of tolerance machining may create excessive wear to the valve body check balls, possibly resulting in an inability to engage drive or reverse. The potential loss of drivability only begins when shifting from a park or neutral transmission selection and does not occur during a functional drive cycle. The average failure mileage of vehicles which experienced this condition is within warranty and related claims or complaints did not include any accidents, injuries, or fatalities. After discussions with GM, Technical Service Bulletin (TSB) 23-NA-142 (NHTSA ID number 10243753) was released in September 2023. This technical service bulletin provides a procedure for technicians to replace the forward check ball and separator plate if found to be the cause of a customer's concern. During the course of the investigation, GM also released a Customer Satisfaction Program (CSP) N232428780 (NHTSA ID 10253316) in February 2024, to notify school bus and ambulance fleets of the concern and to proactively mitigate the risk in these essential-operation vehicles. Recently, ODI contacted multiple school bus fleets, verifying that there have not been any stranded buses mid-route from this condition. Additionally, ODI has not received any additional VOQ complaints since the opening of this investigation. Based on the available information, including GM's TSB and CSP, this PE is closed. The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exist. The Agency reserves the right to take additional action if warranted by future circumstances. To review the ODI report cited in the Closing Resume ODI Report Identification Numbers document, go to NHTSA.gov.
Additional source detail variants (3)
Power Train:automatic Transmission
The Office of Defects Investigation (ODI) opened this Preliminary Evaluation (PE) after receiving one Vehicle Owner Questionnaire (VOQ) complaint related to four school buses built on General Motors (GM) van chassis. The VOQ alleged transmission failure resulting in a loss of all forward gear. In ODI's pre-investigative discussions with GM, ODI learned that valve body separator plates had been machined out of tolerance during production periods between October 2016 to April 2017 and February 2021 to April 2021. This out of tolerance machining may create excessive wear to the valve body check balls, possibly resulting in an inability to engage drive or reverse. The potential loss of drivability only begins when shifting from a park or neutral transmission selection and does not occur during a functional drive cycle. The average failure mileage of vehicles which experienced this condition is within warranty and related claims or complaints did not include any accidents, injuries, or fatalities. After discussions with GM, Technical Service Bulletin (TSB) 23-NA-142 (NHTSA ID number 10243753) was released in September 2023. This technical service bulletin provides a procedure for technicians to replace the forward check ball and separator plate if found to be the cause of a customer's concern. During the course of the investigation, GM also released a Customer Satisfaction Program (CSP) N232428780 (NHTSA ID 10253316) in February 2024, to notify school bus and ambulance fleets of the concern and to proactively mitigate the risk in these essential-operation vehicles. Recently, ODI contacted multiple school bus fleets, verifying that there have not been any stranded buses mid-route from this condition. Additionally, ODI has not received any additional VOQ complaints since the opening of this investigation. Based on the available information, including GM's TSB and CSP, this PE is closed. The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exist. The Agency reserves the right to take additional action if warranted by future circumstances. To review the ODI report cited in the Closing Resume ODI Report Identification Numbers document, go to NHTSA.gov.
Power Train:automatic Transmission:fluid/lubricant:valves/valve Body
The Office of Defects Investigation (ODI) opened this Preliminary Evaluation (PE) after receiving one Vehicle Owner Questionnaire (VOQ) complaint related to four school buses built on General Motors (GM) van chassis. The VOQ alleged transmission failure resulting in a loss of all forward gear. In ODI's pre-investigative discussions with GM, ODI learned that valve body separator plates had been machined out of tolerance during production periods between October 2016 to April 2017 and February 2021 to April 2021. This out of tolerance machining may create excessive wear to the valve body check balls, possibly resulting in an inability to engage drive or reverse. The potential loss of drivability only begins when shifting from a park or neutral transmission selection and does not occur during a functional drive cycle. The average failure mileage of vehicles which experienced this condition is within warranty and related claims or complaints did not include any accidents, injuries, or fatalities. After discussions with GM, Technical Service Bulletin (TSB) 23-NA-142 (NHTSA ID number 10243753) was released in September 2023. This technical service bulletin provides a procedure for technicians to replace the forward check ball and separator plate if found to be the cause of a customer's concern. During the course of the investigation, GM also released a Customer Satisfaction Program (CSP) N232428780 (NHTSA ID 10253316) in February 2024, to notify school bus and ambulance fleets of the concern and to proactively mitigate the risk in these essential-operation vehicles. Recently, ODI contacted multiple school bus fleets, verifying that there have not been any stranded buses mid-route from this condition. Additionally, ODI has not received any additional VOQ complaints since the opening of this investigation. Based on the available information, including GM's TSB and CSP, this PE is closed. The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exist. The Agency reserves the right to take additional action if warranted by future circumstances. To review the ODI report cited in the Closing Resume ODI Report Identification Numbers document, go to NHTSA.gov.
Power Train
The Office of Defects Investigation (ODI) opened this Preliminary Evaluation (PE) after receiving one Vehicle Owner Questionnaire (VOQ) complaint related to four school buses built on General Motors (GM) van chassis. The VOQ alleged transmission failure resulting in a loss of all forward gear. In ODI's pre-investigative discussions with GM, ODI learned that valve body separator plates had been machined out of tolerance during production periods between October 2016 to April 2017 and February 2021 to April 2021. This out of tolerance machining may create excessive wear to the valve body check balls, possibly resulting in an inability to engage drive or reverse. The potential loss of drivability only begins when shifting from a park or neutral transmission selection and does not occur during a functional drive cycle. The average failure mileage of vehicles which experienced this condition is within warranty and related claims or complaints did not include any accidents, injuries, or fatalities. After discussions with GM, Technical Service Bulletin (TSB) 23-NA-142 (NHTSA ID number 10243753) was released in September 2023. This technical service bulletin provides a procedure for technicians to replace the forward check ball and separator plate if found to be the cause of a customer's concern. During the course of the investigation, GM also released a Customer Satisfaction Program (CSP) N232428780 (NHTSA ID 10253316) in February 2024, to notify school bus and ambulance fleets of the concern and to proactively mitigate the risk in these essential-operation vehicles. Recently, ODI contacted multiple school bus fleets, verifying that there have not been any stranded buses mid-route from this condition. Additionally, ODI has not received any additional VOQ complaints since the opening of this investigation. Based on the available information, including GM's TSB and CSP, this PE is closed. The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exist. The Agency reserves the right to take additional action if warranted by future circumstances. To review the ODI report cited in the Closing Resume ODI Report Identification Numbers document, go to NHTSA.gov.
2022 Micro Bird Mb Ii School Bus Problems, Complaints & Recalls | Skip That Year
Illustration